Question about Ford F-150

1 Answer

Emy recently purchased 2001f-150 , windshield wipers will not come on unless i shift to neutral or park, after they come on they will not turn off unless i shift to neutral or park.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

All the signals-hi low -wipers and wiper speeds windshield washer are all on the same switch so change the switch this should solve your problems good luck.

Posted on Aug 31, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need to replace a neutral safety switch on a 1995 Buick Park Ave, where is it located?


i have a 97 par avanue. i had to remove the windshield wiper resovior to get access to it. Once it is removed, itis easy to access the neutral safety switch

Aug 18, 2012 | 1995 Buick Park Avenue

1 Answer

I recently changed my wiper motor in my 2003 Hyandai Accent. Now the windshield wipers will not stop at the bottom. When I turn thw wipers on, it goes donw first then up then back and stops in the middle...


Remove the linkage from the wiper motor. Turn the wipers on then off. This will set the motor in the park position. Move the wipers by hand to there normal off position. Reinstall the linkage onto the wiper motor. The wipers should now park or stop in the correct position.

Sep 08, 2011 | 2003 Hyundai Accent

2 Answers

Windshield wiper will not turn off on my 2006 trailblzer unless we trun car off fuel gauge reads empty even when full


WIPER NOT TURNING OFF.WIPER MOTOR LIMIT SWITCH BAD.FUEL GAUGE READING EMPTY COULD BE A FAULTY FUEL LEVEL SENDING UNIT.

Dec 12, 2010 | 2006 Chevrolet Trailblazer

1 Answer

2oo2 ford F-150 can't get out of park,wipers and elec. windows won't work


check for water intrusion on left side of dash. just above the fuse panel (or on backside) if this is so..the GEM module may have been damaged...for short term to drive the truck...turn the key to the on position without starting truck...shift into neutral, then start the engine....you can now drive the vehicle until fixed...hope this helps!

May 28, 2009 | 2002 Ford F150 Regular Cab

1 Answer

Need to get a programmer dont know where its at


  • Windshield Wipers Continue to Run When Turn Signal and Windshield Wiper Switch Are Turned OFF
  • Damaged turn signal and windshield wiper switch .
  • Damaged windshield wiper motor .
  • Damaged windshield wiper control module.
7fd52e7.gif
efd7dbe.gif
Pin Number Circuit Circuit Function 1 57 (BK) Wiper Motor Ground (Park) 2 28 (BK/PK) Wiper Module to Wiper Motor (Park Switch) 3 65 (DG) Wiper Motor Power (Park Feed) 4 61 (Y/R) Wiper Motor Common (RUN) 5 56 (DB/O) Wiper Motor LO 6 58 (W) Wiper Motor HI
Windshield Wiper System The windshield wiper system consists of :
  • Windshield wiper motor (17508) (F-type).
  • Washer system.
  • Windshield wiper control module.
  • Turn signal and windshield wiper switch (13K359).
The windshield wiper control module is:
  • Located at the instrument panel fuse panel.
The windshield wiper motor is:
  • Attached to the cowl top extension (021A36) .
  • Connected to windshield wiper mounting arm and pivot shaft (17566) .
The turn signal and windshield wiper switch features a:
  • Rotary wiper switch.
  • Push type washer actuator.
OFF/Low/High Speed
  • Has a two-speed, permanent magnet, three brush electric windshield wiper motor .
  • The windshield wiper motor has a brush rigging that permits selection of low or high speed.
  • When the turn signal and windshield wiper switch is in the LO position, the common brush and the blue/orange wire brush are used, and the windshield wiper motor operates at low speed.
  • When the turn signal and windshield wiper switch is in the HI position, the common brush and the white wire brush are used.
  • In HI position, electric current will bypass a portion of the armature winding causing the windshield wiper motor to operate faster.
  • When the turn signal and windshield wiper switch is moved to the OFF position, the windshield wiper motor will continue at low speed until the park switch outer contacts open.
  • When the park switch contacts open, the windshield wiper motor stops in the park position.
Interval
When the turn signal and windshield wiper switch is in the interval position:
  • The wipers make single wipes separated by pauses.
  • The rotary switch is on the end of turn signal and windshield wiper switch .
  • The length of the pause can be set from approximately 1 to 17 seconds.
  • Length of pause decreases as the rotary switch is rotated away from off.
  • Length of pause increases as the rotary switch is rotated toward off.
While in the interval wiper mode:
  • It is normal to hear a slight click at the beginning of each on/pause cycle. NOTE: When using interval wipers, the first wipe may not occur until after a pause of up to 17 seconds.

May 27, 2009 | 1994 Ford Mustang

2 Answers

1990 Ford Taurus GL windshield wipers park in the wrong position


I have a 1996 Ford Taurus with a similar malfunction the intermittent wiper function is erratic, but the wipers park properly. I'm the original owner & this malfunction was in the car from the factory. I have a regular Ford Dealership manual & came to the conclusion that the Generic Electronic Module located behind the fuse panel is bad (computer glitch in programming) ! Ford Dealers want over $ 300.00 for a brand new module, I haven't checked with my local used auto parts recycler yet, but I know it will be less than the dealer price !

Mar 16, 2009 | 1990 Ford Taurus

2 Answers

On rainy days, my windshied wipers work when they want to and the radio comes on in the park and neutral position on my 2000 ford expepdition. does any one have any ideas.


You most likely have a water leak around the windshield on the driver's side and it is dripping down into the GEM module which mounts on the back side of the interior fuse panel.

Mar 16, 2009 | 2000 Ford Expedition

2 Answers

Windshield wipers not parking


The problem could be a bent parking pall bracket. This is usually caused when you wipe snow from windshield using the wipers instead of brushing off. You need to remove both wipers and the cover from the drivers side. Remove the cover over the wiper motor assembly (held by a plastic button). On the right side of the wiper mechanism is a small tab (part of the wiper bracket). This tab needs to be straight for the wiper park pall to rest against.Carefully hammer this tab straight (or you may have to replace bracket, big job) Then cycle the wiper and you will see the assembly return to park position. Re-install all parts in reverse order.
Hope this works for you.

Jan 15, 2009 | 2003 Chevrolet Impala

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5481 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...