Question about 2006 Ford Five Hundred
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Remove plastic plug on the inside of door there is 10 mm hole use a hooked pick set pick put through the hole and pull the plastic cir clip towards the back of the door that will release the smaller part of the outer handle then the handle itself can be taken out.this is so simple but so deceiving the actual cir clip is hard to notice because of all the plastic **** on the inside backing plate the cir clip is just on the inside of hole look hard it is 2mm thick & 20mm high (black plastic) place point of pick in between backing plate & cir clip hook it and pull back the front door is based on the same principle but is a lot easier
Posted on Jul 16, 2009
right rear just in front of wheel. push clips back and remove old filter. apply new filter insuring flow is correct direction by arrow on filter press the clips back in place and you are ready. check to see if it is leaking.
Posted on Mar 16, 2009
On the inside trim, you can remove screws (these screws may be covered by filler pieces or may be visible, or they may require you pry a plastic piece off that covers the screws) that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can disconnect the linkage connecting to the outer handle and remove the bolts securing the outer handle on
Posted on Nov 05, 2009
the linkage behind the handle either the retaining clip broke or popped off need to remove the door panel to check and fix
Posted on Mar 13, 2010
Testimonial: "Thanks I thought it might be a cable or linkage. Much thanks"
You should have some little plugs in the plastic edge on the bottom that can be popped off, that will expose screws, there is maybe one screw behind the door handle, and maybe a couple in the door pull. Then once it is unscrewed, pop off the plastic retainers that hold it the rest of the panel and up it goes, past the lock button and off, except that it is still connected by wires, you should be able to see what's going on behind the handle without taking the wires loose, just lean it up against the door or the car. There is also a plastic wind barrier stuck on there with the stickiest stuff you ever saw, take off your watch. Hope this helps.
Posted on May 11, 2010
Tips for a great answer:
Oct 17, 2017 | Ford Cars & Trucks
Nov 26, 2015 | 2005 Ford Five Hundred
Jun 27, 2012 | 2007 Ford Five Hundred Limited Sedan
Mar 06, 2010 | 2001 Toyota Sienna
Feb 10, 2010 | 2006 Ford Five Hundred
Dec 30, 2009 | 2007 Ford Fusion I4 SEL Sedan
Nov 19, 2009 | 2007 Ford Five Hundred Limited Sedan
Nov 04, 2009 | 2007 Ford Expedition EL XLT
Aug 30, 2009 | 2007 Ford Explorer Eddie Bauer
Dec 24, 2015 | 2006 Ford Five Hundred
Dec 06, 2015 | 2006 Ford Five Hundred
909 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: