Question about Daihatsu Charade

1 Answer

Change a c v joint on a 1998 daihatsu serion - Charade Daihatsu Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,016 Answers

Hi,

Would you like to know how to do this?

Let me know and I will send through the information you need.

Thanks

Jason

Posted on Aug 30, 2010

  • Jason Maurirere
    Jason Maurirere Aug 30, 2010

    Ok,

    You need to jack the side up that you need to replace the C.V. joint on, and place the car on jack stands.
    Then you need to remove the wheel,brake caliper,center axle-nut,bottom arm, and steering arm.
    Once you have done this then you can pull the whole suspension shock assembly and hub away from the axle and C.V. joint.

    Then pull the whole axle out of the gearbox, this will make the job alot easier to work on. Watch out for oil that may leak out from the gearbox when the axle is pulled out.

    Put the axle in a vice and remove the C.V. boot off the C.V you are replacing, then push from the top of the C.V and quickly pull it and it should come off, if not then persuade it with a hammer.....once you have this off then check that the circlip which is underneath is removed and you replace it with the one you should get with the New C.V..

    Grease the new C.V. with all the grease which has come with it. Put new circlip in groove on axle and then refit new C.V.

    NOTE: Make sure you line up the axle shaft grooves with the C.V. grooves before putting any pressure to fit it. Damaging the axle grooves will make the job impossible to complete.

    Assembly is reversal of removal.

    Let me know if you need more information.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you to replace a headlight bulb on Daihatsu Sirion 2007?


go to an autoparts store and ask them what bulb it takes then ask them how to change it . ,ost any more you remove them from under the hood by twisting and pulling out .

Jul 06, 2014 | 1998 Daihatsu Sirion

1 Answer

Engine vibrating


Are the transmission mounts good also? You can check them with a pry bar and stretch them to see if theyre broken or the rubber in the center is torn, or have an assistant start the vehicle and and put in gear and hold the brake and give it some throttle and observe the mounts under the hood to see if the engine has alot of movement in forward and reverse engagement. Also,check to see if idle is at factory setting.If (TPS)(throttle position sensor) is to low then it WILL also cause a vibration.

Jan 01, 2014 | Daihatsu Cars & Trucks

1 Answer

'91 daihatsu hijet 4x4 van 4 speed manual


could be worn universal joint bearing if noise coming from rear end of vechicle.

Aug 01, 2013 | Daihatsu Cars & Trucks

1 Answer

I have a 1998 daihatsu terios manual it vibrates badly in 4th and 5th gear what can it be


Check the half shafts for worn CV joints is the 1st thing. Also so you think it may be a misfire, they usually happen in higher gears when engine load is highest.

Apr 26, 2012 | 2004 Daihatsu Terios

1 Answer

Daihatsu charade '98 oil filter.


have you checked your owners manual?
better for you to goto quick lube shop and get it changed

Apr 15, 2010 | Daihatsu Charade Cars & Trucks

2 Answers

Engine


If it's a daihatsu it will have "daihatsu" printed on the valve cover. The standard 4 pot sizes are HC-E = 1295cc, HE-E = 1499cc, HD-E = 1589cc

Aug 08, 2008 | 1991 Daihatsu Charade

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daihatsu Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76132 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

Are you a Daihatsu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...