Question about 1998 Dodge Caravan
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: starter for dodge caravan 2000
DISCONNECT THE BATTERY, JACK UP AND SUPPORT YOUR CARAVAN. LYING ON YOUR BACK LOCATE THE STARTER WHICH IS ATTACHED TO THE ENGINE THROUGH THE BELL HOUSING .THERE ARE TWO 15 MILIMETER BOLTS THAT HOLDS THE STARTER ON . AFTER BREAKING THE BOLTS A 15MM WRENCH WOULD BE USEFUL.
Posted on May 30, 2008
If you're on the smallish side and pretty limber, you might avoid removing the rear wheel. If not, you will likely need to remove the rear wheel and put the van on jack stands securely. I would remove the underside splash shield and gain access from underneath. It looks like you will need to unscrew the plastic insert that surrounds the filler neck inside the area that is exposed when you open the fuel door. Make sure you get the vent hooked up correctly when you are done.
Posted on Jan 31, 2009
I recently had the same issue, but my airbag warning lights also turned on. If this is the case, it might be the clockspring. There is a recall on clocksprings for Caravans 1998 - 2000 I believe. I got it replaced for free in the dealership. Enter your VIN in this site and it will tell you if you are covered in the free replacement warranty.
Hope this helps.
Posted on Mar 06, 2009
SOURCE: Check Engine Light
It is for the radiator fan relay control circuit.It means there is a problem in the cooling fan relay circuit.Could be the relay,wiring,or the fans.Check the fuses and relay over if it looks good then you have to take it in to get it diagnosed.You need a scan tool and you also need to know how to use a multimeter.Hope this helps.Good luck.
Posted on Feb 24, 2010
To align both sets of timing marks, turn engine crankshaft to the right with belt on cam and crank. Once you have done this the crankshaft alignment mark (on front of crankshaft gear) will line up with mark to the rear of gear on engine block.The two cam gear timing marks should be alines across from one another. The right cam gear is the intake side and the left side is the exhaust side. After removing the belt turn the exhaust cam down 1/2 notch. Timing mark on exhaust 1/2 notch down from the intake side. Install new belt and recheck everything to make sure it's all correct. Hope this will help you.
Posted on May 27, 2010
Tips for a great answer:
Sep 20, 2014 | 2000 Dodge Caravan
Feb 06, 2011 | 2000 Dodge Grand Caravan
Aug 21, 2010 | 2000 Dodge Caravan
May 08, 2010 | 1997 Dodge Caravan
Nov 21, 2008 | 2000 Dodge Caravan
Oct 26, 2008 | 2000 Ford Expedition
123 people viewed this question
Usually answered in minutes!