Question about 2006 Dodge Ram

Open Question

2000 dodge diesel 2500 3/4 ton pickup. the tachometer bounces around from working okay to just not showing a reading at all. truck runs ok on hiway but sputters and jerks when idling.. can you help,please.?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75822 Answers

SOURCE: The car

sounds like you have an ignition missfire, have it put on an analyzer to determine the cause.

Posted on Sep 02, 2009

Testimonial: "The insight offered helped me determine a course of action."

  • 83 Answers

SOURCE: 2006 Dodge Ram 2500 diesel truck----need inside fuse box diagram

If you are looking for the fuse box diagrams or any other diagrams for your Ram, check promanuals.net for a factory service manual for around 20 bucks or so. It's an invaluable tool for my Ram 2500.

Posted on Sep 26, 2009

  • 7 Answers

SOURCE: 1999 Dodge 2500 4x4 quad cab diesel. Having tranny

1999 dodge up to 02 can shuttle shift in and out of lockup, most people think it is overdrive but it is lockup. It is caused by tps voltage jumping around. You'll find you will not see it on a scan tool. The dealer has a computer reflash, it doesn't fix the tps voltage bounce but it makes the computer not as sensitive about locking and unlocking the converter clutch with small voltage change at the tps. I had my truck reflashed, but on rare occasions it still does it a bit. Voltage bounce can start around 90,000 miles and continue to get worse with milage. It cost about $90.00.

Posted on Nov 25, 2009

  • 1 Answer

SOURCE: problem with hid on 2008 dodge ram 2500

Not too much amperage. HID lights use less amps. Duh. The circuit is showing a failure in the HID kit from not enough amps so it turns off. You need to add a resistor.

Posted on Dec 07, 2009

TimtheStick
  • 83 Answers

SOURCE: my honda drives okay for awhile then the

It sounds like you're loosing crank or cam siganl to the ECM. Unfortunately on that engine, both sensors are located inside the distributor and are not serviceable, short of a new distributor. I would check all wiring connections first, but more than likely, you've got a distributor about to drop a TRS or SRS sensor. the Stick

Posted on Dec 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Transmisson jumps in and out of overdrive at hiway speed is it a sensor?


I had a 2000 2500 (not diesel) there are two sensor. one on the tranny and one near the rear end

Aug 29, 2014 | Dodge Ram 2500 Cars & Trucks

1 Answer

Dodge ram 2500 diesel


check for broken timing belt /chain. Check that there is not air in the system

Aug 18, 2014 | 2002 Dodge Ram Pickup 2500

1 Answer

What dose the crank sensor control in a 96 dodge diesel


The crank sensor on the truck works with the camsensor the crank sensor uses the cam to synchronize and identify where number one piston position is at. It is responsible to fire you injector and for how long is determined by the cam position sensor. On a 96 Dodge diesel the crank sensor is also responsible for you tach reading,your air condition ,and for the alternator.

Mar 06, 2012 | 2008 Dodge Ram Pickup 2500

1 Answer

Fireing digram of 1999 dodge ram cummimgs 24 valve 5.9 diesel


Check this firing order for each engine...

1999 Dodge RAM 2500 ¾-Ton Pickup 5.9 liter V-8 VIN "5" HDC

zjlimited_759.gif



1999 Dodge RAM 2500 ¾-Ton Pickup 5.9 liter V-8 VIN "Z" LDC

zjlimited_760.gif


Hope this helps (rememnber to rating this free answer).

Oct 05, 2011 | 1999 Dodge Ram 2500 4WD

1 Answer

Where is the filter located on a 2001 dodge ram


2001 Dodge Truck RAM 2500 3/4 ton 4WD 5.9L Turbo Diesel 6cyl the Fuel Filter is located under hood, passenger side, lower engine area, mounted above starter.

2001 Dodge Truck RAM 2500 3/4 ton 4WD 5.9L SFI 8cyl the Fuel Filter is located under vehicle, center, below seating area, mounted on top of fuel tank, in fuel pump module.

Hope helps with this (remember rated the help).

Jun 01, 2010 | 2001 Dodge Ram 2500 Truck

1 Answer

2000 chevy 3/4 ton diesel no brale light but third brake light wo


I just Know that you replaced the bulb ,try a test lite ,make shure it's grounded well poke inside the socket for the bulb this metal socket gives the bulb both electric and a ground ,this is the problem,good luck.

Nov 14, 2009 | 2000 Chevrolet 2500

2 Answers

Dodge diesel, While pulling upon accellerating, truck gets jumpy


IT SOUNDS LIKE THE LIFT PUMP OR POSSABLE FUEL RESTRICTION CHANGE THE FUEL FILTER ALSO CHANGE THE AIR FILTER IF THAT DOSENT FIX IT YOU WILL NEED TO CHECK THE FUEL PRESSURE OUT OF THE LIFT PUMP BEFORE YOU WASTE THE INJECTION PUMP

Mar 08, 2009 | 1997 Dodge Ram 2500 Club Cab

6 Answers

1997 Dodge Ram 2500 Cummins Turbo Diesel


The cruise control on y 1997 dodge cummins diesel 4x4 suddenly stopped working.I checked the fuses but they are ok.any solutions?

Jul 12, 2008 | 1997 Dodge Ram 2500 Club Cab

Not finding what you are looking for?
2006 Dodge Ram Logo

Related Topics:

221 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...