Question about 2008 Mitsubishi Lancer

Open Question

I have a fuso super great with 8m22 engine..when it starts,has a high rpm,then it goes down and down..then no more power

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 128 Answers

SOURCE: Hesitation or stumble during acceleration

take your car for a tune up
if they are carburetor type motors you may need your carbie cleaned and a tune up
if you clean it your self with carbie cleaner it may increase in idle speed this is nothing to worries about it is a simple adjustment
with a carburetor type motor they tend to idle higher when their cold this is the automatic choke kicking in and normally it should happen till the car is a bit warmer and the accelerator has been depresses
although a car should idle at 800 rpm my paddok car dose when it is cold it idles at 1200rpm i like it this way as the car warms up quicker as i will not drive a car while it is cold
hope this helps

Posted on Dec 27, 2008

  • 9 Answers

SOURCE: high tick over

Try replacing the air mass meter

Posted on Dec 29, 2008

  • 11 Answers

SOURCE: 98 chevy cheyenne king cab 4x4 diesel 6.5 dually.

Ditto? TCC (torque converter clutch solenoid on the way out or already kaput...?

Posted on Jul 08, 2009

  • 5 Answers

SOURCE: At high RPM engine sputters like it's flooding.

check your fuel pump and filter,filter may be dirty ,fuel pump may not be pushing anough presser,or your pressure ragulator my be leaking

Posted on Jul 22, 2009

  • 2 Answers

SOURCE: High rev when starting hyundai atos

Check the vacuum hoses, but sounds like the IAC or even the o2 sensors. The computer will pick up on the o2 sensors but not the IAC..Go to your local ADVANCE store and they will check on computer for free :)

Posted on Jul 26, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What is the problem of my super great 10m20 engine is low power

thats a big fuso diesel truck

if it starts up ok glow plugs and engine is ok
if it dies under load or blows heaps of smoke
look in to these possibles

if turbo-ed faulty turbo or internal crack
dirty air filter
fuel pump /filter
cylinder compression


Oct 21, 2016 | Cars & Trucks

2 Answers

Engine low power

I, feel sorry for you, after reading your problem, but don't worry you visit the Reliable-Store they will help you for sure.
Best Manuals

Aug 25, 2016 | Mitsubishi Cars & Trucks

1 Answer

I have a fuso super great with an 8m22 engine when i on the key it saids japanese the only word i understand is engine lo.....and it has a warning light color orange

Can you please send me the picture of the fault indicator showed on your dashboard of your Fuso super great 8m22 to my email

May 06, 2016 | Cars & Trucks

2 Answers

What is the problem of my fuso super great 6m70 would not start after the engine fuel was dilluted by water

Your answer is water in the gas drain fuel tank put fresh fuel in and add a bottle of dry gas

Apr 01, 2016 | Cars & Trucks

1 Answer

What is the problem of my fuso super great 6m70 engine..when you rev to 20k rpm it will changed the engine timing or "palyado" when it switch off then start again it back to normal again..pls help me..TIA

All computer controlled ignition systems are set to a base ignition timing. The computer will advance or retart the ignition timing according to engine speed and load. This is normal.

Nov 20, 2014 | Cars & Trucks

1 Answer

92 accord engine/rpm/lack of power problem

i had the same prob on a toyota check out the fuel presure if its good its prob the fuel regulater i think it should have around 32 psi but call and double check that

Feb 27, 2012 | 1992 Honda Accord

Not finding what you are looking for?
2008 Mitsubishi Lancer Logo

Related Topics:

612 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides