Question about 1987 Ford Tempo

1 Answer

1987 ford temp automatic - will start when engine is cold, run until it warms up, approximately 5-10 minutes, then just shuts off.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 5,763 Answers

This sounds like a bad control module, this controls the spark and timing, this is common, the engine runs until module gets hot then engine dies, try replacing the module, another thing is to remove the module and take to a napa auto parts store they will test i for you, make sure they test it a few times to get it hot. hope this helps.

Posted on Aug 30, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1985 Ford Ranger 2.3 starts and idles good. But when put in gear dies until it reaches full temp.


Hmm...........
1985..........
Probably carb? Automatic choke not working? Remove air filter and spray carb with cleaner, Make sure all parts move freely. With engine cold, check automatic choke position. Start and check function as it warms up.

Feb 21, 2016 | Ford Cars & Trucks

1 Answer

P2285 code 6.0 litre ford deisel long cranking before starting after starts runs great but oil pressure gauge drops at idle


bad bearings on crank or worn oil pump. Pressure will be up when cold, but will drop when engine warms up. Check for knock in lower end. If so, bad crank bearings.

Jan 16, 2013 | 2004 Ford Super Duty F 550

1 Answer

Does the 2002 regal have a cold motor sensor Car hard to start when cold motor (in the morning )


Your vehicle uses the coolant temp sensor and the intake air temp sensor to determine the engines temperature on a cold start. If one of them is dramatically different than the other it will flag a code.

Is the check engine light on?

When was the last time you had a tune-up? if recently what brand of plugs where used?

Have you noticed any hard start issues after a hot soak? A hot soak would be driving the car until fully warmed up, shutting of the engine for approximately 15 to 20 minutes, and then starting the engine again.

Oct 27, 2010 | 2002 Buick Regal

1 Answer

2.0d x-type 2005 Est. Starting problems when engine is warm


Ok, time for car school. The vehicle is operated by the computer, every electrical concept that is. When the engine is cold, it starts fine because the computer has placed it in "cold start mode", putting more fuel into the engine than normally would until Once the engine is warmed up, a temperature sending unit or temp sensor tells the computer to change to normal run mode. IF said temp sensor is faulty and is not telling the computer to make said change, it stays in cold start mode, still dumping excess fuel in the engine that is now not required, cause it's warmed up. Like keeping the choke closed on older vehicles. Now I think you can answer your own question, when this no start action is happening after warm up and it always starts fine when cold, what's the first thing you check ? Right, the unsuspected temp sensor. Change that and no more start problem. Have a wonderful day. Glad I could be of service.

Jul 11, 2017 | 2005 Jaguar X-Type

1 Answer

Cold starts ok warms up shakes and stalls


check engine coolant temperature when it gets warmer, or at operating temperature, and verify that the temperature gauge is showing warmed up to operating temperature. If the coolant temperature sensor tells the computer the engine is cold it will over fuel and miss and the engine will die. When cooled down it will run fine until it warms up. Also could be coil if it starts missing after warmed up.

Aug 18, 2009 | 1990 Ford Bronco II

1 Answer

87 Ford Taurus 3L engine shut down when warm - will not restart


after it has shut down check for gas at the fuel rail with the key on their should be gas squirting out constantly it sounds like the fuel pump is going out

Jul 28, 2009 | 1987 Ford Taurus

1 Answer

I have a 1999 Ford F450 super duty diesel. It


Replace the glowplug relay.Its faulty.The glow plugs stay on until engine warms up.The engine temp switch then activates the relay to switch off.So it could be the temp switch also faulty.

Jul 17, 2009 | 1999 Ford Super Duty F 450

1 Answer

Intermitant temperature


Check to make sure your thermostat works right by monitoring the warming up of your engine. With a completely cold engine, start and run the engine for a few minutes, then put your hand on the top radiator hose to monitor if and when it gets warm as the thermostat opens more and more and note the gauge reading( if it works) the top radiator hose should be unbearably hot within 5-8 minutes. If the therm. opens right it should close right aswell, staying open a little while eventhough the radiator may have cooled may be what you are experiencing causing the rapid cooling and is nothing to worry about. The Hose should not get warm very soon after starting the engine. Regarding you gauge, lets take one step at a time, verify proper op. or the therm.

Jan 20, 2009 | 1986 Toyota 4Runner

1 Answer

Start and shut off after about 2 to 3 minutes. then wouldnt start until engine cool down. 1997 town & country


Check your coolant temp sensor. It is thinking that the engine is cold when it is actually warm or warming up and is probably not giving the correct air to fuel ratio.

Aug 13, 2008 | 1997 Chrysler Town & Country

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

184 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...