Question about 1997 Nissan Pathfinder

1 Answer

Rear door of 1997 QX4 will not open. The handles move but will not operate the door latches

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 137 Answers

The door latch cable sounds broke or the the door lock spring has popped, try open the door from the inside by removing the panel and pulling the cable. hope this helps ( rate me thanks )

Posted on Aug 30, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you remove the rear door panels on 1997 pathfinder


remove the trim around your interior door handle then pull on the metal rod that is connected to the handle, and the door should open

Feb 20, 2014 | Nissan Pathfinder Cars & Trucks

1 Answer

Can´t open the rear tail gate/door. Have tried the emergency opening option (holding down the 2 lock buttons in the car) but that didn´t work either. When pressing the rear door "handle" to open...


If you squeese the handle put your head near the badge you should hear one micro switch operating the window and a noise like well hard to explain but its a solenoid operating the rear latch after the window drops, you can get the inside panel off bit hard with door locked; at bottom of door panel is four philips screws take them out and then the panel pulls from the bottom up,cut round water shredder and you can operate latch manually to get it open then check to see if micro switch in handle is working its not a rear wiper fault or window fault as they work, the relay for the rear door latch and the rear window are behind the offside rear quarter panel 3 connectors for rear door electrics, the relays are up by the seat at top,its not normally a relay issue either rear door latch solenoid or micro switch in back handle but rule out the handle as window works.

Disconect battery and wait 5 min and try again it worked on mine.

Hope helps.

Oct 15, 2010 | Land Rover Discovery Cars & Trucks

1 Answer

What is he best way to fix the latch/handle on the rear hatch door? The handle operates (moves), but the latch does not release.


The screws securing the latch mechanism may have come loose. I had this problem. I had to remove all the screws from the rear hatch panel, within the luggage compartment. I pulled the panel away from the bottom of the window, bent it slightly, enough to get my arm in there to reach down to pull on the lever that releases the latch. grab a flashlight and a partner. have your partner turn the key to "open" and pull on the rear door handle. with the flashlight you will be able to see or feel the rod moving. pull up on this rod. After you get the door open spray some lube on the lock mechanism and adjust as needed. The rod that you pulled on can be adjusted

Oct 02, 2010 | 1996 Jeep Grand Cherokee

1 Answer

The rear door will not stay closed. When I operate the latch mechanism in the door manually (move it to the closed position) I can move it back open without pulling on the door handle. The other side...


My 2005 Equinox just had the same problem on the rear passanger door. My husband took a heat gun to the latch about 10 minutes ago, and now the door latches.

Dec 26, 2009 | Chevrolet Equinox Cars & Trucks

3 Answers

ELECTRIC DOOR LOCKS ONLY LOCK SOME TIMES


if you hit the lock button a couple times, will it finally lock?

If so, then you will need to take door cover off and lube up the connectors as they probably got corroded.

Aug 14, 2009 | 2000 Ford F350 Super Duty Super Cab

2 Answers

1997 F150 Pickup door wont open


I believe there is a cable which connects the handle to the latch, they are pron to breaking.

Jun 21, 2009 | 1997 Ford F150 Regular Cab

1 Answer

96 Bravada, tailgate and rear glass won't open


its a linkage problem . you need to remove the door panel to repair

Jun 12, 2009 | 1997 Oldsmobile Bravada

1 Answer

When i try to open the door it wont move the bottom latch releases but the top wont and i cna get to it to try to remove it


Section 501-14A: Handles, Locks, Latches and Mechanisms 1997 F-150, F-250 Workshop Manual REMOVAL AND INSTALLATION Latch, Rear Door — Upper Removal
  1. Remove the rear door trim panel; refer to Section 501-05 .
  1. Remove the rear door radio speaker.
    1. Remove the four radio speaker screws.
    1. Disconnect the electrical connector.
    1. Remove the rear door radio speaker.
  1. Carefully peel off the rear door watershield.
  1. Disconnect the upper rear door latch cable.
    1. Lift the clip.
    1. Pull to release the cable from its seated position.
d07f7d7.gif
  1. Remove the upper rear door latch.
    1. Remove the three screws.
    1. Pull the upper rear door latch and the cable up through the door latch opening.
b223e87.gif

Apr 14, 2009 | 1997 Ford F150 Regular Cab

1 Answer

Rear door on driver side won't open,have taken the panel off the inside of car,seems like the lock won,t travelas far as it does on the other door.is there any way to open this door,thanks[1997 lincoln...


Rear
Removal
  1. Using a small screwdriver, remove the screw cover from the armrest of rear door trim panel (27406).
  1. Remove the two retaining screws.
  1. Using Trim Pad Removing Tool from Rotunda Windshield and Moulding/Trim Removal Kit 107-R0401 or equivalent, pry rear door trim panel from door inner panel.
  1. Disconnect electrical connectors.
Installation
  1. Position rear door trim panel on door inner panel, aligning two locators on rear door trim panel. Reverse Removal procedure.
------------------------------------------------------------------------------------ Rear
Removal
  1. Remove door trim panel and watershield. Refer to Section 01-05 .
  1. Check all connections of remote control links and cables. Service as necessary.
  1. Remove remote control assembly.
  1. Remove door latch remote control assembly from latch assembly.
  1. Drill out rivet at bellcrank and link (264B14).
  1. Remove three screws attaching latch assembly to door.
  1. Drill out rivet that attaches actuator motor to door.
  1. Remove latch assembly with actuator motor and door latch control rod lever link assembly.
Installation
  1. Install new bushings and clip onto latch assembly.
  1. Install latch with links and power lock actuator into door cavity.
  1. Position latch assembly to door, aligning screw holes in latch and door. Install three screws. Tighten to 10-13 Nm (89-115 lb-in).
  1. Attach door latch actuator motor to door with a new rivet.
  1. Install bellcrank and link to door using a new rivet.
  1. Install inside door handle and remote control assembly to door.
  1. Open and close door to check latch assembly operation.
  1. Install watershield and door trim panel. Refer to Section 01-05 .
ee8a11f.gif
Item Part Number Description 1 221A00 Door Handle to Door Latch Actuating Cable 2 26446 Rear Door Control Rod Retainer 3 377901 Plug Button 4 26412 Rear Door Latch 5 W623451-S2 Push Nut 6 224A32 Counter Balance 7 22450 Door Outside Handle Tension Spring 8 W701210-S309 Screw 9 224A20 Outside Door Handle Anti Rattle Pivot (2 Req'd) 10 22404 Door Handle 11 224A24 Front Door Outside Handle Spacer (2 Req'd) 12 264A64 Rear Door Actuating Rod 13 22408 Outside Door Handle Anti-Rattle Bumper 14 22428 Outside Door Handle Large Pad 15 N621906-S2 Nut (2 Req'd) 16 N807329 Screw (3 Req'd) 17 26595 Rear Door Electric Latch Actuator (RH) 18 W701566-S47 Rivet 19 431C04-A Rear Door Latch Striker Assembly 20 — Door Lock Striker Plate (Part of Door Shell Assy) 21 W525172-S Rivet (2 Req'd) 22 264B14 Bellcrank and Link (RH) 23 264A50 Bushing 24 N802034-SG Rivet 25 26420 Rear Door Latch Control Rod Link 26 W525172-S Rivet (2 Req'd) 27 21818 RR Door Latch (Inside) 28 A26460 RR Door Latch Push Button Rod 29 21982 Door Latch Rear Striker Assembly 30 N808377-S101 Screw (2 Req'd) 31 250A04 Rear Door Catch 32 N801010-S100 Truss Head Bolt (2 Req'd) 33 N804234-S2 Screw 34 266A74 Rear Door Latch Actuator Retainer 35 24630 Rear Door 36 26552 Rear Door Latch Control Escutcheon A — Tighten to 21-29 Nm (16-21 Lb-Ft) B — Tighten to 10-13 Nm (89-115 Lb-In) C — Tighten to 7-8 Nm (62-70 Lb-In) D — Tighten to 26-34 Nm (20-25 Lb-Ft) E — Tighten to 3-4 Nm (27-35 Lb-In)

Mar 24, 2009 | 1997 Lincoln Continental

1 Answer

Door lock


When the actuator moves the latch up, it connects the outside door handle to the opening mechanism. When the latch is down, the outside door handle is disconnected from the mechanism so that it cannot be opened. So in this case your latch needs to be replaced, the latch or one of its parts is malfunctioning. the outside handle is never beening disconnected from the latch. remove the door panel visually inspect for damage, and take the proper repair

Jul 12, 2008 | 1997 Oldsmobile Cutlass Supreme

Not finding what you are looking for?
1997 Nissan Pathfinder Logo

282 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...