Question about 2000 Dodge Durango

1 Answer

How do you take the door cover off a durango to change a mess up speaker

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Make sure you take all screws out of door panel, dont forget the one by the handle, once all screws have been removed lift gently and pull towards you

Posted on Aug 28, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 01Dodge Durango and i needed to know the fuse layouts


for fuses inside vehicle, pull the cover of the drivers side dashboard end with the door open. Fuse map is inside the cover.

Feb 28, 2015 | 2001 Dodge Durango

1 Answer

Need 1999 dodge durango fuse panel diagram


here is the diagram for your Durango. Notice where it says 'RADIO' That is your RADIO
2_22_2012_1_33_44_am.jpg

Feb 22, 2012 | 1999 Dodge Durango

1 Answer

How do I remove the door panel on a 1999 Chysler concorde?


for the front doors:

Remove the speaker cover.

Remove screws holding the speaker.

Inside the door handle, there's a little cover that you can open with a flathead screwdriver. Flip it open then remove the screw inside. Another one of these is in the little armrest cubby. Same deal, flip it open then remove the screw.

If you have sail speakers (close to the window), remove these too. Gently pry the cover off, then remove screws.

The dip on the door towards the front of the car, there are 2 screw to be removed, they are in there deep but easily come out.

At the bottom, there are 3 more screws to remove.

Once you have these screws off, you can feel the door panel start to come off. There are plastic pieces inside the door panel that are a pain to get the door panel off of; you'll have to lift it to remove the panel. Be aware these might break. I found replacements at an autoparts store. One of mine doesn't have 1 of these (2 on each panel IIRC) but there is no noticeable difference.

As stated, this is for the fronts. The rears should be somewhat similar, just screws to remove.

Carefully put the panel back on, making sure the panel rests into the clips in the door panel, or it might feel loose or look off. You might have to mess with the door lock when you put the door panel back on. Good luck.

Aug 02, 2011 | 1999 Chrysler Concorde

1 Answer

How many speakers does my 98 durango have?


There should be four(with the standard stereo-radio)Two in the dash(L&R) and two in the L&R rear doors.Deluxe stereo might have Two extra L&R (2 inch) near the "A " pillar in the L&R front doors.

Dec 23, 2009 | 1998 Dodge Durango

2 Answers

Electric door locks lock and unlock all the time even if its not running


Hi:
The most likely cause of this is the power door lock control module. You can locate the fuse for the power door locks and pull that, to keep your durango secure. I am not 100% sure , but I think the module is located inside the drivers door.

Nov 18, 2009 | 2003 Dodge Durango

3 Answers

1999 Dodge Durango driver side window does not roll up nor down.


Remove the door panel and find the window motor Unplug it and using a separate car battery run cables directly to the window motor When you switch the polarity the motor will either bring the window up or down or if noting happened change the window motor and window regulator assembly.

Jun 08, 2009 | 1999 Dodge Durango

1 Answer

Want to install after market speakers in 06 Chevy Cobalt...


they make a tool V-shaped that should be used for prying around the door panel..door airbags should not be triggered unless wiring for them is shorted, replacing speakers should not mess up any other wiring , fuses should be fine as are..

Jun 02, 2009 | 2006 Chevrolet Cobalt

1 Answer

What size speakers are in 1999 Dodge Durango


Car speaker fit guide - DODGE DURANGO 1999
According to our database, here are the speakers types that go in your DODGE DURANGO 1999 car, along with their location:
  • Front: 6-3/4"
  • Rear: 6-3/4"
  • Front door: 6-3/4"
  • Back door: 6-3/4"

Dec 17, 2008 | 1999 Dodge Durango

3 Answers

Door removal


there will be a torx head screw somewhere around not the door handle but the handle on the door, and then a phillips head screw above the mirror adjuster and 2 more screws on the bottom of the door. once all of those are removed, simply pull upwards on the panel until all clips break loose. Be careful not to break the harness, of the door handle and electric locks and window. once the panel is pulled back the speakers should be exposed. hope this helps.

Nov 21, 2008 | 2002 Dodge Durango

Not finding what you are looking for?
2000 Dodge Durango Logo

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...