Question about Infiniti G35

Open Question

My 2003 infiniti G35 Sedan makes a loud clicking noise when using the breaks. per the dealearship I changed both back rotors and break pads. after 2 months the clicking is back. what can i do to get rid of the clicking

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
kcmetal9901
  • 102 Answers

SOURCE: How do I get the fuel door unlocked - 2003 G35 Infinity Sedan

there is a small cable in the trunk behind the carpet that,when pulled, is a manual release. Look behind the carpet on the side of the cars gas tank. hope this helps. Don't forget to rate my answer.

Posted on Dec 10, 2008

Ad
  • 1 Answer

SOURCE: I have a 2004 infiniti sedan g35... the pass side seat does not

i just fixed this problem - the switch is bad - take out the seat - 4 bolts on the bottom 4 corners and then remove the whole switch - either buy a new one around $200 or unsauter the switch and clean it but be careful as there are a lot of parts inside that can fall out. i cleaned mine and it works fine beats spending the money.

Posted on Apr 24, 2009

  • 1 Answer

SOURCE: Problem with break caliber and pedal and rotor 99 corolla

you might have a froze caliper piston, he is asking for all of that because whenever you change a caliper out you dont just want to change the caliper but do the brake job while you are there because more than likely the rest of your brakes are worn as well and if you just do the caliper you will damage you brakes more because of uneven wear sometimes a caliper gets locked up from extreme wear on pads past limit, he is actually saving you money in the long run. now as far as price it doesnt take much to change a caliper out, if you pinch off the line hooking directly to that caliper and unhook it along with the two bolts, all you have to do is put the new one in and pump the brakes back up and then bleed them to ensure all air is out of brake system, and depending on make and model, bleed them starting from furthest wheel from master cylinder....in other words you should be able to find a better price cheaper considering they want to replace the rotors instead of resurfacing them so that is alot less time to just replace them it is merily just parts changing, I hope i could help

Posted on May 14, 2009

isaid
  • 302 Answers

SOURCE: where is the starter located on a 2004 g35

ACESS DA STARTER FROM UNDER THE CAR, IF U STILL CANT LOCATE IT JUST FOLLOW DA POSITIVE BAT. CABLE FROM BAT TO STARTER

Posted on Oct 04, 2009

  • 86 Answers

SOURCE: 2003 Infiniti G35 - VDC, slip and brake lights on

The abs sensor may have been damaged when the repair was done.

Posted on Feb 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My car makes horrible loud squeaking noises from front end of car under hood when temps reach 95 outside. Could this be suspension related and how serious and expensive.


May be fan belt, check tension by looking 2 c if arrows r within tolerance on the belt tensioner. If arrows r beyond tolerance, replacement is necessary. Or u could push up&dwn on both front fenders (one at a time) 2 hear 4 ur noises. Good luck.

Aug 08, 2015 | 2007 Infiniti G35 Sedan Sport Sedan

2 Answers

Y my breaks make noise on the rear of my g35 2004


It's most probably the wear indicators on the brake pads. They make an irritating low pitched intermittent squeal or groan each time they contact the turning rotor. The noise goes away when you step on the brakes. Check the pad wear by pulling off a wheel and looking through the slot on the circumference of the caliper. You should have even wear on both pads, and at least an eighth of an inch of pad left. If not even you'll need to pull the caliper, and clean and lube the pins it slides on. If worn or uneven, replace them; it doesn't pay to try and wait for pads to wear down any farther, because you'll probably end up scoring the rotor.

Oct 12, 2014 | 2004 Infiniti G35 Sport Coupe

2 Answers

What is the grinding noise on my 2003 Grand am front wheels, help please?


There are many things the grinding noise can be. I would start with the breaks though as that sounds like the most likely culprit. If they are grinding, odds are you have ruined your rotors and/or drums. This means that you are looking at about $50-$70 in new parts per wheel (Total of $200 to $280) to replace, assumming only the pads and rotors/drums needs to be replaced.

Please note that breaks can be a good DIY project, but this takes an intermediate skill level with some expereince. Some vehicles are easier than others. Drum style breaks can be especially tricky as they relie on a system of springs that can be challenging to work with. There is also a hydrulic system that can have issues. If you see break fluid when you take off the wheels and drums, you have much larger issues and I would recommend getting in touch with someone more qualified.

Jun 24, 2012 | 2003 Pontiac Grand Am

1 Answer

Front brakes make noise when applied after installing new pads.


it could be because they are dirty. also the noise could be the back brakes. if its a squeaking noise it could be that they are dirty or that they are cheep brake pads and for the first couple of weeks they squeak. also when you got your breaks changed did the break shop cut the rotors because that cleans them up and makes the rotors like new.

Apr 28, 2009 | 2003 Suzuki Grand Vitara

2 Answers

2003 Infiniti G35 Starter location


Downloaded a PDF detailed service manual online. Gives you diagram and everything else you need.

Feb 16, 2009 | 2004 Infiniti G35 Sport Coupe

1 Answer

Breaks meaking load noises


Did you turn the rotors when you replaced the pads? if the rotors are not turned they will squall. Also you should have used some break quiet on the back of the pads you can get it at the parts store

Dec 16, 2008 | 2004 Kia Sorento

2 Answers

How do I get the fuel door unlocked - 2003 G35 Infinity Sedan


there is a small cable in the trunk behind the carpet that,when pulled, is a manual release. Look behind the carpet on the side of the cars gas tank. hope this helps. Don't forget to rate my answer.

Dec 06, 2008 | 2005 Infiniti G35

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Infiniti Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14384 Answers

Are you an Infiniti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...