Question about 1999 Honda Accord

1 Answer

How much fuel should the injectors put out on start up?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 220 Answers

That is a difficult question to answer. The injectors are controlled by an electronic engine control. By various sensors the EEC determines the correct amount of fuel needed by the engine. A cold engine will require a richer mixture than a hot engine. etc. Since the Honda uses direct fuel injection, you never see them in operation like you can by looking down the throat of a carburetor. I hope that helps, but I guess I would have to say I don't know exactly.

Posted on Aug 31, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

96 Chevy Silverado 1500 5.7 liter V8 will not start good fuel pump fuel filter good fuel pressure no start. If you put gas or a catalyst into the intake it starts


no signal for the injectors
check cam/crank position sensors
check immobilizer operation
check ecm and harness connections

May 20, 2016 | Cars & Trucks

1 Answer

Fuel injector. The car seems to drop a cylinder. I replaced the plugs and it ran well for about five minutes. It then started to miss again. I think number 3 injector is bad. How do I replace one injector.


FIRST YOU NEED TO RELIEVE FUEL SYSTEM PRESSURE BY REMOVING FUEL FILLER CAP THEN DISCONNECT FUEL PUMP HARNESS OR UNPLUG FUEL PUMP CIRCUIT RELAY, THEN START ENGINE LET IT IDLE UNTIL DIE LACK OF FUEL.TO REMOVE FUEL INJECTOR YOU NEED TO REMOVE FUEL DELIVERY PIPE WITH FUEL INJECTORS AS A ASSEMBLY TO REMOVE FUEL INJECTOR.YOU NEED TO TAG NUMBER ALL VACUUM HOSES AND PCV VALVE,NUMBER TAG FUEL INJECTORS WIRE CONNECTORS SO YOU CAN PUT EVERY THING BACK IN RIGHT PLACE.

Oct 14, 2011 | 1994 Toyota Corolla

1 Answer

I have a 1997 dodge grand caravan 3.8l v6 with about 146k. I stopped at a gas station and put gas in it (was at 1/2 tank) Went to start it and it started hard. Cranked for about 4 seconds before turning...


Have you ever put in the gasoline tank any fuel injector cleaner yet because your injectors which injects the fuel of gasoline, if the injectors are not injecting enough fuel into the piston chambers that the fuel injectors needs to be clean to allow enough fuel to come in so go buy injector cleaner at autozone and put the whole thing into the gasoline tank and then drive. Your fuel injectors are clogged or going serious bad on you so you might have to replace them as well but first try to put fuel injector cleaner and see.

Jun 09, 2011 | 1997 Dodge Grand Caravan

1 Answer

The rubber o-rings fell out of the fuel line, and I need to know what order they are supposed to be in so I can put them back correctly.


emove the six reverse torx bolts from the fuel rail using an E7 star socket. You may notice that the paper fuel rail gasket is starting to or maybe already has broken between the intake ports. This will cause a lean code condition. (P0171 and P0174)
2. Gently pry the fuel rail off of the lower intake and the six injectors. Note the orientation of the injectors beforehand.
3. Remove all six injectors and discard all 12 o-rings.
4. Thoroughly clean all gasket surfaces and o-ring surfaces.
5. Clean the o-ring areas on all the injectors.
6. Put new o-rings on the injectors. A light film of motor oil on the o-rings will help in seating the injectors.
7. Put the injectors into the lower intake.
8. Put new paper gasket between the fuel rail and lower intake and make sure all of the injectors are seated into the fuel rail.
9. Put the six reverse torx bolts back in and torque them down in this sequence:
<Firewall 1 3 5
............ 6 4 2
To 12-16 N*m (9-11 lb*ft)

reassembly is the reverse of the dissassembly. after you get this done, get you a cold one. heck get two. you deserve it.

(you can let the children and small animals back in the area now)

Dec 06, 2010 | 1993 Ford Explorer Limited

1 Answer

1995 Bonneville: i have 1995 pontiac bonneville fuel all the way to...


have 1995 pontiac bonniville sse fuel all the way to injectors will run if you put fuel into intake then starts and runs till fuel runs out. I have replaced fuel pump and fuel pump filter,cam postion sensor and coil paks

May 16, 2010 | 1995 Pontiac Bonneville

2 Answers

After removing the fuel injectors and rail to remove the manifold, how do you reinstall the fuel injectors?


the same way you took it apart. put a little grease around the rubber seals so they will slide in easier. just tap on the fuel rail while lightly tapping it into place.

Mar 28, 2010 | 2002 Honda Passport

1 Answer

1994 chevy suburban, no fuel coming from fuel


Put an injector noid light at the injector plug terminals to see if your getting a signal from the PCM(computer).If not try to find a computer from the same vehicle that works and swap it into yours to check.A PCM swap will take about 15minutes.

Sep 23, 2009 | Chevrolet Suburban 1500 Cars & Trucks

1 Answer

My 1987 wont start a second time after warming up.


FLOODING IS WHAT HAPPENING.CLOGGED OR DIRTY FUEL INJECTORS. IS LEAKING WITH ENGINE OFF.FILL FUEL TANK.PUT A BOTTLE OF FUEL INJECTOR CLEANER IN FUEL TANK.DRIVE AROUND SO THE FUEL INJECTOR CLEANER CAN CLEAN FUEL INJECTORS.

Sep 13, 2009 | 1987 Ford Mustang

2 Answers

Help w 1994 chevrolet truck


This injector set-up needs a specific fuel pressure supplied to the fuel rail to even start, much less run properly. The fuel pump is immersed in fuel inside the gas tank to keep it cool and not burn up. Running the fuel level low causes more heat in the pump and interuptions in proper fuel pressure. AC/Delco pumps have proven to be a reliable fix, the aftermarket pumps only last for a month or two sometimes. Check fuel pressure under the hood and power and ground to fuel pump at electrical harness at top of gas tank. This truck needs a fuel pump.

Aug 18, 2008 | 1994 Chevrolet C1500

Not finding what you are looking for?
1999 Honda Accord Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...