Question about 2007 Mercury Montego AWD Sedan

Open Question

How to change rear spark plugs on a 2007 mercury montego

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
maklean
  • 1665 Answers

SOURCE: changing rear brake pads

http://www.automedia.com/Replacing_Brake_Pads/ccr20050701bp/1

Posted on Jun 26, 2008

Ad
  • 387 Answers

SOURCE: Change the oil on a 2005 Mercury Montego

Go to a automotive store and tell them you have a 2005 Mercury Montego and what engine it has if there is more then one model and get an oil filter and the oil. Put the car up on ramps and secure it making sure it won't roll back or fall while you are under it. get under the engine and look for the oil pan which should have a bolt in the bottom of it where you can drain the oil. Drain the oil in a proper container and then put the drain plug back in the pan. Then find the oil filter and unscrew it and remove it.. It could be full of oil so watch out and make sure the pan is underneath the filter. Wipe the base where the oil filter screws on and make sure the gasket from the old filter is not still on the engine. Get your new filter and take your finger and put it in one of your new containers of new oil and spread that on the gasket of the new filter. Screw on the filter until the gasket touches the base and then turn only a little more then a 1/4 to 1/2 turn tops. Do not over tighten the filter. Find out what oil the vehicle needs (probably 5-30) and look for the oil cap on a valve cover under the hood. It probably takes 5 quarts but check for sure in your manual or ask when you are at the automotive store. Put the oil in and put the filler cap back on. Now go start the vehicle and make sure you have oil pressure by either the oil pressure guage showing pressure or the oil pressure idiot light goes off and while running check under the car for any signs of leaks. If no leaks then back the car off the ramps and shut the car off on a level surface. Let it sit 10 minutes and check for leaks underneath the car and check the oil dipstick to make sure the proper level of oil is in the engine. Then you are set.

Always check your air filter when changing oil to make sure it is clean as that helps your engine run better and you save gas in the process. Good luck

It is also best to change oil when your engine is warmed up as well.

Posted on Mar 28, 2009

  • 204 Answers

SOURCE: changing rear spark plugs

yes you have to take your front motor mount out and come along the motor forward you do not need to take the intake off

Posted on Apr 21, 2009

  • 387 Answers

SOURCE: Oil change light

Look up the light on the part of your owners manual that explains what each idiot light is for on your dash. That should give you a page where more information on it is available. Part of that section should state that if maintenance is done by someone other then your Mercury dealer, then do the following to reset the light. That should take care of ya.

Good Luck

Posted on Dec 15, 2009

  • 2 Answers

SOURCE: I can't seem to compress the rear brake calipers

With a pair of needle nose pliers turn the pistons clockwise to set them back to base position. The V shape groves are not too deep on the pistons, so make sure you have gloves on, in case of the pliers slip out while turning it.

Posted on Apr 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Blend door actuator replacement 2005 2006 2007 mercury montego


Remove the glove box liner and you should be able to access it from there.

Apr 01, 2016 | 2005 Mercury Montego

1 Answer

How do i fix heated seat in 2007 mercury montego


Two things: Test the wires going to the heat strip in the seat. Check the seat control module to see if it is faulty.

Feb 11, 2015 | 2007 Mercury Montego AWD Sedan

1 Answer

Does the 2007 Mercury Montego have a unique charging system that only sends a current when the computer deems it necessary? The alternator has been tested and is in fine working condtion, however we are...


the PCM (engine computer) does have some control over the alternator. You should have 12 1/2 vilts with the engine off at the battery, and about 14 1/2 volts with the engine running and alternator charging.

Apr 01, 2011 | 2007 Mercury Montego AWD Sedan

1 Answer

COMPRESSING REAR BRAKE CALIPERS ON 2007 MONTEGO


Ford rear brake pistons usually screw back in .
if you have compressed them mechanically they may be damaged.

Aug 28, 2009 | 2006 Mercury Montego

1 Answer

Location of 2007 Mecury Montego tail light fuse?


The fuse is no.8 (15amp) in the interior fuse panel however it works all the park lights front and rear.

Feb 21, 2009 | 2007 Mercury Montego AWD Sedan

1 Answer

2007 mercury montego rear light fuse keeps blowing


  You need to be more specific about which rear light blows the fuse(interior,stop or tail). If the car has an aftermarket alarm or autostart I would look there first, they are usually installed poorly and create these types of problems. 

Oct 19, 2008 | Mercury Montego Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

342 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

fordexpert

Level 3 Expert

5579 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...