Question about 1997 GMC Sonoma

Open Question

Need brake line diagram to rear brakes. Have a leak in line, there are two lines? What is the second line? It's in an area where I can't see which is leaking????

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

moparownr
  • 667 Answers

SOURCE: 1989 gmc runs rough dies at random times

check the line coming from the MAP sensor it is about 1/4" rubber line it plugs into the base of the throttle body at the bottom in the back

Posted on Mar 20, 2009

dennymulford
  • 1055 Answers

SOURCE: 1998 GMC Sierra (C1500) 5.0L 305 V8-right rear brake line

i dont know of any recall for that
and yes it can be replaced without removing the bedeasy wasy too do it is go too auto zone and buy a roll of brake line and run it along side of the old one and just leave the old one in the hangers and use tie straps too hang the new one!!!

Posted on Apr 20, 2009

  • 1118 Answers

SOURCE: need to replace brake line from rear axle forward

Chanses are it broke behind the gas tank wear it runs along the frame rail. You don't need a diagram to fix that, just unhook it at both ends and break it off or cut it off buy the tank and take the pieces with you to a auto parts store and they will match it up with new line, just take a tape measure and measure from the rear axel to the front block or perportioning valve, and don't worry about the piece behind the tank, just run the new line alongside the old one behind the tank unless you want to pull the tank out.

Posted on Sep 06, 2009

michigan man
  • 3533 Answers

SOURCE: Need to see diagram on where brake line is located

give these websites a try www.alldatadiy.com and www.autozone.com if all fails stop by your local GM dealership in the parts department and they be able to print you off the pictures and diagrams you will need wish you the best of luck Michigan Man.

Posted on Mar 22, 2010

Testimonial: "Thanks Michigan Man I will follow your advice"

csmock132
  • 4669 Answers

SOURCE: Where to find diagram to install whole rear brake lines

I don't know about a diagram. Just buy some 1/4 inch brake line and run it as close to the original as you can.

Posted on Apr 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2003 PT Cruiser -Brake fluid is leaking on rear passenger tire where the brake line connects to the brake mechanism. Is it likely loose and just needs to be tightened up or should I replace the line?


-Put it in part position.
-Turn off the engine.
-Craw under neat where you can see the leaking area.
-Wear a safety glasses or goggle.
-Ask some one to help to press the brake pedal for you
and watch where is the fluid come from.
-If from the connector then tight it more. (Not too tight).
and try press brake pedal again. If there is no more leak
then you're good.
-But if it leak from the pipe instead at the connector then the pipe line might broke. Need new line.

Good luck

Mai

Feb 14, 2017 | Chrysler PT Cruiser Cars & Trucks

2 Answers

2001 Dodge van 3500 losing brake fluid but can't tell where


Most likely you have a cylinder in the rear leaking, and it's just slinging it off as you go. Your van should have front disc brakes and rear drum. Cylinders are normally $10 to $20 each. Wouldn't hurt to inspect both

Feb 18, 2015 | Dodge Cars & Trucks

1 Answer

Repair leak in rear brake line.


You CANNOT repair a leaky line, I'm afraid. You will need to replace the leaky section. Don;t forget to bleed the brakes afterwards.

Nov 14, 2011 | 1996 Ford Contour

1 Answer

My brakes are leaking in the rear driver side need a diagram of brake lines to folllow.


Follow the brake line starting at the left rear wheel, there is no diagram for brake lines, take the tire off and inspect (look) left rear wheel, It will be wet where the leak is, if the inside of the tire is wet then you might want to check the brake cylinder, behind the brake drum. You might want to take it to a shop and get it fixed, It is your life and others, if you can't stop.

Aug 05, 2011 | Ford Taurus Cars & Trucks

4 Answers

My 2001 neon's brake light just came on yesterday and will not go off. The brake pedal also goes almost completely to the floor, have to leave a lot of room to stop. Prior to the light coming on, I...


Check the fluid level in the brake resivior. It sounds like you have a leak. Check all the brakes and look for ruptured lines or a leaking caliper. If no leaks at the wheels and along the brake lines the issue would be the master cylinder or hydo boost unit.

Mar 05, 2011 | 2001 Plymouth Neon

2 Answers

Diagram of the brake system. my brake system is leaking in the rear back end of the car, on the block that runs the lines to the different rear braks. I need to know the name of the block so I can replace...


It's a rear brake tee. Nothing but drilled brass. Might want to try checking the threads and flares on the brake lines that go into the tee. It's not often they crack and leak so inspect well. Let me know.

Jul 24, 2010 | 1996 Geo Tracker 2 Door

2 Answers

Leaking brake fluid from rear driver side brake lines,need a diagram of how to replace the lines. 1994 ford taurus 3.o v6.thanks


They don't make diagrams for brake lines. The lines are sold in bulk. You need to measure and duplicate the bends in the orignal lines and cut/flare the lines yourself. You will need a tubing cutter, flare tool and tubing bender.

Feb 27, 2010 | 1994 Ford Taurus

1 Answer

Brake line diagram


Brake Lines and Hoses
Double-walled steel line is used in the hydraulic lines between the brake master cylinder and the front tube connector, and between the brake master cylinder and the flexible brake hose at the rear wheels.
Double-flared brake lines provide good leak-proof connections.
When replacing hydraulic brake lines, hoses, or connectors, tighten all connections securely. After replacement, bleed the brake system; refer to Section 206-00 .
The wet appearance of the outer cover of the rubber brake hose is referred to as "sweating." This is a normal condition for neoprene rayon braid hose and is not a sign of leakage or cause for replacement of the hose.

Hydraulic Brake System Components — Non-ABS

dff7165.gif
Item Part Number Description 1 2005 Power Brake Booster 2 2455 Brake Pedal 3 2261 Rear Wheel Cylinder 4 2552 Rear Disc Brake Caliper— (Mexico Only) 5 2B120 Disc Brake Caliper—, Front 6 2B091 Brake Pressure Control Valves 7 2140 Brake Master Cylinder

May 02, 2009 | 1998 Mercury Tracer

3 Answers

Rear wheel mazda 323 m reg


Sounds like you have a leak in the brake system. The fluid you are seeing is brake fluid.

You need to get this fixed asap.

Apr 05, 2009 | 1991 Mazda 323

Not finding what you are looking for?
1997 GMC Sonoma Logo

Related Topics:

173 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...