Question about 2002 Dodge Caravan

Open Question

My engine light is flashing then stops then flashes again. What could the problem be???

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 18 Answers

SOURCE: flashing light on dashboard 98 dodge neon service engine soon light on

11= Timing belt skipped 1 tooth or more from initial learned value, Intermittent loss of either camshaft or crankshaft position sensor, No crank reference signal detected during engine cranking for dodge odb readout. Hope this helps.

Posted on Dec 08, 2008

Ad
ewashmidas
  • 362 Answers

SOURCE: I have a 1996 volvo 960 and the check engine light

Your vehicle’s computer system has self-testing capability. When the computer senses that there is a problem with one of the components or sensors it stores the correspondent trouble code(s) in its memory and lights up the "Check Engine" or "Service Engine Soon" light to tell you that there is a problem and you need to diagnosed and repaired it. The list of possible codes number in the hundreds. The code itself doesn't tell exactly what component is defective - it only indicates where to look, or what engine parameter is out of normal range. You or a technician will have to perform further testing to pinpoint cause and the proper repair. The light flashing when you are driving indicates a more serious problem that should be fix right away or more problems can occur.

Dave.

Posted on Mar 05, 2009

freetek
  • 5568 Answers

SOURCE: Check engine light intermittently flashing, car jerking.

If you have one of the chain auto parts stores near you, check with them by phone first but most of them offer a free scan of your computer which probably has diagnostic codes stored related to your problem.

Posted on Sep 25, 2009

  • 99 Answers

SOURCE: mazda 626 hold light flashes

it's probably the problem with the sensor failure or the switch fails to completely off the current flow, it's a miner issue so for hazel free drive do visit the nearest MAZDA authorized service station or see for a good skilled & experienced mechanic who may sort out this problems so till the next this is siddhesh saying bye for now feel free to ask any quires regarding automobile field we will be happy to help you so till the next time have safe drive & happy motoring.

Posted on Oct 08, 2009

  • 2187 Answers

SOURCE: My 1997 Dodge mini van will not start. When I do

The flashing check engine light would mean that the engine is misfiring, If you have a scanner, use it on the diagnostic port of the engine to check for the error code to get which cylinder is misfiring and if there are other errors that needs to be checked.

Posted on Jan 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why would your check engine light flash 3 times and stop


Pretty sure that's just the computer resetting. Don't worry about it unless it goes on again.

Sep 16, 2014 | 1999 Dodge Intrepid

2 Answers

I have a 2000 chevy metro that has a rough idle and check engine flashes


The flashing light is indicating a misfire which is what you are describing. When is the last time you had a tune up? Most likely just replacing the spark plugs/wires will fix it.

Jan 11, 2013 | 2000 Chevrolet Metro

1 Answer

Why does my check engine light flash while driving


Can you read the flashes?

Try reading the flashes a bit like morse code. something like flash..flash..flash...............flash...........
would mean Error 31. Three consecutive flashes, a pause, then one more flash.

If there are no pauses or anything though, then you will likely need an OBD computer to read the fault.

Nov 12, 2012 | 1996 Chrysler Town & Country

1 Answer

1997 Buick theft system light flashes won't start


Try turn key on car but not start for few min.Call dealer for alarms ask ththem.Or get online.

Aug 12, 2012 | 1997 Buick Skylark

1 Answer

Service engine light flashes then solid then flashes.car runs rough when stopped.2005 v 6 mustang


the flashing and stopping is a code if you look in manual it will show you what code it is count the flashs between the stop and look it up or try disconnecting battery for 5 minutes the reconnect this should reset cpu then if it does this again have it diagnosed on computer to see what fault it is

Jul 08, 2011 | 2005 Ford Mustang

2 Answers

03 grand am 3.4l no crank at all. All the light on dash work good fuel pressure starter spins and engine starts and then stalls when jumping the starter directly installed new pass lock switch and...


If the Passlock switch has been replaced, the computer has to "learn" the new Passlock code. You will need to hook up a battery charger to perform the learning process. (It takes about 30 minutes with the key in the "ON" position and it will run the battery down.)

Step 1:

Turn the key to the "START" position and release to the "RUN" position. The "SECURITY" light will be flashing. After about 10 minutes, the light will stop flashing.
.
Step 2:

Turn the key "OFF" then back to the "RUN" position. (Do NOT try to crank it yet) The light will start flashing again. Wait about 10 minutes for it to stop flashing.
.
Step 3:
.
Turn the key "OFF" and back to "RUN" one last time. The light will be flashing again. This time, when it stops flashing, do not turn the ignition off. Instead, turn the key from the "RUN" position to "START". The engine should start and run. The computer has now learned the new Passlock code.

Please help myself and others by taking the time to rate my answer. Thank yoou for using fixya!

Feb 08, 2011 | 2003 Pontiac Grand Am

1 Answer

Why wont my car start even after i tried the security reset. i turned key to on position for 10 minutes turned it off then tried to start it 3 times. security light still flashes


turn the key on and wait till the security light stops flashing ( this could take as long as 30 minuets ) then turn the key off then back on but do not try to start the engine and wait till the security light stops flashing ( again this could take as long as 30 minuets ) then turn key off then turn key on and start engine.

Jan 31, 2011 | 1996 Buick Regal Olympic Gold

1 Answer

ENGINE MISFIRE TO THE POINT, THE CHECK ENGINE LIGHT COMES ON. AN IT WILL START TO FLASH. AN WONT GO OUT UNTIL YOU TURN OFF THE CAR .60-65 IT WILL STOP, AS SOON AS THE CAR START TO SLOW DOWN.IT START ALL...


wait untill its dark outside, open your hood and start the engine. look around for white / blue or yellow flashes of light coming from your plug wires. most of the time the spark plug wires are worn out / degraded from heat , and you can see the small lightning flashes in the dark. if you see no light flashes ( shorts to ground) then you can have a cracked / faulty distributor , or bad spark plugs.

Jul 31, 2010 | 1999 Mercury Cougar

2 Answers

Check engine light is on check engine light


Take the vehicle to Auto Zone, advanced Auto parts or o'Rieley's Auto parts and ask them to use their scanner to read the stored Code from the ECM for you.

Jul 14, 2010 | Cars & Trucks

Not finding what you are looking for?
2002 Dodge Caravan Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...