Question about Nissan Altima

Open Question

My 1999 nissan altima dash lights and radio lights are not working. Already check the dimmer switch. when I turn off head lights radio lights come on but not the dash lights stay off. Check fuses and they are fine

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

ilragatzzo78
  • 241 Answers

SOURCE: Replacing a starter for a 1999 Altima

  1. Disconnect battery ground cable.
  2. Disconnect starter wiring from starter.
  3. Remove starter retaining bolts and the starter.
  4. Reverse procedure to install.
the bolts should be on the drivers side.
you will have to crawl underneath the car to do this task

Posted on May 15, 2008

mrgreenz
  • 962 Answers

SOURCE: head light 2005 altima

you have to remove the bulbs from inside of the hood in the engine compartment. in some cars you have to remove some "pins' and remove the entire headlight assembly.. You then remove the holder where the lightbulb is located and replace the bulb.

Posted on Nov 18, 2008

singjerrykin
  • 3 Answers

SOURCE: no dash lights and already check inside fuse

check fuses

Posted on Feb 09, 2009

  • 14036 Answers

SOURCE: interior dash lights out

make sure the dash lights dimmer switch is turn all the way off.it make your dash light not light up.if its okay check the wiring.

Posted on Apr 20, 2009

  • 383 Answers

SOURCE: replacement of a head gasket on 2.5 liter nissan altima 2002

frajogag: First off, be aware that these bolts are "torque to yield" bolts (streach bolts). What this means is that instead of torqueing the head bolts to a specific torque specification, they are torqued down to a set spec and then tightened by rotating the bolts a certain angle, like 90 degrees. and all of them are turned the same amount.
This means that the shanks of the bolts must be checked to make sure they are not too thin (or the bolt has already stretched beyond limits and is prone to snap if used)
Here is how you check the bolts. Measure the bolt using a micrometer, at the base, or within the first 13mm from the end where it threads in. Then go to about 10mm before the threads end heading toward the top of the bolt. There should not be more than a 0.23mm (.0091 inch) or less difference or the bolt should be discarded.
Torque the bolts down to 98.1Nm ( 72.ft lb)
Looking at the head from the side, so you are looking at the full length from side to side, I will number the head bolts in this fashion.
#1 & 2 are directly in front of you and in the center of the cylinder head crossing it width wise.
#3&4 are to the left of #1&2, / #5&6 are to the right of #1&2
#7&8 are to the left of #3&4 / #9$10 are to the right of #5&6
Now, you have the sequence.
After the initial pull, back off all the bolts in the same sequence and then retorque them to 36 Nm ( 28 ft lb)
Using a torque angle wrench or having the ability to accurately judge turning angles. Rotate (clockwise) to a 75 degree angle. do this to all the bolts using the sequence I had provided.
Rotate the bolts (clockwise) 75 degrees again on all bolts in the same sequence. The proceedure is complete!

Posted on Apr 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 97 nissan altima and my lowbeams dont work but my highbeams do and i already replaced headlights today?? what can i do


Could be your dimmer switch gone bad, that controls your low and high beams, the contacts for the low beam is usually the one that goes bad first, the high beam contact isn't used much.
My Oldsmobile had the same problem, only high beams worked, replace the dimmer switch and fixed the problem. Unfortunately with my car replacing the dimmer switch gave me a hard time. Most dimmer switches are located in the steering column underneath the dash board and a little hard to get at. Dimmer switch costs about 12 to 15 dollars, very cheap but very hard to reach and replace. The switch it self is activated with a small metal rod going up and down next to the steering column and into your turn signal lever, when you pull up it pushes the metal rod down to activate your high or low beam lights.

Mar 04, 2015 | Nissan Cars & Trucks

1 Answer

Nissan altima dashboard doesnt turn on


have you checked all the instrument panel fuses and check the dimmer to the dash lights? my be just a bad or dirty dimmer switch if you have done those things.

Apr 05, 2013 | 2004 Nissan Altima

1 Answer

My instrument panel does not light up when the lights are turned on 2006 nissan altima


I'm not shore about the 2006 but have you checked your tail lights as Ive found that if there's a glob out on some cars then your dash lights dont work. it maybe a fuse or is the dimmer switch turned down. try these 3 things I hope this helps

Feb 08, 2013 | 2006 Nissan Altima

1 Answer

I have a 1988 Nissan Altima and the dash lights went out. Is this a fuse or something else? If fuse, where is it? I didn't see one for the dashboard.


The fuse should be located under the dash on the driver side & fuses are also located under the hood. The best thing to do is to check your owners manual & it will point you directly to where your doom fuse is located. Also check to make sure your dimmer switch isn't turned off or low for the dash.

Jan 08, 2013 | Nissan Altima Cars & Trucks

1 Answer

1994 Altima dimmer switch replacement


Dash lights don't work off the dimmer switch, but the headlight switch. I would check the headlight switch first.

Dec 23, 2012 | 1994 Nissan Altima

1 Answer

Dash lights out 1999 nissan altima


Did you check the fuse and the dimmer switch control ?

Jul 11, 2012 | 2001 Pontiac Grand Am SE

1 Answer

1999 altima dash lights out


Check the dimmer switch on the left side of the dash. put the lights on and play with the switch on and off slowly and that is probable what it is.

Jul 13, 2011 | Nissan Altima Cars & Trucks

1 Answer

As soon as i tuen my head lights on dash board light don't work


you need to turn up the dimmer switch, which is located on left side of dash,next to the steering wheel. its a switch with light bulb looking logo next to it.

Dec 23, 2010 | 1999 Nissan Altima

1 Answer

My dash board and tail lights wont work. How do i


If in fact the fuses are ok then chances are it in the headlamp switch.

You can remove the headlamp switch and using a test light check the wires one at a time while moving the dimmer switch up and down. If you don't find a wire that fades from full bright test light to nothing then the headlight switch needs replaced. If you do find that the dimmer wire is working then chances are you either have a bad ground or a broken wire.

Jul 30, 2010 | 1999 Nissan Altima

1 Answer

1997 Nissan Altima. Dashboard lights.


i have replaced my dimmer roller switch to solve my problem with the dash bord light flickering and dimming by them selfs .. that or just flip (smack) the roller switch for temp inprovement untill you decide to install a new dimming switch..?

Jan 26, 2009 | 1997 Nissan.5 Altima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

398 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...