Key sticking in ignition key hole...hard to get out.......

if you have a metal bit for your drill that's small enough to drill a hole into the middle of the key:
drill a hole into the center of they key. stick in something into the hole (preferably a rod of metal) with superglue on it and gently try to turn the ignition after it's properly dried.

• In a straight line down the steering column cover from the key, on the right hand side of the bottom, there is a little hole that may have a round plastic cover over it.
• If cover is there, just pop it off with a small screw driver.
• Take about a 6 inch thin screw driver and stick it up in the hole while turning the key to the off position. This is a manual release that GM built in, knowing that their electronic release would fail.
• You may have to take several stabs at it, but dont push hard as it is a very light button.

Check for some foreign body in the key hole. Kids have a fancy of pushing match sticks in car key holes.

There is a hole under the steering column you will have to stick a pen in it, and you will hear a "spring" sound and you can remove your keys. Once removed, check your shifter, and clean around it. Sometimes this is caused because your shifter is not completely in park. Other solution is to replace the ignition switch after you get them out. Unless you want to just stick a pen in the hole everytime. Thanks.

replace the ignition mechanism please try to disassemble the steering column cover,turn the key to acc position,please try find the small hole upper portion of the ignition barrel then insert a small stick metal in the hole then pull it out the key,goes with the key mechanism then replace it or bring it to the "key duplicator shop"

hard! there is a hole on the steering column near the lock cylinder. normally you can turn the key and stick a small screw driver in it to pull out the lock cylinder. in this case you can drill the pin through that hole then pull it out

if you look on column right under switch you will see a small hole, theres the lock pin for the ignition, put key in ignition then with a small nail or pick stick in the hole push in then turn key slow you should feel pick push in the pin continue truning switch until a the dash lights come on and keep pushing in, then pull swith out, take new switch and turn key to same point as old slide in and turn key off, your done hope this helped.

YOUR GOING TO HAVE TO STICK A SMALL CHISEL INTO THE KEY HOLE USED A SMALL HAMER TO KNOCK IT IN SOME, WITH VISE GRIP TURN TO THE ON POSITION, UNDER THE HOUSING WHERE THE LOCK CYLINDER GOS INTO, THERE WILL BE A LITTLE HOLE PUSH THAT LITTLE PIN IN THERE WITH A PICK HOOK AND SLIDE IGNITION LOCK OUT.

sounds like there is a problem somewhere in the linkage.

There is a hole under the steering column right near the ignition switch, if the key gets stuck, stick a pen or something in the hole, you will feel the little lever move and you can remove the key.