Question about 2008 Toyota RAV4

1 Answer

Engine light comes on when car is running replaced

Engine light comes on when car is running replaced battery checked all fuses did oil change could this be a sensor? some where.

Posted by on

  • craps136 Sep 01, 2010

    what do you mean a scanner ?
    what about diagnostics tester.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Toyota Master
  • 2,050 Answers

Could be anything...
Start by getting a scanner hooked up to see what the trouble code is, and then go from there. (Once the trouble is fixed, the light should go out on it's own.) Also, make sure the fuel cap is tight!

Posted on Sep 01, 2010

  • craps136 Sep 01, 2010

    what is your version of a scanner

  • Douglas Hansen
    Douglas Hansen Sep 01, 2010

    A scanner, is just a tool that hooks up to youe vehicles OBDII (2) link, which is located under the dash in the drivers area, around your left knee. Some auto parts stores will do this for free.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why won't a toyota engine start


Have you checked all the main engine fuses?

Aug 14, 2014 | Cars & Trucks

1 Answer

Why Did the Vsc and check engine light come on in 2005 toyota highlander?


The converters generally fail only after the truck has been running rich. I would not replace them until certain the engine is running properly. There is no harm to the car to drive with these converters. Was there any history of rich operation codes?

Jul 08, 2017 | 2005 Toyota Highlander

2 Answers

Where is the oil sending unit on a 1990 SIlverado 5.7?


The sending unit is behind the distributor on top of the block. And if the service engine light comes on, most auto parts stores like Pep Boys will check your car for free, and if it only comes on while running but not while driving that will steer you in the right direction. But I would try this first, reset the computer. To reset the computer in your vehicle all you need to do is disconnect your battery for 5 minutes, then reconnect your battery and your computer will start fresh, if a there is a problem a sensor sends a signal back to the computer.

Mar 30, 2014 | 1999 Chevrolet Silverado 1500

1 Answer

Runs rough at idle when cold/check engine light comes on/scanner gives no code


Ok Run,s smooth when WArm ?Check thermostat change it or light comes on using to much fuel so replace the oil And Filter cause you have lot,s Of GAS in OIL so Replace it then Check to see if YA HAve Antifreeze in OIL see when ya Change it Ok See if ther is some If Not change thermostat ASAP ya can wreck the HEADS ON the VAN Over HEat them

Mar 15, 2013 | 2003 Ford Windstar

2 Answers

2002 dodge neon check engine light stays on


THe engine light is notifying you that the cpu has found sensors that are outside set parameters. Have the fault code s read and replace faulty unots.

Feb 10, 2013 | 2002 Dodge Neon

2 Answers

I changed the oil in my 98 concorde and now it wont start. The oil light is on but not the check engine light.\


do you here the fuel pump working when you turn the key?If not could be a fuse that runs the fuel pump.

Aug 05, 2012 | 1998 Chrysler Concorde

1 Answer

Oil light flickers. Just changed my radiator, truck runs cooler and also changed my battery (check engine light used to turn on before I started to disconnect the battery cable and reconnect it; and I...


Check the oil pressure with a mechanical test gauge and it will likely be ok, if so replace the oil pressure sending unit. Do not use any oil thickener in this engine it can damage the bearings.

May 23, 2012 | 1991 Mitsubishi Mighty Max

2 Answers

My change oil light never goes off even though I had it changed and now my service vehicle soon light is on even though its been running fine


The change oil light needs to be reset after each oil change...some shops are not knowledgeable on how to do this...Your owners manual will instruct you how to reset the oil change light...The service engine soon is a catch all for low fluids and other needs...Be sure to check your oil level again...to clear the service engine soon light, you can disconnect either battery cable for 15 minutes then reconnect...if the service engine stays on...then you need to have your Grand Am checked...Auto Zone does a free diagnostic of check engine light codes...:)

Dec 13, 2010 | 2001 Pontiac Grand Am SE

Not finding what you are looking for?
2008 Toyota RAV4 Logo

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...