Question about 2007 Toyota Camry

Open Question

Sun visor won't stay up - 2007 Toyota Camry

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: Driver's side sun visor won't

You need to replace it. Don't do it with another 2002 sun visor. I did and guess what, it did it again. I also had it replaced once by the dealer when under warrenty. Its a bad design.

In the end I replaced it with a sun visor from a 2004 (I think) model. I got lucky and found someone selling new sets on e-bay. It is a new design so you should replace both so they look right but they fit. As an extra bonus it also had a memo recorder along with the home link and the new visor slides out to give you better coverage than the '02 model. Best of all, the defect that causes the visor to slowly tilt down has been corrected. After 2 years, it's still working.

Posted on Aug 22, 2009

SOURCE: Sun visor on driver's side

I had the same problem in my 06 Sonata. The mechinism in the fisor that creates tension to hold it in place broke. It seems there is a certain position that if you try to rotate up or down, it cracks and goes limp. $115 for new one.

Posted on Aug 08, 2008

  • 1 Answer

SOURCE: Sun visor on driver's side

I had the same problem with my 2007 Sonata. I took it into the dealership and they were aware of the problem and fixed it.

Posted on Feb 14, 2009

  • 1 Answer

SOURCE: Sun visor on 2005 Nissan Murano won't stay up/falls down

I resolved this same problem on my 2004 Murano after also being told that it ($350 Visor) was not covered under my extended warranty. This problem is primarily caused by the heavier than normal visor. It cost me a total of $2.69 and about 30 minutes to fix.
To resolve this problem follow the following steps:

1) Go to the hardware store and purchase the Velcro package that contains (2) 18”, 1/2 inch strips (I chose the beige color since I have a tan interior) 2) Using a small screw driver, carefully pry off and remove the small cover that hides the mounting screws for the Driver’s visor. 3) Remove the 2 Phillips screws and drop the visor down slightly so that you can unplug the wires that go to the visor light and now remove the visor 4) Using the plastic velcro strip ONLY , (NOT the fuzzy strip), trim the end of the strip so that it will fit under the visor mount and also punch a small hole in that end of the strip so that one of the screws will go through it. (There is NO NEED to remove the adhesive backing from the Velcro strip)
5) Carefully mount the visor so that one of the mounting screws also goes through the Velcro strip 6) Be sure that the sticky side of the Velcro strip faces down or towards the visor
7) Once the visor is loosely mounted, pull the Velcro strip slightly and then tighten the 2 mounting screws securely. 8) Once mounted, hold the Velcro strip against the headliner and then raise the visor against the strip and the headliner and it SHOULD stick in place since it can’t drop down because one end of the Velcro strip is secured to the visor mount 9) Trim the exposed end of the velcro strip so that only 1 inch is exposed (or less) in case you need to lower the visor at a later time. (I removed a half inch of the backing and folded the exposed end on itself so that it's easy to grasp.) In this way you don’t have to glue anything to the headliner OR the visor.

(If your visor is a vinyl material, you will have to stick/glue the fuzzy velcro strip to the top side and/or edge of the visor so that there will be something for the plastic strip to stick to)

I hope this helps others…. It works for me! (and it sure beats $350!!)


Scott99

Posted on Jan 30, 2009

  • 1 Answer

SOURCE: driver side sun visor will not stay in up position

I have fixed this at the mexican way, but really cheap and effective, I had same issue with my rav4 2006, and the velcro magic fix it, let me tell you that u need to obtain the one from lowe's/home depot original "velcro" strip 4"x 2" industrial strenght. stick both part separately and let them cure for 24hrs, without being together, 24hrs later, close the visor, as you normally do, that is the only way it will have the contact force enuff to keep visor up. I tried before with cheaper velcro alternatives, and did not work, hope this helps

Posted on Mar 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2011 toyota camry le sun visor won't stay up. Is there a recall?


You have broke it end of story but a good soloution with this is one of them victorian long hat pins

May 18, 2013 | Cars & Trucks

1 Answer

Car sun visor broken


First, is it out of warranty? If so, check to see if it is seated correctly in the recess by the mirror. Then make sure it is seated on the rod that it pivots on. If those obvious things are ok then remove the mounting end of visor where it is attached to the headliner cose to the door and make certain that it all looks good where it attachs to the rod that it pivots on. If no luck there take it off and go to to toyota and play the role of the what? no recall? Then start looking at ebay for a replacement.

May 12, 2013 | Cars & Trucks

1 Answer

Sun visor


Contact your local dealer. They will be able to get you a new visor. The part that holds it in the up postion is worn out and the only way to fix it is to replace the entire visor.

Apr 30, 2013 | Cars & Trucks

1 Answer

Sun visor won't stay in the up position


SUN VISOR COULD BE BROKEN HAS TO BE REPLACED.

Nov 01, 2011 | 2002 Ferrari 575M

1 Answer

Driver's side sun visor won't stay up


There is no fix for this other than to replace the sunvisor. sorry.

Aug 16, 2011 | 2008 Toyota Camry

1 Answer

07 Camry SE Sun Visor Broken


I had the same thing happen to my Sequoia. They replaced it under warranty when I complained.

Sep 24, 2009 | 2007 Toyota Camry

1 Answer

My, sun visors wont stay in up position


the screws that hold them in place are loose

Jul 23, 2009 | 2004 Toyota Highlander

1 Answer

Sun visors won't stay flipped up.


most of the times on the visors if you look at were it mounts on the car you will see a small screw this is a set screw and if you tighten it just a little bit it should hold your visor up for you. but not all vehicles have a set screw as iam talking about. and if the impala dosent you need to get a compleat new visor
hope this helps you out

Apr 30, 2009 | 2006 Chevrolet Impala

1 Answer

Sun Visors won't stay forward towards windshield


inside the sun visor there is a spring which is moving to side when you push down the spring pushes side so it will keep down when you want to push to the normal possition spring releces and keep to that possition any way i would like to advice you to replace sun visor.

Nov 28, 2008 | 2003 Toyota Highlander

Not finding what you are looking for?
2007 Toyota Camry Logo

Related Topics:

843 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...