Question about 2007 Kia Sedona LX Minivan

Open Question

Replaced a wheel sensor, how do I get TPMS light to reset?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: TPMS not working properly

Take the truck to a tire shop that carries a nitrogen machine ,and let all the air out of tires and get them to fill them with nitrogen. this should take care of that problem.

Posted on Mar 19, 2009

Molson02536
  • 3854 Answers

SOURCE: I replaced my original wheels/tires by GM black

As far as the tpms and aftermarket wheels, all you have to do is when you replace the wheels, take the sensors out of your rims and transfer them into the new ones. Make sure they put the driver front to the new driver front, or they will have to be reset, which a year ago when i did tires was pretty expensive. GM and most other vehicles that i've worked on (besides Ford) have a "Direct TPMS" which is the sensor inside the tire. It is actually attached to the valve stem on the inside. They can be swapped out easily. But if you decide to leave them out of the new rims and just put regular shrader valve stems in them, there wouldn't be anything messed up, you'd just have a tpms light on the dash lit up all the time.
Good luck and keep em posted.

Posted on Nov 05, 2009

  • 1 Answer

SOURCE: tpms light on 2006 town and country

Same thing happened to my 2006 T&C when the weather turned cold. I found that the recommended tire pressure was 36 lbs/sq. in. When I inflated all 4 tires to this pressure, the light went out after driving a few miles.

Posted on Feb 10, 2009

pingman37
  • 58 Answers

SOURCE: TPMS error light on, dash shows no readings

It has to be done at the dealer with the handheld computer. They have to access the Body Control Module and then go around to each tire with a unit that looks like a garage door opener and hold it on the tire below each valve stem. It should only take like 15 minutes to do.

Posted on May 07, 2009

  • 5 Answers

SOURCE: disable tpms

I don't know if there is a problem with your TPMS receiver (on dash board), or your TPMS sensor is disable (in four tire). If it's the receiver problem, You have to go to the dealer ship to solve the problem. If it's the sensor problem. You can go to the dealer ship to let them find which sensor or sensors are fault, And replace them by the new one then doing the reset process.

Posted on Nov 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why is tire pressure fault light blinking?


Could be low air,two pound less may light blinking.

Dec 14, 2015 | Cars & Trucks

2 Answers

One day TPMS sensor light was on on my instrument panel so I went to the repair shop so they reset it with the diagnosis machine and the sensor light was gone from the instrument panel temporarily. The...


The TMPS device in the tire attached to the wheel once introduced to the TPMS computer receiver it continuously checks air pressure and sends that info to the reciver (each whel does this) the reveiver compares the pressure data betwen the 4 wheels. If they are not the same it will put up a message to the dash TPMS icon.

So if all of your wheel sensors are sending messages and you are getting a message tire low -- they are working.
If you simply get the TMPS symbol or lettring and it is only becuase of one wheel -- replace the wheel sensor.
If all wheels are not working (each one off and on) then have technician remove the the electronic hadnshake for the car to the 4 wheels and then reintroduce the wheels to the car. If that fails then have the revieving computer check for faults and replace or replace it.
Note the wheel sensors each have a battery -- hence the batteries can go dead. Some sensors can have the battery repplaced. It is recommended that all 4 be done at the same time.

Dec 26, 2014 | 2007 Nissan Quest 3.5 Minivan

1 Answer

HOW DO YOU RESET THE TPMS ON 06 NISSAN PATHFINDER


If the wheel tpms sensors work,when you turn on the
ignition switch, the dash light should go off in one second

When you drive 16mph the system is activated & if
tire pressure in the 4 driven wheels are okey, the light
stays off

Other wise you have tire & sensor work to do

Aug 27, 2014 | 2006 Nissan Pathfinder

1 Answer

2007 Nissan Frontier TPMS


tpms sensors have small battery inside rim which last 5-7 years then tpms all need to be replaced with new ones could cost between $50-$100 per wheel as tires have to be opened to access tpms.

May 20, 2014 | 2007 Nissan Frontier SE Crew Cab

1 Answer

Reset tpms on 2009 maxima


Yes, you have to reset the TPMS in a dealer shop with a special TPMS diagnostic tool.

Aug 15, 2013 | Cars & Trucks

1 Answer

My Cadillac devil 2004 is prompting me saying"tire monitoring sensor" isn't wiring or need to be replaced. I'm a do it yourself kind of guy is this something I can fix myself ? And what's my best plan


The TPMS monitors tire pressure and sends a signal to the Cadillac's computer when there is low tire pressure. When the tire pressure is restored, the Cadillac's TPMS should reset itself. However, if it does not, the TPMS light on the dash will stay lit. When this happens, you need to know how to manually reset the TPMS light and sensors.

Instructions

1 Press and hold the tip odometer button on the gauge cluster.

2 Wait until the display screen brings up the settings menu.

3 Release the "reset" button and press it again to scroll through various settings.

4 Keep pressing the "reset" button until you come to the TPMS setting.

5 Press and hold the "reset" button until the TPMS light on the dash resets.

Oct 04, 2012 | 2004 Cadillac Deville

2 Answers

TIRE PRESSURE LIGHT STAYING ON


You either have low tire pressure in a tire
A bad tire pressure sensor in a wheel
Or just need to reset the TPMS,if you rotated your tires.

Go to a shop with a TPMS tool or scanner with TPMS software, and have it reset.

Aug 02, 2010 | 2007 Nissan Sentra 2.0 SL Sedan

1 Answer

I replaced my 08 accord wheels with an 09 accord wheels


thank your gorvernment. they required auto makers to implement some sort of tire pressure monitoring system in all vehicles. More than likely what needs to be done is a re-initialization of the sensors. it will most likely need to be performed by a dealer.

Jan 12, 2010 | 2008 Honda Accord

3 Answers

Where is the low tire reset button located on 2005 ford freestar?


It is on the same button as the Trip Odometer. Cycle through until you see Tire Reset and hold the button down.

Mar 28, 2009 | 2005 Ford Freestar

Not finding what you are looking for?
2007 Kia Sedona LX Minivan Logo

Related Topics:

998 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...