Question about 2002 Pontiac Grand Prix

Open Question

How do i replace the ignition on 2002 pontiac grand prix

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

PyroPCMan
  • 405 Answers

SOURCE: diagram on a pontiac grand prix

Ignition Switch GM Century/Lumina/Grand Prix/Intrigue 1997-2000 The vehicles covered by this guide use one of two types of ignition switches:

  • A mechanical key and lock cylinder built into the steering column, that works a pull rod to actuate the separate electrical portion of the ignition switch mounted further down the steering column. For more information and replacement procedures on this type of switch, please see .
  • An instrument panel-mounted ignition switch is also used on some W-Body vehicles. To service this switch, the radio, heater & A/C control panel and the instrument cluster must be removed. All of these procedures are found elsewhere in this section.
REMOVAL & INSTALLATION
Instrument Panel-Mounted Ignition Switch
WARNING You must perform the Body Control Module (BCM) theft deterrent relearn procedure after replacement of the ignition lock cylinder. Failure to perform this relearn procedure means the BCM will not function properly. This means the vehicle will not be theft protected by the Passlock system and the engine may not crank or start. GM recommends that this procedure be performed with their Tech 2® or equivalent scan tool. An alternate relearn procedure is given at the end of this procedure.
  1. Disconnect the negative battery cable.
  2. Remove the radio assembly following the procedures found in this section.
  3. Remove the heater & A/C control head assembly following the procedures found in this section.
  4. Remove the instrument cluster assembly following the procedures found in this section.
  5. Detach the electrical connectors from the ignition switch.
  6. Insert the key and turn the ignition switch lock cylinder to the ACC position.
  7. Depress the transaxle park/lock cable retainer to release, then pull to remove the cable from the ignition switch.
NOTE You must perform the Body Control Module theft deterrent relearn procedure after replacement of the ignition lock cylinder.
  1. If it is necessary to remove the ignition lock cylinder from the ignition switch (theft damage, etc.), use the following procedure:
    1. Insert the key and turn the ignition switch lock cylinder to the ON position.
    2. Using a small flat-bladed tool, depress and hold the lock cylinder retaining tab.
    3. Using the key as an aid, pull to remove the ignition switch lock cylinder from the switch.
    4. Remove the key from the lock cylinder.
    5. Carefully pull to release the ignition switch bezel from the ignition switch lock cylinder.
  2. Remove the ignition switch bracket bolts and remove the ignition switch through the instrument panel cluster opening.
  3. Remove the bolts retaining the ignition switch to the bracket and remove the bracket.
0900c15280090fea.jpgRemoving an instrument panel-mounted ignition switch assembly—1998 Oldsmobile Intrigue shown, others similar To install:
  1. Install the ignition switch to its bracket and install the bolts. Install the ignition switch into position through the instrument panel cluster opening and install the bracket retaining bolts.
  2. If removed, install the ignition switch lock cylinder to the ignition switch using the following procedure:
    1. Recode the lock cylinder, if necessary.
    2. Align the ignition switch bezel to the tabs on the ignition switch lock cylinder and carefully press to secure in place.
    3. Insert the key and turn the ignition switch lock cylinder to the ON position.
    4. Align the ignition switch lock cylinder to the ignition switch, then press into place.
  3. Turn the key to the ACC position. Align and press into place the transaxle park/lock cable to the ignition switch. Remove the key from the switch.
  4. Attach the electrical connectors to the ignition switch.
  5. Install the instrument cluster using the procedures found in this section.
  6. Install the heater & A/C control panel using the procedures found in this section.
  7. Install the radio assembly using the procedures found in this section.
  8. Connect the negative battery cable.
  9. If the lock cylinder was removed, perform the BCM Programming/RPO Configuration procedure.
THEFT DETERENT RE-LEARN—WITHOUT TECH 1®SCAN TOOL
This procedure takes approximately 30 minutes. Make sure the battery is fully charged before proceeding.
  1. Turn the ignition switch to the OFF position.
  2. Turn the ignition switch all the way from the OFF to the START position, then leave it in the ON position. The engine will not crank.
  3. The SECURITY light should come on and stay on for at lease ten minutes.
  4. Turn the ignition switch to the OFF position for five seconds.
  5. Repeat Steps 2, 3 and 4 again for a second time.
  6. Repeat Steps 2, 3 and 4 again for a third time.
  7. Turn the ignition switch to the OFF position.
  8. Turn the ignition switch all the way to the START position. The engine should now start.

Posted on Sep 09, 2008

davidg65
  • 26 Answers

SOURCE: 2002 Pontiac Grand Prix Thermostat

as you face the engine the thermostat bell is on the right (drivers side) Follow the radiatoe hose. Remove the two bolts and raise the bell still attatched to the hose. the thermostat is there with the rubber seal. You can gently pry the thermostat out with a screwdriver or something similar. Put in new thermostat be sure it is the same as the old one, and then replace or change the seal (be sure it is the smae size and thickness as the old one as I got the wrong size from Napa) Then replace the bell, and tighten, but not over tighten. I hope this helps!

Posted on Jan 31, 2009

csmock132
  • 4669 Answers

SOURCE: how to replace ignition cylinder on a pontiac

Does it turn? Or is it **** in the lock position.

Posted on Mar 19, 2009

  • 58 Answers

SOURCE: 2002 Pontiac Grand Prix GTP / Multi-function Switch

i have the sameproblem. Dealer part was quoted to me at $510.00. All after market parts stores were $350- 450. Try moving the emerg. flasher button while you step on the brakes and someone else watches the lights. I jammed paper beside the button and they work until I can fix it.I had to order the multi-function switch. and you have to pull the air bags to replace it.

Posted on Jul 15, 2009

  • 451 Answers

SOURCE: How do replace heater core in 2002 Pontiac Gran Prix

i do believe you have to take the passengers side dash apart behind the glove compartment. go to autozone and get a manual or go to the library and check the chiltons manual. this is not an easy job. how bad is the leak? if its not bad these heater cores are made of all aluminum. i would buy a bottle of that radiator additive and see if that takes care of the problem first. it only cost about 5 bucks a bottle and it may permanantly fix your problem.

Posted on Aug 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 grand prix, temperature won go from ac to heat, stuck on ac.


Pontiac Grand Prix Climate Control/AC - Car Forums at Edmunds.com

forums.edmunds.com > Pontiac > Pontiac Grand Prix
Dec 29, 2007 - 30 posts - ‎20 authors Hi Joe, I had the same problem with no heat on my 2000 grand prix. .... motor and the exterior temperature sensor have both been replaced ... Pontiac Grand Prix Electrical/Lighting
30 posts
Aug 3, 2009
Pontiac Grand Prix Heater blower relay switch
30 posts
May 13, 2009
Pontiac Grand Prix Starting / Stalling Issues
30 posts
Feb 9, 2008
More results from forums.edmunds.com

Fixing AC Temperature Control on my 2002 Pontiac Grand ...

? 9:58
www.youtube.com/watch?v=2BOdhWMdxXc

Jul 13, 2014 - Uploaded by Turbo231
Fixing AC Temperature Control on my 2002 Pontiac Grand Prix... How To Install Replace AC Heater ...

Oct 15, 2015 | 2000 Pontiac Grand Prix SE

1 Answer

Hi, I'm having a major problem with my 2002 Pontiac Grand Prix. The fog, dashboard, and tail lights are not coming on. Along with my car is making the sound as if the key is in the ignition when ther


First replace the light switch. It controls all the lights you said don't work. The key chime is a small white switch on top of the ignition You have to remove the steering column bezel to get to it. They stick.

Jan 25, 2015 | 2002 Pontiac Grand Prix

1 Answer

2002 Grand Prix: I just had my oil changed in my Pontiac 2008 Grand...


To reset "CHANGE OIL" light, turn the ignition switch to the run position without starting the engine. Fully depress and release the accelerator pedal 3 times within 5 seconds. and wait for the light to flash. Check your manual it maybe slightly different. Real easy fix.

May 16, 2010 | 2002 Pontiac Grand Prix

1 Answer

2002 pontiac grand prix,no running lights,noblower motor,no back window defogger


I've been thru this mess... Replace the ignition switch (not the key portion) located inside the steering column. Don't waste your money replacing the blower motor and/or blower resistor. This is a common issue on this make/model Pontic.

Mar 21, 2010 | 2002 Pontiac Grand Prix

1 Answer

I have a 2002 grand prix the key will not remove from the ignition, how should i fix it.


try woggling the steering wheel and turn the key at the same time. id it will not come out the ignition cylinder will need a replacement

Feb 28, 2010 | 2002 Pontiac Grand Prix

Not finding what you are looking for?
2002 Pontiac Grand Prix Logo

Related Topics:

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...