Question about 1998 Chevrolet S-10 Pickup

2 Answers

Need plug wire configuration coming off the coils for 1998 chevy s-10 2.2 litre engine

Posted by on

  • electricpet Sep 01, 2010

    thanks... can you give me which cylinder sets up to which pin on which coil?


2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,796 Answers


Firing order is 1-3-4-2 the distributor rotates counterclockwise..
Spark plug #1 is in front of the engine. there should be a mark on the distributor cap for spark plug cable #1..

Good luck!! Don't forget to rate this post!!

Posted on Sep 01, 2010

  • Rene J Solis Sep 02, 2010

    If you have distributorless ignition, you should have 2 coils w/2 connectors each, each connector has a number, the firing order is 1-3-4-2, one coil has the numbers 1&3 and the other 2&4, you match that # with the spark plugs and you'll be set.

    The first spark plug is on the front of the engine.

    Let me know if you need more assistance.


  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,297 Answers

Tough to read but...
top coil is 2-3
bottom is 1-4
need plug wire configuration coming - ee88ae2.gif

Posted on Sep 02, 2010

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I HAVE A 2000 CHEVY S10 4.3 ENGINE coil sparks but no spark from distributor. can the cam sensor cause this problem?

If you take coil wire loose from distributor cap and hold close to engine ground, engine cranking, does a spark jump? If it does, make sure rotor turns when you crank it. The pink wire at the coil goes hot with key on, that is primary voltage, use a test light, is it hot? That voltage comes from ecm fuse1--15 amp, check voltage with key on.
If sensor issue, my first thought would be the crank sensor. Just my opinion.
s10 ignition coil-o5ackhig0xzyenisedck4g1t-3-0.jpg

Feb 27, 2017 | 2000 Chevrolet S-10

1 Answer

Spark plug wiring diagram for 05 tahoe

Greg Bernett 2821 Solutions February 14, 2010
You didn't post your engine size so please pick the applicable diagram:

1996-98 4.3L Engines Firing Order: 1-6-5-4-3-2Distributor Rotation: Clockwise

1996-98 5.0L, 5.7L and 7.4L Engines Firing Order: 1-8-4-3-6-5-7-2Distributor Rotation: Clockwise

4.3L Engines Firing order: 1-6-5-4-3-2 Distributor rotation: Clockwise

4.8L, 5.3L and 6.0L Engines Firing order: 1-8-7-2-6-5-4-3 Distributorless ignition system (one coil on each cylinder)

5.0L, 5.7L and 7.4L Engines Firing order: 1-8-4-3-6-5-7-2 Distributor rotation: Clockwise

Source: spark plug wiring diagram for 98 tahoe

  • avatar15.jpg
    ledsled378 2926 Solutions July 24, 2010

01f93b7.jpg ..............................

Source: Need diagram for spark plug wiring for 1997 Chevy

Testimonial: "Thank you for your prompt response. Saved my husband from some distress!"
Was this solution helpful? Yes No

  • avatar1.jpg
    Dennis Weid. 44272 Solutions September 16, 2008

This was all I could come with, hope it helps.


Feb 27, 2013 | 1998 Chevrolet Tahoe

1 Answer

Need torque spec for a 1998 3.1 litre chevy v6

Hi there:
Are you refer at engine torque specf? Please confirm us.

Aug 10, 2012 | 1998 Chevrolet Malibu

1 Answer

I need to know where the spark plugs and distributer cap is located on my 1998 Lexus es300

Hello,the Lexus 3.0 litre engine has no distributor or cap.There is an individual ignition coil on top of each spark plug,all of which are located on top of the engine.There may be a removeable trim cover over the engine making these harder to see untill you remove it for access.

Sep 04, 2011 | 1998 Lexus ES 300

1 Answer

Po354 dtc occurs immediately even after clearing codes with scanner the scanner says coil pack "d" pri/sec circuit fault my question is i just cleared a ton of water out of spark plug hole # 4 this is a...

it sounds like you need to replace that coil and yes the coils are on top of the plugs also make sure you replace the boot and plug wire on that one

Aug 24, 2010 | 1998 Ford Expedition

1 Answer

I have 1998 Polo 1.6 litre auto. The engine stops, while waiting for traffic lights. Any body can help?

ditributor cap plugs wires or coil pac tune up and get a scan at the parts store for your check engine light

Feb 28, 2010 | 1998 Volkswagen Passat

1 Answer

Engine will not restart after use, will start after 10-25 minutes

Do not take the fuel cap of when trying to start the vehicle this will trigger a trouble code. The no start problem, sounds like the ignition module. Thats the thing that your coils are plugged into. The coils are the things that your plug wires are plugged into up by the fire wall. The ignition module looks like a silver plate about 6-8" long underneath the coil packs, (3 individual coils serving two cylinders each). Anyway have that checked out. Tip;- If you unplug the coils and put dielectric grease at each of the terminals, that might help, it's a first step to fixYa.

Aug 31, 2009 | 1998 Chevrolet Malibu

1 Answer

98 s-10 2.2 Fuel Pump Pressure

40 psi good lower than that bad

Apr 21, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

I do not have any fire from the coil and engine code P0336 shows.

Did you put in a used engine, do you have the crank sensor off the other engine? If not, without looking at it I would suggest replacing the Crank Sensor.

Mar 12, 2009 | 1998 Chevrolet S-10 Pickup

Not finding what you are looking for?
1998 Chevrolet S-10 Pickup Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides