Question about 1992 Honda Accord

1 Answer

Starting problems. turns over but no fire up. already had plugs, wires, cap and rotor replaced. Fuel pump or filter?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 3,074 Answers

Spray wd40 in the intake if it acts like it gonna start then yes fuel pump/filter

Posted on Aug 29, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Truck stop while driving on hwy. replaced fuel pump, fuel filter, wires plugs cap rotor but still no start


Have your ignition module checked, my car would start and drive and would go dead after a few miles and would not start until it cooled down, turned out to be the ignition module that eventually went bad and would not start at all.

Mar 30, 2015 | 2000 Chevrolet Silverado 1500

1 Answer

No fuel and no spark


fuel pump , fuel pump relay on fire wall, fuel filter, may all need replaced, pump in tank, inspect all wiring in this circuit, especially all grounds,, grounds get overlooked & that is sometimes the problem. I have a 1988 gmc 2500, I 'm talking from experience. can you hear if fuel pump runs for 2 seconds, when you turn key on ? if not, ground problem or pump problem. relay has a fuse in it, check that. check all fuses. NOW, spark ! coil ? plug wires ? distributor cap & rotor ? replace them if you haven't !!!!!!!!!! get to work, see how you do ! good luck !

Mar 05, 2013 | 1989 GMC K1500

2 Answers

94 chevy 1500 4.3 no spark no fuel


Sounds like you replaced alot of parts for nothing.
The pickup coil in the distributor "fires" the module which grounds the coil and the injectors.
Those components would need to be tested. The coil fires the plugs when the ground is removed by the module or the key switch.

Jan 08, 2013 | GMC C1500 Cars & Trucks

1 Answer

Chevrolet blazer starting problems


Check for spark. Likely causes are fuel pump, fuel filter, bad cap rotor, fouled plugs. I would start with new fuel filter and cap rotor. Totaly cost about 25 bucks. The fuel filter is on the driver's side frame rail. About middle of vehicle. Usalluy rusted and I think the wrenches are 7/8 and 13/16. This take patience cause it is in a tight area and you only get to turn the filter 1/8 turn the turn the wrench and turn again. Repeat

Nov 10, 2011 | 1997 Chevrolet Blazer

1 Answer

Have replaced the starter solenoid, spark plugs, plug wires, fuel filter, air filter, water pump and battery all within the last two months. When the truck gets hot it will not crank. Has electrical power,...


If you haven't already done so, replace the distributor cap and rotor. There is most likely corrosion inside the cap that is causing a crossfire condition.

This is a common problem on that engine.

Don't know why being hot would aggravate it, but start with the cap.

Jun 14, 2011 | 1990 Chevrolet Suburban

1 Answer

Replaced bad fuel pump, installed new relay and fuel filter, engine turns over but is not firing on..... positive the fuel pump is pumping gas and checked to see if gas was going thru fuel filter. Tried...


Hi, Ok you have confirmed that it's not a fuel problem. You need to check for spark. Pull the coil wire off of the coil(secondary lead-looks like a spark plug wire) Have some one crank it over and listen for a popping sound. IF yes, spark is at the coil, that means all ignition sensors are working. Next check for spark at ends of wires after cap. IF no replace cap and rotor. IF yes remove a couple spark plugs and check for fouling(wet, fuel etc...) IF yes replace or clean plugs and retest for starting. IF no spark is present at coil you need to scan computer and watch for rpm signal. IF no rpm signal, replace crankshaft sensor with OEM delco part. BIGGEST problem with these engines is Cap and Rotor burn out.

May 23, 2011 | 2002 Chevrolet Blazer

1 Answer

Wont start


is it turning over?
getting fire to the plugs?
things to check,
cap,rotor,wires, fouled plugs.

Jul 17, 2008 | 1996 Chevrolet S-10 Pickup

1 Answer

No fire


check the key swtich or just have it replaced

Jul 04, 2008 | 1992 Chevrolet C1500

Not finding what you are looking for?
1992 Honda Accord Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...