Question about 2004 Ford F250

3 Answers

No parking or taillights 2004 f250 superduty diesel 6.0

Posted by on

  • 1 more comment 
  • kazabuch Aug 30, 2010

    that did not work

  • kazabuch Aug 30, 2010

    changed front and rear bumpers and now parking and taillights don;t work all others do

  • kazabuch Aug 30, 2010

    changed out front and rear bumpers now no parking or taillights. have all other lights though

×

Ad

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,035 Answers

Hi. Check your fuse if there are blown fuse especially for the parking and taillight.

Posted on Aug 30, 2010

  • Angelito Rabago
    Angelito Rabago Aug 31, 2010

    check all electrical wirings some wire might be damaged. Check also the bulbs.

×

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 5,081 Answers

Is parking and tail light alone not working or any other lights too?

I also want to know what have you tried till now?

Did you check whether the bulb has shorted?

Posted on Aug 30, 2010

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,319 Answers

If you have no park lamps nor tail lamps the headlamp switch is at fault. It has internal shorted out contacts inside of it.. Upon receiving your replacement switch dismantle the old one. You should see carbon build up on the contacts and maybe burnt out contacts

Posted on Aug 30, 2010

  • frank thomas wilson
    frank thomas wilson Aug 30, 2010

    that was not mentioned earlier so recheck the wiring if dismantled

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is tail light fuse


Got Pulled over last night for no Taillights Diesel Forum TheDieselStop com

like that forum states, under hood or under dash & don't forget to rule out that the double filament bulbs are good (some models have one wire in that bulb as parking lights)

Mar 15, 2015 | 2002 Ford F250 Super Duty SuperCab

1 Answer

F250 no air from dash vents, works on floor and defrost


Possibly some blockage? Foam where it shouldnt be?

Nov 07, 2013 | Cars & Trucks

1 Answer

No parking or taillights f250superduty diesel 2004 6.0liter


check youre fuses in the engine compartment fuse box there is a 7.5 amp fuse that is blown .if you have a trailer check youre wires and if not then check youre tail light bulb socket,ihopenthis help you good luck

Aug 30, 2010 | 2004 Ford F250

2 Answers

Need door code


The control module for your door locks is located under your dash in the middle just below your radio. You may have to move insulation out of your way and possibly part of the carpet but it is on the firewall on the inside of the truck. Above the hump for transmission on firewall just below the radio. you can get to it by crawling under drivers side and poking your head up there! It will have a white sticker on it with your preprogrammed 5 digit code

Jan 27, 2010 | 2004 Ford F250

1 Answer

I have a 2001 F250 Superduty 7.3l Diesel. When I


I had a problem with vacuum in my F250 diesel. It had a new vacuum pump but would kick out of cruise control every time the vacuum pressure dropped. It turned out to be the vacuum reserve cannister had holes in it.

Seems you reach a tipping point and then all the vacuum systems mess up. You might want to check the reserve cannister and any vacuum servo your 4x4 might have. You can check most of the vacuum stuff with the engine OFF using a vacuum pump. You could have a leaking vacuum pot operating the ductwork. Check your diesel vacuum pump for output and loose belts.

Jan 07, 2010 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

I have a 2000 Ford F250 Superduty Diesel. When I


Have you looked at your anti lock braking system. It will give a pulsation when it is in use. You may have a problem with it and it is coming on prematurely. Listen when your truck is doing this and you should hear the humming of the antilock system if it is on. Otherwise i would ckeck your ball joints and tie rod ends for wear as this can cause a vibration back thru your braking system as well

Jan 04, 2010 | 2000 Ford F350 Super Duty Super Cab

1 Answer

Change the ICP on 2005 F250 6.0 superduty


remove the rh valve cover, unscrew the sensor, replace the valve cover.

May 28, 2009 | 2004 Ford F250

1 Answer

2004 F250 A/C hot only when idling


check to see if coolant fans is working. they have run to cool down the 134 refrigerant in condenser.back down to liquid state .so it can run the cycle again.

Apr 23, 2009 | 2004 Ford F150

1 Answer

2004 Ford F250 Superduty Truck Steering problems


I have had this same problem after thorough checking it ended up being a bad steering box. after replacing the box it was fine

Oct 20, 2008 | 2004 Ford F250

Not finding what you are looking for?
2004 Ford F250 Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...