Question about 2000 Chevrolet Express Cargo

Open Question

How to replace back door latch 2000 chevy express

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 142 Answers

SOURCE: 2000 2wd Dakota Quad cab, right rear door latch

Sounds like either a linkage rod came off or the interior handle is broken. either way you have to take the interrior door panal off to see which it is.

Posted on Oct 09, 2009

  • 17 Answers

SOURCE: 2000 chevy cavalier door wont close. door latch

you have to open the jaws on the lock by takeing a screw driver and pring it open while opening the handle. try that see if it works

Posted on Jul 27, 2009

  • 389 Answers

SOURCE: trying to adjust outer door handle rod. how to

Once you remove the door panel, you will see the linkage and rods. The rods are connected with these little "swing away" plastic fasteners. Basically, these fasteners have a hole on one end and a sort of channel which snaps onto the connecting rods. To remove them you just unsnap them from the connecting rods. I'm enclosing 2 pictures of typical awing away connectors. In the pictures, it's the square end which needs to be unsnapped. Hope this helps, if you need any further clarification, just post a comment.

Posted on Jan 11, 2010

  • 10319 Answers

SOURCE: 2000 Ford expedition. Rear door latch will not release when unloc

Yes the mechanical lock is shot for it stuck
Replace it or soak it in WD40 first and work with it to see if it frees up for you. If it does add white lithium grease to it all over the moving parts and install

Posted on Jun 05, 2010

  • 1 Answer

SOURCE: I need a diagram of fuse box for 2000 Chevy Express Van

i have a 2000 Chevy van where is the fuse for the two(2) rear power outlets

Posted on Apr 08, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2000 chevy 1500 no start, no crank, security problem

The truck has a feature, where you turn the key in door lock , the alarm should stop going off. there is a small switch on back of the lock cylinder. it may have popped off and is in lock position, but you cant turn it back to on position, because it popped off from the back of the lock. remove the door panel and look inside of the door where the lock is. make sure, that the switch is attached firmly to the back of the lock cylinder. start there.

Jul 04, 2013 | Cars & Trucks

1 Answer


first open door and spray wd40 on latch to see if its stuck if not the latch on inside of door is bad but they really dont't go bad that often so just see if its stuck

Feb 15, 2013 | Chevrolet Cars & Trucks

1 Answer

How to fix rear left door mechanism in 2000 chevrolet express

you have to take the inside pannel off and get behind it. There will be a pannel you will need to take off to get to the inside of the door. There is a plastic clip that holds the rod to the door latch. It is probley broke and let the rod fall out. You can get these at any auto parts store. Clip it back into place and you should be ready to go.

Dec 01, 2012 | 2000 Chevrolet Express Cargo

1 Answer

How do you adjust the drivers door, improper closing, on a 2000 Chevy Silverado 1500?

If it is closing inproperly, open door. Lift up on bottom of door near latch. If there is movement the hinge pins need to be replaced. If there is no up & down movement adjust stiker bar on pillar that door closes onto, either up, down or in or out, depending on how it closes.

Jan 17, 2011 | 2000 Chevrolet Silverado

1 Answer

Driver side door on 1995 chevy express van will not shut

Chances are the door latch has closed without the door being closed.

Inspect the latch mechanism on the door. I suspect you will find that the latch is in the closed position.

Use a screw driver to take place of the normal jam pin in the latch apply tension ( like the tension that would be present normally opening the door) and actuate the door handle.

Make sure to lubricate once you do get the latch to open.

Jan 17, 2010 | 1999 Chevrolet Express

1 Answer

My back door won't open on my 2000 tahoe

you latch mechanism could be broken or came apart, common to any vehicle.. open the cover to the back and you will see the locking mechanism, once the rear cover open you can find the latch and open it form the inside. once you get the door open you can play with the door handle by pulling on it like you opening the door and you can observed what actually connect to what to operate the latch. if small rod attached from the door handle to the lock could pop off or broken. may have to replace the handle, depend if its broken or came apart. should be 30 buck for the new handle if needed..hope that help some..good luck

May 30, 2009 | 2000 Chevrolet Tahoe

1 Answer

I need a diagram of fuse box for 2000 Chevy Express Van

i have a 2000 Chevy van where is the fuse for the two(2) rear power outlets

Oct 30, 2008 | 2000 Chevrolet Express Cargo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

281 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides