Question about 2007 Chevrolet Silverado 2500HD

Open Question

How do I adjust the parking brake on my 2007 Chevy 2500HD?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 66 Answers

SOURCE: 2003 chevy 2500hd no brake lights

your truck has fuses for the rear and high mount brake light in the fuse box in the side of the dash when you open the drivers door

Posted on Jan 26, 2009

ourhowse
  • 2007 Answers

SOURCE: How to adjust the parking brake in a 2007 Camry

I think, now, i'm not positive, there is a cable adjustment at the bottom of your parking brake handle.

Posted on Jun 04, 2009

  • 30 Answers

SOURCE: How to adjust the parking

there is an adjusting screw atached to the hand brake cable located near the hand brake it self but before i do that i would check and replace the rear padds first and replace if needed! that could be the reason why your hand brake needs adjustment???

Posted on Dec 15, 2008

  • 1596 Answers

SOURCE: Park Brake Adjustment


Park Brake Adjustment (Disc Brake)

Tools Required

j 21177-A Drum-to-Brake Shoe Clearance Gage

Park Brake Shoe Adjustment

Caution: Refer to Brake Dust Caution.

Important: The park brake shoes must be adjusted before the park brake cable tension is adjusted.Set the J 21177-A so it contacts the inside diameter of the rotor

  1. Position the J 21177-A over the shoe and the lining at the widest point.
  2. Turn the adjuster nut until the lining just contacts the J 21177-A. Park brake shoe to brake rotor clearance: 0.6604 mm (0.026 in)
  3. Repeat steps 1-3 for the opposite side.
Park Brake Cable Tension Adjustment

Important: Before you adjust the park brake cable tension, verify that the park brake shoes are adjusted to provide a clearance of 0.6604 mm (0.026 in) and the rear disc brake rotors are installed.

  1. Verify the self adjuster lock-out pin has been removed.
  2. Fully apply and release the park brake pedal 3 times.

Posted on Feb 22, 2009

  • 14036 Answers

SOURCE: 2001 chevy sylverado 2500hd power steering and power brakes quit

check power steering fluid. first. if all good . power steering is going. your hydro boost brake system depends on the power steering pump if it goes out your brake go out.

Posted on Mar 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Brake lights stuck on 2007 chevrolet silverado 2500hd


place something between switch and pedal arm to see if light goes out.
you might have to adjust the switch till lights go out.
some are threaded in others have double nuts.

Jan 30, 2013 | 2007 Chevrolet Silverado 2500HD

1 Answer

How can I adjust the parking brake on my 2002 GMC Sierra HD


Umm... I could be wrong but... the 2002 GMC 2500 has rear *disc brakes with an interior set of *drum brakes for the E brakes. check with your dealer because there was a recall on the E brake for some early 2000 GMC trucks. also there is a manuel adjuster for the parking brakes.

Jan 26, 2013 | 2002 GMC Sierra 2500HD

2 Answers

How do i adjust the parking brake on a 2003 silverado 2500HD?


Under the truck about 3/4 of the way back on the drivers side is where you can adjust it. lube it up, it will be rusted

Feb 14, 2011 | 2003 Chevrolet Silverado 2500HD

1 Answer

How do you remove rear brake drum on a 1992 chevy 2500HD


make sure parking brake is off and tap medium to hard around brake drum to free it up then tap it off with a hammer they can be tough good luck

Dec 09, 2010 | 1992 Chevrolet C/K 2500

1 Answer

Noise coming from under 05 Chevy 2500 HD


the parking brake rusts and makes a rubbing sound. it is inside of the rear disks. you have to remove the caliper then the caliper bracket. pull the disk off and inspect the parking brake. very common problemas most automatic trucks no one ever uses the parking brake

Dec 31, 2009 | 2003 GMC Sierra 2500HD

1 Answer

Some kind of lubicant coming out of center hub on back wheel. This is a 2002 Chevy Silverado truck with 77,000 miles.


that would be your axle seals, have them replaced, that fluid is gear oil, also if the oil has gotten on any of the brake parts they must also be replaced, this includes parking brake system because if fluid got on the parking brake it will also be less effective.

Jul 19, 2009 | 2002 Chevrolet Silverado 2500HD

1 Answer

Park Brake Adjustment



Park Brake Adjustment (Disc Brake)

Tools Required

j 21177-A Drum-to-Brake Shoe Clearance Gage

Park Brake Shoe Adjustment

Caution: Refer to Brake Dust Caution.

Important: The park brake shoes must be adjusted before the park brake cable tension is adjusted.Set the J 21177-A so it contacts the inside diameter of the rotor
  1. Position the J 21177-A over the shoe and the lining at the widest point.
  2. Turn the adjuster nut until the lining just contacts the J 21177-A. Park brake shoe to brake rotor clearance: 0.6604 mm (0.026 in)
  3. Repeat steps 1-3 for the opposite side.
Park Brake Cable Tension Adjustment

Important: Before you adjust the park brake cable tension, verify that the park brake shoes are adjusted to provide a clearance of 0.6604 mm (0.026 in) and the rear disc brake rotors are installed.

  1. Verify the self adjuster lock-out pin has been removed.
  2. Fully apply and release the park brake pedal 3 times.

Feb 22, 2009 | 2007 GMC Sierra C/K2500

1 Answer

Emergency Brake Adjustment


Ahh they are a real pain in the **** you need to remove the rear wheels calipers caliper anchors then the rotors and then you can adujust the park brake shoes up just untill you feel a bit of drag on the rotor then back them off a bit. Other wise you need to buy the tools to check the adjustment bottom line they are a pain

Jan 18, 2009 | 2002 GMC Sierra 2500HD

Not finding what you are looking for?
2007 Chevrolet Silverado 2500HD Logo

Related Topics:

626 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8211 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...