Question about 1995 Chevrolet Lumina

1 Answer

Car starts with screwdriver but stalls - 1995 Chevrolet Lumina

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 355 Answers

The problem is the security system (VATS/Passkey) installed on these GM cars. There are 3 parts involved:

  1. The chip-key
  2. The lock cylinder
  3. The TDM (aka the brain of the system)
There is a solution that I found on the internet and that bypasses the entire factory security system, all 3 pieces altogether and you can even remove the TDM at the end and use 99c keys without chip. The product I used is at http://newrockies.com and is still working perfectly after 5 years. Don't go to the dealer!

Posted on Feb 27, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 buick skylark starts then instantly stalls its not the security its not flashing been there done that. fuel pump kicks on seems to be a fuel issue? need help


with 3.0L engine the MAF sensor can be check. with screwdriver handle hit a little the MAF sensor while the engine running if it stall .then change the MAF

Sep 20, 2013 | 1985 Buick Skylark

1 Answer

Car will start and run until it reaches operating temp. Then it dies and will not start for several mins. 1988 Royal 88 3800


MAF sensor is located between air filter and trottle body. During warm up take a screwdriver and lightly hit the MAF sensor if engine stall. then you have MAF sensor defect.
other thing is crankshaft sensor behing the harmonic balancer could touch metal when engine is hot enough have a look then good luck

Sep 14, 2013 | Oldsmobile Delta 88 Cars & Trucks

1 Answer

My 2000 lesabre stalls at lights??but restarts ok ??


one could be iac motor it's there to unstall. and MAF sensor.Try hitting with handle of screwdriver while the engine running if it change or stall MAF defect

Aug 09, 2013 | 2000 Buick LeSabre

1 Answer

1992 dakota v6 stalled while driving, won't start and not firing ?


Crank sensor.should be on back side of engine on passenger side were bellhousing is. controls spark and fuel pump.

Dec 06, 2012 | Cars & Trucks

1 Answer

My 93 cutlass ciera c stalls as if out of gas after about 5 min it starts


Sounds like fuel pump may be going out. Check fuel pressure to see if it is within specifications and steady pressure. Next time car stalls, lightly bang on the fuel tank with a rubber mallet or screwdriver handle about 10 times, then try to restart the car. If fuel pump is going out, this helps "free it up" and the car will start. It will only last a short while though and stall again.

Apr 29, 2012 | Oldsmobile Cutlass Ciera Cars & Trucks

1 Answer

My 1993 mustang almost started then it made a burp sound then stalled. I started it after this happened an it won't idle down it goes to 3000 rpm


find your idle sensor tap it with a screwdriver if idle works ok after smacking it replace idle sensor cost for part usually about 50 dollars

Nov 26, 2010 | 1993 Ford Mustang

1 Answer

While driving the engine goes dead immediatly, the radio and the headlights stay on. I try a few times and then it starts and runs. This happens totally irratically with no warning. It has never failed to...


You may have an issue with your ECU(car's computer).Remove the
passenger side kick panel to locate the computer box. Lightly tap on
it with a plastic handled screwdriver or something similar,while the
car is running, to see if it suddenly stalls? If it stalls,your ECU needs
replacing,or loose ground to it. Good luck.

Mar 30, 2010 | 1991 Cadillac Seville

1 Answer

Periodic stall issue. All guages go to zero,


Sounds like an intermittent short in the wire harness or ECU(computer).
If you can locate the computer(in the passenger side kickpanel), try
tapping on it with a plastic handled screwdriver handle, to see if the car
suddenly shuts down? If it does, your computer is shot. Good luck.

Mar 29, 2010 | 1997 Pontiac Bonneville

2 Answers

When i take my foot off the gas the car stalls.


u will need to take to the shop i could tell u all day what it could be and u could replace parts all day. but u need to have it put on a computer then u could only replace 1 part instead of 4 or 5..

Jul 18, 2009 | 1994 Ford Taurus

Not finding what you are looking for?
1995 Chevrolet Lumina Logo

121 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...