Question about 1988 Toyota MR2

1 Answer

How do I check the radiator flued? - 1988 Toyota MR2

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 21 Answers

The radiator cap is in the engine compartment, not at the radiator. The mr2 has a very strange radiator set up, because of the rear engine. when the engine is cold, open the radiator cap. If you see fluid, you're probably ok. However, I would recommend if you are worried about it, to bleed the system of air. The procedure is in the owner's manual, but there are 3 air bleeding valves. You need some hose (usually found in the front trunk behind the shroud and spare tire, clear plastic flexible tubing. One valve is on the drivers side radiator top, one is by the heater, and one is on the engine/transmission (the one with the hose already going to your overflow tank). with the car off, you can open these valves to let air out of the system if it gets trapped in those high points.

Let me know if you have trouble.

Posted on Oct 09, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

85 nissan 300zx no reverse


if its automatic transmission check the transmision flued,level,seals might be corroded,and flued leaked out, causes lack of presure in the transmision hydrolick system,or the clutch plates inside the transmission are slipping cuase of hardening

Dec 22, 2012 | 1985 Nissan 300ZX

1 Answer

I have a 2003 Lincoln town car 59,000 miles. My power steering is acting as if there isn't any power,and then sometime it come back as power steering. As you are driving the car. It seam as I turn a...


hi is there any power stiring flued leak under the vehicle or is the flued full ? and is any of the hoses have a pinch an check the belt to ? none of this it my be your pump you can get it replaced

Apr 30, 2011 | Ford Lincoln Continental Cars & Trucks

1 Answer

How would trans flued get in the raidater ?


on the rad either at the bottom or on the side is a transmission cooler built into the radiator, its leaking

Nov 06, 2010 | 1992 Volvo 740

1 Answer

Transmission


When you change fluid and filter, if it doesn't seem to be be taking enough fluid, you need to check the return cooling line. Loosen the return line ( the back one ) and have someone start the vehicle and put it in gear. If the check valve by the radiator is not plug you will have fluid pumping out. THIS ONLY TAKES A SECOND OR TWO, so don't let it run too long. If no fluid comes out, then the check valve is pluged and you need to replace your cooling line from the radiator to the transmission. This a common problem that cause the transmission to strave for fluid and burns what is in it. Remember to always check fluid level in Neutral and use Plus4 transmission fluid. Good luck.

Mar 31, 2010 | 2005 Dodge Ram 2500 Truck

1 Answer

Have a 1992 plymoth voyger.It keeps losing tranmiss flued.have changed gasget and filter it still likes bad tranney work right when you put 2qt in but that is gone in about 5 miles what should i try now


check the lines going from tranny to radiator, make sure hose clamps are tight, or it could be your main seal, which you would have to take the tranny out for

Dec 04, 2009 | 1992 Plymouth Voyager

1 Answer

The heater does not work on our 2000 Nissan Maxima. The fan blows air..but no heat. What could this be and what could it cost for repair?


make sure cooling flued is filled to the maximum . Is this no cure .maybe your heater crane is stuck and warm water is not comming through. find the crane at the heater radiator or just in front of where the heaterhoses go to the interior. it is possible that Nissan installs a electronic heater crane. then the only way to fix it is to fit a new one. hope to be at any help to you

Aug 01, 2009 | 2000 Nissan Maxima

2 Answers

1989 mazda astina 323 5 spd manual clutch fluid??


open your bonnet check to see @ gearbox if the-res is cable, or a cylinder, the cable is Usualy visible on the top of the gearbox if theres a cable theres no clutch flu-ed needed. Note that your gearbox uses oil. Usualy on older models like 1989 the use a clutch cable no flu-ed needed

Jan 03, 2009 | 1989 Mazda 323

1 Answer

CHANGE A6 RADIATOR


Not realy you might loose your air con gas and some powersteering flued. let me know if you want some advice on how to do it!

Oct 17, 2008 | 2001 Audi A6

1 Answer

Heat needle is going to hot ten minutes into driving


check the bottom hose u may be leakening radiator flued and also check around the water pump if u see water then u need to change the water pump and if you see a leake at the bottom then change the hose.

Jul 09, 2008 | 2001 Kia Sephia

Not finding what you are looking for?
1988 Toyota MR2 Logo

152 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...