Question about Hummer H3

2 Answers

My abs light comes on my traction control light comes on my air bag light comes on then they will go off the engine light has never come on then when it sets for a few hrs it want start no power at all. Then when u jump it off the h3 2006 will run fine and then lights come on again then go off and as long as u don't let it set for a long time it will start fine. I had the battery checked it was fine it was putting out 12.7 volts

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Hummer Master
  • 14,338 Answers

Go to Autozone,have them test your battery and alternator,it's free and only takes a few minutes,also check your battery cables to see if they are good and tight and clean.Pamela is right about the battery specs.

Posted on Jul 08, 2017

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Hummer Master
  • 1,830 Answers

When engine is running the battery should putout 13.7 - 14.7.

Posted on Jul 08, 2017

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

GM Elec
  • 1000 Answers

SOURCE: Traction control

Lvan....Have you had the codes pulled for the ABS failure? I would not be supprised if you have a wheel speed sensor failure.
Check with your local Auto Zone or other after market part store, they will pull codes for you for free in most cases.
Let me know.
Regards,

Posted on Feb 10, 2009

ewashmidas
  • 362 Answers

SOURCE: 2000 Chev Cavalier, warning lights are coming on

Your vehicle’s computer system has self-testing capability. When the computer senses that there is a problem with some of the components it stores the correspondent trouble code(s) in its memory and lights up the Check Engine, Service Engine Soon, ABS Or TC lights to tell you that there is a problem and you should have the car diagnosed and repaired. The number of codes that can turn the light on number in the hundreds. I would take it to a service center you trust and let then come up with a solution. Sometimes a problem in one system will turn light on for other systems that communicate with it, but it doesn't mean there is a problem in all of the systems.

Posted on Mar 14, 2009

mecanica03
  • 881 Answers

SOURCE: Solution for

maybe any of wheel sensor are clogged , clean each one ,and disconnect the negative battery terminal few minutes

Posted on Apr 24, 2009

SOURCE: abs warning light on traction control fault

Check for short in the electrical system as that is what is causing the Drain , then check if the Generator is working properly

Posted on Aug 13, 2009

  • 1 Answer

SOURCE: abs light/traction control light

You can check out what the trouble code is by pushing and holding the information button and the up arrow (right side of instrument cluster above the radio) until all the instrument clusters light. Press the information button (last) to enter test mode. I've had an error C1234, meaning Left rear wheel sensor fault. I found the problem to be a corroded connector under the chasis just under the rear left door about 2 feet in. I had to by-pass (replace 1 wire due to corrosion at the connector.

Posted on Sep 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The anti lock brake, air bag, service engine, and traction control warning light are all lit up in my 2003 Bonneville. Is the body control module causing this?


Hook it up to a scanner that reads both OBD2 and ABS and read the codes. I had problems with GM vehicles and it was usually the ABS or another harness that was actually the problem.

Jan 15, 2015 | Cars & Trucks

1 Answer

At times the following lights come on but after for a short time, I restart the car and they go off. ABS, 4WD, ESP BAG, and Traction Control. Whats happening?


posible tou have a problem on the abs system need to scann the car right after the lights came on but dont turn the engine of because when you turn the engine of tha abs system dont have memort for the code and gets errase

Sep 22, 2014 | 2008 Jeep Patriot

1 Answer

Air bag light stays on


Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module

Oct 22, 2012 | Peugeot Cars & Trucks

2 Answers

ABS/ Traction control light/BAS & brake light on in 2008 dodge grand caravan


It is safe to drive. You need a scan tool to get a code out of it. Could be as simple as a wheel speed sensor going bad. All of these lights will work together normally. The traction control uses the ABS to gain traction, and the Brake Assist System is part of the stability control. Also uses the ABS.

Oct 03, 2012 | 2008 Dodge Grand Caravan

2 Answers

Vcs light and traction of light on


For this VCS and traction lights coming ON,its advisable to check/click this help links :----
VCS maintenance required ? http://howtobyme.blogspot.com/2011/11/vcs-maintaince-required-on-toyota-camry.html------- VCS and ABS lights go on and off intermittently? http://howtobyme.blogspot.com/2011/11/vcs-and-abs-lights-go-on-and-off.html
--------Traction control message? http://schematicsdiagram.blogspot.com/2012/01/traction-control-message.html
---------The ABS and Traction Control Lights stays ON dash of car? http://schematicsdiagram.blogspot.com/2011/06/abs-and-traction-control-lights-stays.html
----------This will help.Thanks.

Feb 09, 2012 | 2006 Toyota Highlander

3 Answers

Traction control and anti-locks(ABS) lights come on.


Traction control and anti-locks(ABS) lights come on there is sensors that are pluged in behind the rotors check and see if they are disconected or loose sometimes when you change your brake pads they might come loose and not making contact.

Jul 06, 2010 | 1998 Cadillac DeVille

1 Answer

I have an o7 five hundred the speedometer goes to zero and the tack shows two dotted lines as well as the air bag lght comes on and the check engine light and the abs and the wrench and traction control.


This is a sign of a failing instrument cluster. you need to have a dealer use the IDS tool to perform a scan reading prior to repair to see if any other systems are causing this.

Mar 16, 2010 | 2007 Ford Five Hundred Limited Sedan

2 Answers

Abs light, trac light, service engine soon light 2001 Pontiac Grand Am


Sounds like you have a bad wheel speed sensor. You need to have it scanned. Since it's been sitting, it might just be a bad connection to one of the speed sensors.

Jun 01, 2009 | 2000 Pontiac Grand Am GT

1 Answer

2001 olds ABS and traction control sensor issue


An ABS sensor DOES affect the traction control system. Traction control uses these sensors to determine if a wheel is losing traction. A bad sensor will cause both the ABS and TRACTION lights to come on.
The CHECK ENGINE light however is going to be a seperate problem.

Jun 08, 2008 | 1999 Mazda Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hummer Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8211 Answers

Are you a Hummer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...