Question about 2002 Jeep Grand Cherokee

1 Answer

Rear axle seal is leaking...how do I change it out...does the axle have a C-clip to keep the axles connected to the carrier unit?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Hi.
what is the erorr p0445

Posted on Sep 12, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you change the rear axle seal


This is a c clip axle remove diff cover rotate carrier to gain access to drive pin bolt on passenger side of carrier. remove bolt 5/16 head pin will slide out . NOW DO NOT ROTATE ANYTHING. on the side the axle seal is bad tire should be off brake drum off (disc remove caliper and mount) push in on axle c clip should fall out then slide axle out. remove seal with a seal puller and install new one.

May 05, 2014 | 2001 Oldsmobile Bravada

2 Answers

I have greese all over the rear brakes


Rear Axle seals are bad, they must be replaced. Good Luck

Jan 14, 2011 | 1993 Ford Econoline

1 Answer

Fluid leak from left rear axle housing


This is caused by a leaking rear axle seal you will need to pull the left rear axle out and change the seal and check for a worn axle bearing, this requires the removal of the differential cover, pin and center block or posi spring and clutch pack (if so equipped) and spider gears and then the "C" clip that retains the axle into the gear carrier, u will need a tube of silicone to reseal the cover and a axle seal installer tool and about 2 hours of your time

Oct 28, 2010 | 2000 Ford Mustang

1 Answer

How do i replace the axle seals on my 69 roadrunner. it has the dana 8.75 rear end. it is leaking the gear oil into my brake drums


first make sure that its not the wheel cylinder's causing the leak as well okay? if so, replace. thats pretty straight forward. If it is for sure the axle seals, then you will need to remove the brake drums. take off the differential cover. there should be like 13 bolts, empty out the fluid. Rotate the differential carrier unti you can see a small bolt. remove the bolt and take out the axle pin. Once the axle pin is out, then push ONE axle in until u hear something drop. this is a c clip that drops inside housing usually will land at the bottom in the remaining oil. pick out clip. keep off to the side as u will need to reinstall this clip later. then once clip is out pull axle out of tube, and set aside. there are multiple ways to remove the seal itself. you can use a seal puller, screw driver, pry bar, or the axle itself. Becareful not to scratch the bore where the seal goes or else IT WILL LEAK. then just do the same for the other side. pay attention for the bearings and not to nick them either, or else they will need to be replaced as well and that's much more of a pain in te ***, lol..good luck!

Aug 24, 2010 | Plymouth Scamp Cars & Trucks

1 Answer

How do you remove an axle on the right rear of a 1999 explorer? it has a leaking wheel seal.


1. Drain diff if it has a plug.
2. Remove rear cover
3. Undo cross pin bolt and slide the cross pin out of the carrier
4. Push axle shaft in so you can remove the C clip
axle retainers
5. Slide axle out of housing.
6. Remove axle seal and then replace axle seal
7. Reverse steps

May 25, 2010 | 1999 Ford Explorer

1 Answer

Change rear whell seal 1997 f-150 gear oil comeing out of rear whell took tire off; took drum off; and saw gear oil all over brake shoes. Seal or bearing need to be replace? how?


replace the axle seal to replace pull the rear cover draining the gear oil then rotate the carrier around till the small bolt holding the carrier pin remove bolt pull pin out don"t turn carrier after pulling the pin push the axle in and remove the clip from the inside of the carrier that pin holds the axle clips in place after pulling out you can remove the axle then just pop the seal out and install new one use a socket or something that is the same size as the seal lube the axle and slide axle back in lift up when almost all the way in the tube putting it in the carrier once in replace clip and pullout on the axle thats it pretty much hope this helps you out

Mar 24, 2010 | 1991 Ford F250

1 Answer

I'm trying to remove the left rear axle so I can replace the outer oil/greese seal. Seems pretty straight forward, however I'm not totally sure where the ''C'' c;ip is located that I need to remove to...


Have someone try to move the axle in and out while you watch the end of the axle inside the spider gear carrier. The 'C' clip should be near the end and will drive off with a small punch. If there is no clip, then the axle/bearing is retained by a plate that is bolted at the end of the axle housing behind the wheel. The bearing and seal should be removed and replaced with the aid of a shop press.

Sep 30, 2009 | 2001 Jeep Grand Cherokee

2 Answers

Rear Axle Leak


if it is the seal, you will have to remove the caliper and rotor, remove the differential cover and remove the bolt and pin inside the diff carrier housing. push in the axle and remove the axle clip and pull out the axle use a seal puller or prybar to remove seal reverse the steps to assemble

Dec 10, 2008 | 2001 Lincoln Town Car

1 Answer

Leaking right rear axle seal on 1986 F-150


You must pull the diff cover off, then remove the center pin and spider gears, then remove the C clip that holds the axle in the carrier assembly.
Please rate me.

Nov 22, 2008 | 1986 Ford F150 SuperCab

1 Answer

2005 Yukon Front Diff Axle seals


You don't have to remove the whole diff to change the seals, but you will have to seperate it where the shaft meets the carrier housing. There is a clip holding the passenger axle shaft in place that you have to remove to change the seal. The drivers side axle stub can be removed with a little force as there is a spring clip holding that side in.

Sep 01, 2008 | 2003 GMC Yukon

Not finding what you are looking for?
2002 Jeep Grand Cherokee Logo

206 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7711 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...