Question about 1999 Jeep Wrangler

Open Question

I have a 1999 Jeep wrangler, all the gauges stopped working at the same time. I checked all fuses under the dash and under the hood. A friend mentioned the IPC. Where would I find this?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76691 Answers

SOURCE: Turn signals not working on 2001 Jeep Grand Cherokee

replace the turns signals flasher unit.

Posted on Mar 02, 2009

Ad
co7196
  • 3433 Answers

SOURCE: 97 Jeep Wrangler Dash Gauges Arent Operating..everything else ok!

ck the engine to body ground.located back side of engine and srew to firewall.

Posted on Jun 01, 2009

  • 1 Answer

SOURCE: 97 Jeep Wrangler Dash Gauges Arent Operating..everything else ok!

I have a 98 Wrangler - same problem. Dash gauges would work, then out (airbag light came on). Then it would work for a week or two than out.
Tried looking at fuses, wires, aftermarket radio problems, etc.
When I pulled the instrument cluster out of the dash, I noticed a lot of goop (lubricant) on one of the cluster plugs. So I wiped it off with a paper towel and now everything works. Maybe too much goop was shorting stuff out? Anyway, I'll know in a couple of months if that was my problem or not assuming my gauges keep working uninterrupted.
ranger326

Posted on Aug 05, 2009

  • 197 Answers

SOURCE: hood wont open on 1999 dodge durango

The cable has snapped. The easy bit is replacing it, the hard bit is getting the bonnet open to do so. Take it to a good local garage, or even to ford to open the hood, tell them you can't open the hood and say nothing. Let them open the hood for you, and close it slowly, just one click, so it it still latched, then change the cable.

Posted on Aug 11, 2009

ZJLimited
  • 17970 Answers

SOURCE: i need to find a diagram of the fuse box under the

Review ths Repair Manual ZJ-Secc-8W-Wiring-Diagrams (page 7, 9 and 10 for location, details and description). The diagramas can find it in the next pages.

I hope help yuo with this (remember rated this help). Good luck.

Posted on Oct 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dose 2008 wrangler have a fuse panel in cab


Most American-made cars have a fuse box under the dash. Check under dash at driver's side firewall. May have a cover that you will need to open. Also see fuses under hood in area around the steering column.

Feb 15, 2015 | 2008 Jeep Wrangler

1 Answer

Gauges top working security system not working vehicle will start but only runs 2 seconds


fuses, check all fuses in all fuse boxes. under dash and hood.
the IMMO SKIM , stops fueling of the engine.
the SKIM lamp in the dash shows, that. it sticks on or flashes
you have a transponder key ,right?
and you insert the key as the oper guide states, and the lamp SKIM
self tests. then must go out, if not, the engine will never run more than 2 seconds by Design.
  1. so fix the dead dash first.
  2. then get the SKIM lamp out
  3. then start car.

Sentry Key Immobilizer module.

Mar 15, 2014 | 1999 Jeep Grand Cherokee

1 Answer

95 jeep wrangler 4.0,won,t start,dash lites won,t go on.replaced starter relay.still won,t turn over.


Try checking the battery and battery leads. Sounds as though you have a bad battery. Also check your fuses under the hood and dash.

Jun 03, 2011 | 1995 Jeep Wrangler

1 Answer

The fan for the air conditioner and heater will not come on for any speed on my 1999 4 cly. jeep wrangler. I've changed the fuse in the fuse box behind the glove box. Is there any other switch/fuse that...


It may be a relay problem. From the controls on the dash it should lead you to the components behind the dashboard. Check if the connections are OK. I am unsure if the relays are found there, but inspect the relay at that area or under the hood.

Jun 08, 2010 | 1999 Jeep Wrangler

2 Answers

1999 jeep wrangler dash gauges not working


likely connection behind dash. Easy fix - remove dash, twist cannectors behind dash and put back together. All gauges will e working again. 10-15 mins tops

May 20, 2010 | 1999 Jeep Wrangler

2 Answers

1998 Jeep Wrangler - Radio and Wipers stopped working


Some of the factory and aftermarket radios have a fuse in the rear of the unit. You will need to remove the radio from the dash to check it. It will have a spade type fuse in it. If it is bad the radio will not work.

Aug 29, 2009 | 2003 Jeep Wrangler

2 Answers

97 Jeep Wrangler Dash Gauges Arent Operating..everything else ok!


ck the engine to body ground.located back side of engine and srew to firewall.

Jun 01, 2009 | 1997 Jeep Wrangler

1 Answer

Fuse box


Under the left of the dash board close to the parking brake tucked up under.

Jan 02, 2009 | 1989 Jeep Wrangler

1 Answer

Removed aftermarket radio from 1999 Wrangler, no gauges work now


first, you have to tape any open wires with electrical tape, so they DON"T short anything out again. second, check your gauge fuse.

Dec 04, 2008 | 1999 Jeep Wrangler

Not finding what you are looking for?
1999 Jeep Wrangler Logo

Related Topics:

188 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...