Question about 2001 Oldsmobile Intrigue

1 Answer

How do you replace coolant temperature sensor on an 2001 Oldsmobile Intrigue

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Oldsmobile Master
  • 6,826 Answers

Removal & Installation To Remove:
ECT sensor 3.5L engine How do you replace coolant temperature sensor on - 93174g14.gif

  1. Disconnect the battery ground cable.
  2. Drain the coolant below the level of the engine coolant temperature (ECT) sensor.
  3. Disconnect the ECT sensor electrical connector.
  4. Carefully remove the ECT sensor.
To Install:
WARNING
Damage to the coolant sensor will affect the operation of the fuel control system.
  1. Coat the ECT sensor threads with thread sealer.
  2. Install the ECT sensor. Tighten the sensor to 15 ft lb (20 Nm) on 3.5L engines and 22 ft lb (30 Nm) on 3.8L engines.
  3. Install the ECT sensor electrical connector.
  4. Connect the battery ground cable.
  5. Refill the cooling system using the recommended procedure.
prev.gif next.gif

Posted on Aug 29, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the low coolant switch located on a 2001 Oldsmobile intrigue


Those are usually located on the coolant reservoir tank.

Feb 22, 2017 | 2001 Oldsmobile Intrigue

1 Answer

2001 olds intregue heat not getting warm in car why?


This could be a lot of things but I would try the most immediate solutions first.Do you have the correct level of coolant in your radiator?It could also be your thermostat not functioning properly and stuck open.It could also be your temperature sensor.Lastly and most expensively it could also be a clogged drier located in most vehicle under the dash board.Try a radiator flush if all else fails.

Nov 26, 2013 | 2001 Oldsmobile Intrigue

1 Answer

2001 oldsmobile intrigue engine temperature rises when idle and normal when driving


If the radiator is full of coolant, it could be a blockage in the engine not allowing the coolant to flow.

Dec 25, 2012 | 2000 Oldsmobile Intrigue

2 Answers

I have a 1999 oldsmobile intrigue with a 3.5 engine and it is overheating what might be the problem?


It's usually the thermostat, I woud pressure test the cap. It may need to be flushed. Are the fans working? Is there a 50/50 mix of anti-freeze

Sep 11, 2011 | 1999 Oldsmobile Intrigue

1 Answer

Trying to find p0131 which is on a 2001 oldsmobile intrigue transmission help me locate?


p0131 refers to low voltage reading on the o2 sensor. Should be the bank 1 which is the o2 sensor closest to engine. Inspect wires and/or replace sensor.

Mar 16, 2011 | 2001 Oldsmobile Intrigue

3 Answers

Oldsmobile intrigue 2000 coolant light will not go out even though the tank is up to fill line--how do i turn off the light


you do not turn off light this vehicle has a low coolant sensor that goes bad it is located in the passenger side of radiator side tank it is held in place with a wire clip and has o-ring to prevent coolant from leaking out around it

Jul 27, 2010 | 2000 Oldsmobile Intrigue

1 Answer

Crankshaft sensor location on 2001 oldsmobile


. Its above the starter going into the side of the block. (front side of the engine) Disconnect the battery. Remove the starter. Remove the wIre CONNECTOR plug to the sensor. The sensor has 1 bolt holding it in. Remove the bolt, you may have to wiggle the sensor at the base a bit as you pull it out. Replace, and make sure it is pushed in all of the way. Replace the bolt, wire plug, starter, reconnect the battery.

Jun 05, 2010 | 2001 Oldsmobile Intrigue

1 Answer

2001 Oldsmobile Intrigue


Knuckle replacement may have damaged wheel speed sensor or wiring.

Mar 01, 2010 | 2001 Oldsmobile Intrigue

1 Answer

99 oldsmobile intrigue


The ambient temperature sensor going bad causes this exact problem. I've replaced many of them because when they show outside temp as being below 60 degrees, the A/C control module will shut the compressor off.

Aug 07, 2008 | 1999 Oldsmobile Intrigue

Not finding what you are looking for?
2001 Oldsmobile Intrigue Logo

1,523 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...