Question about 2007 Audi S6 Sedan

Open Question

How to replace headlight bulb on drivers side on audi a5 2006

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Scorpedo
  • 111 Answers

SOURCE: bulb replacment

The bulbs are changed from the rear. There might be a weather cover, once its removed you will see a ring or clip holding in the bulb , remove that to remove the bulb. Install in reverse order. And a little known fact most parts stores will install bulbs for free when you buy them.

Posted on Dec 16, 2008

  • 1 Answer

SOURCE: 2006 Trailblazer Headlight Replacement

There are not two rods, there are two clips one under fender weild and one right above the light on top of the cover. Pull up on these two clips and pull the light forward a couple of inches and remove the dust cover. You have to take the air filter cover off to be able to reach in and replace the light. It took me about 10 min to figure these out but hope it helps out.

Posted on Jan 14, 2009

j_del
  • 1586 Answers

SOURCE: 2000 Audi a4 headlight bulb replacement

The easiest way to do it is to pull the headlight out of the car. This isn't hard, but you'll have to have a T30 Torx bit to do it. There are three bolts that secure the headlight. Two are on top of the headlight - you'll see them right up there on top when you open the hood.

The third is harder to find. Look where the outer upper corner of the headlight meets the top of the fender, above the corner indicator. There is a lip on the fender that runs all the way back to the base of the windshield, where the edge of the hood sits when it's closed. There is a round hole in that lip near the headlight (just behind it). Shine a light down in there and you'll see the third Torx bolt. Take that out and you can slide the headlight assembly forward. You shouldnt' have to take it fully out of the car, just take the bolts out and move it forward.

Then remove the dust cap on the back of the headlight, pop the connector off the bulb, undo the spring clip holding the bulb, and remove it. Install the new bulb (wipe down the glass portion with your t-shirt to get any skin oils off it, as they'll burn it up quickly), and then reassemble in the reverse order.

Posted on Jan 18, 2009

jgwhomeequip
  • 1902 Answers

SOURCE: replacing headlight bulbs on a 2006 chrysler sebring

Behind the headlight you should see a eletrical wires running to the headlight section. There will be a 2 inch round plastic ring. You grap the back of the bulb and turn it to the right which will release the bulb and the socket. You pull out the bulb and replace it the same way. If this doesnt help then get back to me.

Posted on Feb 06, 2009

c17hydro
  • 2984 Answers

SOURCE: How do I change the passenger headlight bulb on my 2002 Audi A6?

Here you will see the left headlight we are going to take out, but the same procedure can be applied also to the right one (click will open a bigger photo in a new window)
audi1small.jpg

First, remove the cover circled in green (just take it, it is not fixed with screws), then, with a Torx screwdriver, remove the two screws circled in red
audi2small.jpg

Cover removed
audi3small.jpg

Under (yes, almost hidden) the cables circled in red and yellow there are two more Torx screws, you don't need to unscrew them all, only make 2 or 3 rounds
audi4small.jpg

Particular of the screws under the circles in the previous photo (sorry for the bad focus)
audi5small.jpg audi6small.jpg

Last, we have to remove the power connector. To remove it, pull the little plastic block lever circled in green and then, while holding it, pull out the whole connector (in red). After that the headlight is free, and you can take it out from the chassis
audi7small.jpg

Et voila', headlight removed :) Red circles are for the vertical offset control, don't touch them unless you know what you're doing. Lights are located under the black plastic covers
audi9small.jpg audi8small.jpg

Posted on Mar 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Audi A4 2002 Low beams & Right front turn signal stopped working


For Audi A4 the fuse box is located on the left side of dashboard behind a plastic cover (for left hand steering wheel vehicle). On inner face of the plastic cover you will find the fuse diagram.
First fuse on first row from left upper corner is Fuse Nr.20 = F20 (15A) - RH headlamp low beam, headlamp adjustment.
First fuse on second row from left upper corner is Fuse Nr.21 = F21 (15A) - LH headlamp low beam, headlamp adjustment.

Feb 15, 2010 | 2002 Audi A4

1 Answer

2004 Audi A4 headlight replacement


you have to loosen the whole headlight assembly to open the covers behind the lights to actually get to the bulbs. 4 screws, 2 are on the top of the assembly(phillips screws) the other two are hex and attach the bottom of the assembly to the car. somewhat difficult to see but look behind the assembly and down into the compartment and loosen the screws(they don't fully come out) just enough to pull the assembly out. open the black cover behind he low bean and there is the bulb

Jan 21, 2010 | 2004 Audi A4

1 Answer

How to change 2006 audi a6 headlight bulb


how to replace a 2006 audi a6 front side headlight

Jan 15, 2010 | 2006 Audi A6

1 Answer

How do i replace the sidelight bulbs on my 1999 audi a4? do i need to take the whole headlight unit off or is there a simpler way? I can get to the wires that conect to the sidelight bulb but my fingers...


You don't need to remove the whole headlight but instead the side light bulb is normally clipped to the headlight.Some are held by a small cover which you either need to rotate it or unclipped it out.Hope this helps.

Dec 15, 2009 | 1996 Audi A4

2 Answers

Audi TT Intermittent headlight


Did exactly as you said, replaced both bulbs with the d2s as you said and got them on ebay, driver side was clearly more difficult to put in, passenger side very easy, worked perfect for 1 day and the intermittent problem returned. What to do.

Aug 22, 2009 | 2005 Audi TT

1 Answer

What size bulb is an audi s4 headlight and fog light?


SYLVANIA H7 SILVERSTAR HIGH PERFORMANCE HALOGEN HEADLIGHT BULB -- 55 Watts, Single C-8 filament for use as either high beam or low beam; 100 percent legal halogen headlight bulbs; Features the whitest and brightest light colour similar to daylight for safer night driving; Meets all US FMVSS 108 and Canadian CMVSS 108 requirements. Fits Driver or Passenger Side Driver or Passenger Side Fits the following vehicle/s
2004 Audi S4 Base 8 Cyl 4.2L 2004: Base; 8 Cyl 4.2L RAMPAGE FOG LIGHT, BLACK METAL HOUSING, With round clear lens; Includes 100-Watt H3 halogen bulb, one lamp and a single bolt mounting system; Provides better illumination Fog Light

  • Fits the following vehicle/s: 2004 Audi S4 Base 8 Cyl 4.2L 2004: Base; 8 Cyl 4.2L;

Jun 24, 2009 | 2004 Audi S4

1 Answer

Driver Side turn Signal Bulb


There's one more "hidden" bolt. Above and behind the corner of the headlamp, along the top ridge of the fender, there's a hole in the fender lip. Shine a flashlight down in there and you'll see the head of the third bolt. Remove that, and the headlight assembly will slide forward so you can change the bulb.

Jan 03, 2009 | 2001 Audi A4

2 Answers

2000 Audi a4 headlight bulb replacement


The easiest way to do it is to pull the headlight out of the car. This isn't hard, but you'll have to have a T30 Torx bit to do it. There are three bolts that secure the headlight. Two are on top of the headlight - you'll see them right up there on top when you open the hood.

The third is harder to find. Look where the outer upper corner of the headlight meets the top of the fender, above the corner indicator. There is a lip on the fender that runs all the way back to the base of the windshield, where the edge of the hood sits when it's closed. There is a round hole in that lip near the headlight (just behind it). Shine a light down in there and you'll see the third Torx bolt. Take that out and you can slide the headlight assembly forward. You shouldnt' have to take it fully out of the car, just take the bolts out and move it forward.

Then remove the dust cap on the back of the headlight, pop the connector off the bulb, undo the spring clip holding the bulb, and remove it. Install the new bulb (wipe down the glass portion with your t-shirt to get any skin oils off it, as they'll burn it up quickly), and then reassemble in the reverse order.

Nov 20, 2008 | 2000 Audi A4

1 Answer

Burned out headlight/bulb bmw 1991 325i 2dr


It's a bulb replacement. If it's anything similar to my Audi, there is a cover on the back of the headlight housing that you pop off. Then you can reach in, pull the wire connector off the bulb, and unclip a metal retainer over the bulb, and pull the bulb out. Installation of the new one is the reverse. Just be SURE not to touch the glass part of the bulb. Skin oils can cause a halogen bulb to burn very hot and burn out very quickly. If you do touch the glass, wipe it gently but thoroughly on a cotton cloth to clean it off before you install it.

Oct 31, 2008 | 1991 BMW 3 Series

Not finding what you are looking for?
2007 Audi S6 Sedan Logo

Related Topics:

477 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75077 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14223 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...