Question about 1997 Ford F250 SuperCab

Open Question

Where is the Voltage Regulator located on a 1997 Ford F-250 7.3 liter diesel?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 321 Answers

SOURCE: 1990 dodge caravan voltage regulator location

Voltage regulator should be built in,in the alternator.

Posted on Jul 09, 2008

  • 2 Answers

SOURCE: ford f-250 diesel fuel filter blinking

Does your truck have the big fram mounted fuel filter? If so there should be a drain plug where you can drain the water. Instead of having to replace the filter. also I might look at buying my fuel at a different place.

Posted on Apr 08, 2009

michigan man
  • 3533 Answers

SOURCE: spark plug gap spec. for 1997 ford ranger/4.0 liter

for the most part it is under the hood of your car where the sticker say engine size try this website to see if they have you car listed its www.autozone.com if not call your local part store and tell them its a 4.0 liter and you need the gap on the spark plugs

Posted on Apr 20, 2009

  • 122 Answers

SOURCE: how to change fuel filter on 1997 ford f-250

if there are two clips going trough the filter line pull them out then stay clear & pull the line out if not there is no clips then you will need ford filter removal tool you can get them at any parts store there are about 30 bucks for the set

Posted on Jun 04, 2009

  • 113 Answers

SOURCE: 84 ford F350 6.9 diesel charging system not

look for a fusible link out. You need to check for output on the alternator that you installed. make sure the batteries are fully charged before that, otherwise its not going to read right. start from the source. also, you can disconnect the batteries from the sys and do a continuity check on the wires in the loom, so you can see if current has a path, or if you have an open circuit. hope this helps

Posted on Jul 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

03f250 7.3disel runs good gets hot shutsoff replaced camshaft sensor


Ford F250 Truck Overheating Why - Ford-Trucks

www.ford-trucks.com > ... > Powertrain > Cooling System
Nov 13, 2014 - Here are a few reasons why your Super Duty truck is overheating. ...6.0 Diesel · 1999-2003 7.3 Diesel · 1994.5-1997 7.3 Diesel · 1983-1994 7.3&6.9 Diesel... This article applies to the Ford F-250, F-350 Diesel (2005-2014).

Aug 26, 2015 | Ford Cars & Trucks

2 Answers

How do i change the fuel filter on a 1992 Ford F 250 7.3 Liter diesel.


fuel filter problems come in slowly as in loss of power. It it just died and will not start I would be looking elsewhere for the problem. A good place to start would be the fault codes to check for cam/crank position sensor faults, immobiliser operation,timing belt condition. If you ran the fuel too low it may have air in the system that will have to be bled out. Best have an accredited diesel shop specialist look at it.

Nov 12, 2014 | Cars & Trucks

1 Answer

1997 7.3 powerstroke diesel keeps stalling


I have and had to replace the cam sensor for the same problem

Jan 20, 2013 | Ford F-250 Cars & Trucks

1 Answer

What is an estimate on installing a new high pressure pump on a 2004 ford excursion diesel??


have replaced them in under 3.5 hr
26 units from 250 to 550 all with 6 liter diesel
and ton of other issus with them

Nov 16, 2010 | 2004 Ford Excursion

1 Answer

1997 F-250 HD, diesel 4X4. Windshield wipers will


Replace the wiper switch assembly. Fords are noted for these switches failing.

Jan 17, 2010 | 1997 Ford F250 SuperCab

2 Answers

My 7.3 L diesel ford f-250 shows the battery light (check charge system) on in the dash. I tried to drive it and the voltage gauge started dropping into the 10-11 v range. I replaced the alternator...


You must have an older vehicle,but I am pretty sure the 7.3 was put out after the voltage regulator was put in the alternator.What you are describing is a voltage regulator on the the firewall.If this is so,replace the voltage regulator on the firewall,with a new one.This will be the problem most likely.The voltage regulator on the firewall should be kind of flat,almost square,and a wide plug,goes all the way across the voltage regulator.If You don`t have external regulator,then it is built in the alternator,and the alternator you purchased is bad.Be sure the wires on the back of the alternator are not broken anywhere.The big post ,largest wire,on the back of the alternator is the out put wire.It should go to the battery.If it does not have 13.65 to 14.25 volts on the back of the alternator,and at the battery positive post.Like I said,I believe the voltage regulator is on the firewall,if it looks like I described,then it is a regulator,replace this part(voltage regulator)and it will solve your problem.I hope this was some help,please let us know,thank you.

Oct 15, 2009 | Ford F-250 Cars & Trucks

1 Answer

Where is the fuel pressure regulator located on a 2003 f-350 diesel 7.3 liter, and how will you know if this is bad?


most diesels don't have a fuel pressure regulator,  The primary pump pressurizes a fuel loop keeping fuel ready for the injector pump. Throw in a few filters and thats about it.
And you certainly don't want to mess with the injector pump. 

Mar 22, 2009 | 1995 Ford F350

1 Answer

What tools do you need to replace a 1997 Ford F250 diesel fuel pump?


nothing special, its in the valley, probably have to remove the fuel bowl and the turbo pedastal to get access to it.
book value from navistar / ford is a 4 hour job.
better have a good ladder and a plywood sheet to lay on up in the engine bay.

Jul 05, 2008 | 1997 Ford F250 SuperCab

Not finding what you are looking for?
1997 Ford F250 SuperCab Logo

Related Topics:

252 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...