Question about 1996 Jeep Cherokee

1 Answer

Jeep run great but at times will up and quitt for no reason while driving and then is hard to start back. this can happen at any time. replaced fuel pump, throddle possession sensor, and coil, and a new battery still same problem

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 77 Answers

Depends on engine if its a 4.0L may be the crank sensor located in the top of the transmission bell housing sensor reads of the teeth on the flexplate(flywheel)

Posted on Aug 29, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1994 wrangler.must crank starter multipul times for fuel to reach fuel rail on 2.4 or 2.5 4 cyl.Once finally starts will run great all day and start.Next day starts hard again.I replaced fuel


replace the fuel pump,the check valve that holds pressure on the fuel is in the fuel pump.The fuel in the lines is draining back into the tank

Dec 10, 2017 | 1994 Jeep Wrangler

1 Answer

I own a 1990 YJ Jeep 4.2 If I drive the Jeep every day it starts and runs great. If the car sits for several days it is extermly hard to start If I use a small amount of starting fluid, it will fire...


Sounds like the fuel pressure regulator. Its not holding the pressure over a period of time. Making it difficult to start after its been sitting.

Jul 03, 2011 | 1990 Jeep Wrangler

2 Answers

1996 Jeep Country Wagon. Replaced fuel filter and


does your jeep run rough? idle is real low? and when you are driving and push the gas hard it doesnt want to move? if so it is most likely the mass air flow sensor. i had to replace that 2 or 3 times on my 1999 jeep cherokee

Jun 22, 2009 | 1996 Jeep Cherokee Country

1 Answer

96 Jeep Cherokee stall then hard/no start


change fule filter if nothing changes do fule pressure test

Feb 11, 2009 | 1996 Jeep Cherokee Country

1 Answer

1999 Jeep Grand Cherokee stalling and not starting


Since you've replaced many of the usual suspects (fuel pump etc.) you might want to look into testing or simply replacing the crankshaft position sensor or the camshaft position sensor. If you intermittently lose one the these signals it would cause the problem you describe.

Feb 05, 2009 | 1999 Jeep Grand Cherokee

4 Answers

Car dies at random moments


But, you did not change the crank sensor (on the drivers side of the bellhousing, just where it's a real pain to get to)

Jan 12, 2009 | 1996 Jeep Grand Cherokee

1 Answer

Hard starting


try cycling the key on and off 5-6 times before cranking. let me know what happens

Dec 09, 2008 | 1999 Jeep Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

78936 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...