Question about 2004 Mazda MPV

1 Answer

My 2004 MPV shaking so bad, specially when stepping on the brake at reverse or drive, and before that, the engine light was on. What do you think the problem was?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Hopefully this may be of use to you. I've just had similar symptoms with a 2003 MPV. It shook when it warmed up and with brakes applied. It also turned the check engine light on with codes P0171, P0174 and P0300 which were bank 1

Posted on Sep 14, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2004 sienna hit bumpy corner express road at 45mph, seconds later the whole van shakes like I'm driving on 4 flat tires then vsc and check engine light comes on. The van refuse to move as if I


Hello


The Engine and Automatic Transmission (not applicable to manual transmissions) in this vehicles drive train are fully electronically controlled by a computer called the PCM and TCM (Power Train Control Module, Transmission Control Module). When a problem like this or other drive-ability related problems occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM. Also always check fuel pressure for correct spec for your make and engine type.


Sep 20, 2012 | 2004 Toyota Sienna

1 Answer

Steps to replace water pump mpv 3.0


Remove the battery and battery tray.
Drain the engine coolant.
Remove the water pump drive pulley.
Remove thermostat case
Remove water pump tensioner
Remove water Outlet pipe
Remove water pump
Reverse disassembly order to install water pump.
Fill and bleed cooling system

Aug 14, 2011 | 2004 Mazda MPV

1 Answer

The front wheels and steerting wheel of my 1994 ford escort shake when accelerating and braking.... could you tell me what the problem might be ?


Probably one or more bad motor or transmission mounts. You can brake torque the engine in reverse and drive, if the engine rocks violently in either step those mounts need replaced.

Apr 06, 2011 | 1994 Ford Escort

1 Answer

My car shakes when am stopped only in drive or reverse. it stops when i am going at a faster speed what could be the problem


I think the first step is to check the engine mounts.Open the hood,put your foot on the brake hard,put the car into reverse,rev the engine,and have someone watch the movement of the engine.You are going to need both feet for this.The engine should move no more than an inch.Have the person stand off to the side and repeat the procedure in drive. Hope this is it.Good luck

Nov 05, 2010 | 1999 Isuzu Rodeo

1 Answer

Engine Mechanical problem 2004 Kia Sedona 6 cyl Front Wheel Drive Automatic 100K miles the mpv has a 2.5L, Problem: 1) when press a little hard at the pedal to make the car move, the engine shake...


Nothing to do with valve control but o2 sensor should be replaced and also sounds like the engine is misfiring when gas is applied, this may be caused by a bad coil or sparkplug.when was your last tune up?, i would replace sensor and also make sure there are no other codes , even check for history codes.

Aug 22, 2010 | 2004 Kia Sedona

1 Answer

My 2002 Mazda MPV recently developed an engine shake when stop at intersection or driving 45mph or slower. My mechanic scanned and found OS2 code, vacuum leak, replaced the intake hose, reset engine...


You might try another mechanic if this one can't get it fixed. Shaking is usually caused by one or more cylinders mis-firing for whatever reason--usually faulty ignition or fuel injection. Has the engine had recent tune-up? Bad spark plugs/plug wiring are frequent villains. Not sure what an 'OS2' code is. Hope this helps!

May 21, 2010 | 2003 Mazda MPV

1 Answer

I have a 2002 Mazda MPV; the engine is shaking, foward and backward really hard when I am sitting still, with the car in gear. What's strange is that it doesn't shake when I have the emergency brake on,...


Possibly a bad / leaking brake booster basically creating a major vacuum leak when the brake pedal is depressed. Had one in the shop just last week doing exactly the same thing & that was the problem.

Oct 03, 2009 | 2002 Mazda MPV

1 Answer

Car is shaking when sitting in drive at stop


should be 95 octane try that first ,because it will cause pre detonation which could be the problem

Jul 09, 2009 | 2004 Mazda MPV

2 Answers

'03 MPV problem


we had a very similar problem on our 2003 mazda mpv. at first we were also told coils. we changed all the coils out and the problem came back. we found out that it was a leak in the egr valve and gasket. there was also another leak found after that. when the leaks were fixed, the problem stopped. i suggest checking for leaks in your engine, this could be the problem.

May 28, 2009 | 2003 Mazda MPV

Not finding what you are looking for?
2004 Mazda MPV Logo

810 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...