Question about 2001 Chevrolet Silverado

Open Question

01 duramax Ive changed thermastats, clutch fan, water pump tested for pressure build up put runs about 190 perfect but pulling anything as soon as I start getting any weight on itmost red lines HELP

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2005 s10 fan clutch

autozone has a simple diagram but it serves your purpose
d404b2b.jpg

Posted on Aug 24, 2008

  • 99 Answers

SOURCE: 1999 chevy blazer fuel problem

probably not fuel filter . probably going to have to remove the upper intake and replace the fuel injector spider(fuel inj assebly) if it is droping fuel pressure it is leaking into the upper manifold

Posted on Nov 30, 2008

  • 15478 Answers

SOURCE: Tempature Question. Have a 2003

There are a couple of things to cosider. One is that the temp gauge that is on the car is only a close estimate and not exact. The ranges that you are saying the engine is in are fine. To troubleshoot this issue if it is really bothering you. You need to get a diagnostic reading of the temp. Then you can see what the exact temp is. Then you need to check and see if the coolant is the right mixture. Check the radiator for obstructions internally and check the hoses for soft spots that inicate a collapse issue when they are hot and last but not least would be the water pump to see if it has worn impellers. The PCM will set an error code if there is a high or low temp issue that will impact emissions. So unless you are having driveability issues I would not worry about it,

Posted on Jan 29, 2011

TDISLine
  • 1874 Answers

SOURCE: My 2005 duramax is building up alot of pressure in

The root cause of the engine overheating was the closed stuck thermostat.
Unfortunately the cylinder head gasket was cracked, and as a result the air pressure from cylinders pass inside cooling system pushing the coolant out.
You need to remove the cylinder head and replace the gasket. Also check the cylinder head surface flatness before reinstallation. New cylinder head bolts required.

Posted on Feb 06, 2011

  • 1 Answer

SOURCE: 2500 hd duramax crew cab 4 WD pulls right. Both

Can be the ABS system causing this problem...had a similar experience with my 03 siverado 2500 hd diesel.

Posted on Apr 11, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I stop my 01 explorer from 0ver heating. I already replaced water pump thermostat and radiator


Since you have done the basics, more information is needed. Under what conditions does it overheat, and how severely? Only when at idle for several minutes? Could be bad fan clutch or missing/damaged fan shroud. Severely overheats so bad you can't drive it at all? Blown head gasket? You can often diagnosis this by running with radiator cap removed and see bubbles in the radiator, or also look for water in oil, or oil in the coolant. Also, check with parts store. I think certain years of these run a reverse direction water pump, and if you get the wrong one they will overheat badly.

Dec 12, 2014 | Ford Explorer Cars & Trucks

2 Answers

Replaced the whole fan, motor and all on my 2002 mustang gt and now it doesn't come on and water is blowing out of the radiator while the cap is off like its building pressure... What is wrong


It sounds like you have a blown head gasket or a crack in the head, these are the main reason pressure builds up in the radiator. Also check your Thermastat it could be jammed shut

Jul 19, 2013 | Cars & Trucks

1 Answer

1990 mbz 1903 2.6 stop while driving after 5 minutes


engine could have faulty clutch fan causing engine overheat or fuel pump going bad,soon as car stall out check fuel pressure with engine off.if you have 80 to 90 psi with new fuel filter fuel pump okay.if you have zero fuel pressure fuel pump not pumping any fuel.

Sep 21, 2012 | 1985 Mercedes-Benz 190

1 Answer

Hello im wondering why my truck keeps over heating after iv changed the thermastat 4 times and temp sensor im i also had the intake gaskit changed right befor this started i was pulling out out of the...


CLUTCH ON COOLING FAN FREEWHEELING. COOLING FAN SHOULD HAVE RESISTANCE WHEN TURN WITH HAND WHEN ENGINE HOT.IF NOT FAN FREE WHEEL FAN CLUTCH NEEDS TO BE REPLACED.IF COOLING FAN OKAY.YOU COULD HAVE BLOWN HEAD GASKET.YOUR RADIATOR AND ENGINE BLOCK NEED FLUSHING OUT.CHECK WATER PUMP FOR LEAKING WEEP HOLE IF LEAKING REPLACE WATER PUMP.

Nov 12, 2010 | 1991 GMC K1500

1 Answer

Change water pump 6.6 ltr duramax


not too bad of a job, pull the fan and dampner. ive heard of guys saying they can do it without pulling the dampner (i dont know how?) it doesnt take long to get it off. dont put a cheap w/p back in, if the shaft seal goes out you will have alot of coolant in the oil.

Oct 05, 2010 | 2006 GMC Sierra 2500HD 2WD

1 Answer

2000 dodge durango cooling issue: I HAVE THE 5.2L 2WD. I have replaced the water pump, thermostat 3 times, hoses, fan clutch. To begin with ive had it tested at three places no one can figure out why...


Ihave a 2000 Dodge Durango i have put a new radiator and the gaskets came back good um i replaced the coolen fan also the thermostate and tested it it it came back good when i run it its fine but when i am in line its hot when i drive it cools down........

Aug 18, 2010 | 2000 Dodge Durango

2 Answers

How to locate and replace water pump on 2006 chevy trailblazer


The water pump is usually mounted center, Front of the engine and is run by a belt. Look for the location the water lines connect to that has a pulley attached.

Jul 11, 2010 | 2006 Chevrolet Trailblazer Ext

2 Answers

How do I change the water pump on a 2004 chevy trailblazer 4.2L?


dont change a water pump unless it is leaking from the pump itself. if your vehicle is overheating check the simple items first. a water pump very rarely goes bad.

Apr 12, 2010 | 2004 Chevrolet TrailBlazer

2 Answers

Need to replaCE WATER PUMP 2002 GMC DURAMAX DIESEL how hard?


cardenderek,
This info is totally bogus.You obviousely have never changed a water pump on a 6.6 liter Duramax Diesel engine.1st off it isnt belt driven it is gear driven from the drive train inside the engine.You have to remove the fan shroud,clutch fan assem.,and harmonic balancer as one of the mounting bolts is behind the balancer.Also remove the left side inner fender for easier access.

catD8RII

Mar 12, 2010 | 2002 Chevrolet Silverado 2500HD

2 Answers

Cooling system


these are somethings that maybe causing it to over heat (1) not enough cooling in it.(2) water pump drivebelt (3) Radiator core blocked (4) Bad thermostat (5) fan blades broken or cracked (6)Radiator cap need to be replace (7) Ignition timing incorrect if all fails stop by your local library and get your hands on a Haynes auto repair Manual for your car wish you the best of luck Michigan Man

Dec 09, 2009 | 1995 Mercury Cougar

Not finding what you are looking for?
2001 Chevrolet Silverado Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...