Question about 2005 Hyundai Tucson

1 Answer

Airbag light is remaining on when the engine has started. I tryed to manually resetting by disconnecting the battery but this did not help. I have a 2005 hyundia tuson.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Hyundai Master
  • 22,114 Answers

Dealer only they use encrypted software on later models from 2005 and although you have a OBDII plug under dash its only for show or the american market for the emisions test ,The actual diagnostic plug is under the bonnet with a fancy shape thats copyrighted so no made up bits for aftermarket readers.Doesnt help general mechanics like myself much

Posted on Aug 28, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What does SBS mean, it is lite up on my dashboard


I think you mean either ABS or SRS.
ABS refers to the braking system so this would need investigation....I.e.check brake fluid reservoir and for signs of leaks round brake pipes and wear on pads.
SRS supplemental restraint system...usually airbag warning light. They should go out after 5 seconds on start.sometime they can be reset by using various techniques like leaving the driver door open...turning the ignition on but not starting the car... Then pressing the door light switch button on bottom of driver door opening 5 or 6 or 7 times and turning off ignition All within 10 seconds.(you may need to experiment with this number )always hold the door light button in on last count whilst turning ignition off.then close door restart car.wait 5-7 seconds then it will reset unless there is actually a problem with airbag.this can occur when you disconnect battery or replace battery.the interruption can
alter airbags sensor.also some sensors are housed in the horn component of car horn and the spring on horn can interfere with the sensors normal operation.So did you recently remove battery or use horn excessively ?finally if it is an airbag fault and the light remains on it may mean your airbag will not deploy and your seat belts won't lock in a collision scenario.best in that event to get to a garage.if thus is of help please vote thank you.

Feb 11, 2015 | Cars & Trucks

1 Answer

My daughter has a 2008 Sentra; tire inflation light was lit despite tires all properly inflated. She tried to reset computer by disconnecting battery cables.Now car won't start; nothing happens when s


Now you learned about removing battery cables,
for no reason

Look in your owners manual for the next step you take

After that --you will need to call a dealer or repair shop
& have them look up what --you needed to know
before you ever remove a battery cable

Aug 27, 2014 | 2008 Nissan Sentra

1 Answer

Engine light on hard start after refuelling 2007 caddy dts


Try resetting the check engine light by disconnecting the battery for a few minutes (While the battery is disconnected turn your key on and off a few times and run through some switches on the dashboard to drain out any remaining power that might still be in the system). If your vehicle is equipped with a backup power source for memory purposes it could take a bit longer. Reconnect your battery and everything should be reset as far as warning lights. If the check engine light comes back on i would say you have an unrelated issue.

Mar 01, 2014 | 2003 Pontiac Sunfire

1 Answer

I tried to reset the engine light by disconnecting the battery cable. When I put it back on the car wont start and gage needles are jumping


As I know disconnecting battery cable cannot reset engine light.
Engine light on caused by a fault code remained in the OBD system. You have to clear the fault code to reset engine light.
But before that, I suppose to have your car checked first to make sure there's nothing wrong.

Good luck.

Dec 29, 2011 | 2003 Chrysler PT Cruiser

1 Answer

Having problem boosting my 2002 buick lesabre


Sounds like the last car I bought with"no problems!"
Start with a charged battery and clean all corrosion off cable connections before installing and tightening. Check your battery ground for a clean tight connection.
O.K., key on...still no check engine light/airbag light? You sure it's the bulbs out and not something disconnected? Try starting it. Does it crank over normally? If nothing, you mayhave a fuse out or something wrong in the power distribution center in the engine compartment. Check your fuses.There may be another center or box, too, with fuses, besides the one. Post back if you need more help. Cheers.

Nov 25, 2011 | 2002 Buick LeSabre

1 Answer

Why does my airbag light stay on all the time. Nothing happened to the car the day it just turned on. So I don't believe it need airbag system needs serviced. Even when the battery was disconnected the...


Sounds to me like one of the air bag sensors may have tripped, causing the airbag computer to think the vehicle has been wrecked. Take the vehicle to a dealership and have them reset the air bag sensors to get rid of the light.

Feb 12, 2010 | 2000 Ford Taurus

3 Answers

Airbag light is on. I unplugged a plug to gain access to the daytime running light control box. Plugged everything back in and now the airbag light is on in the dash


Hello.
Give your computer a reset. Disconnect the battery terminals (positive and negative) for about 15-20 minutes. When time passes, put them back on wait 10 minutes and give it a try. Everything in the computer should be reset and you should have no more blinking air bag indicator. Hope this helps!

Dec 07, 2009 | 2002 Kia Sedona

3 Answers

Resetting airbag on 2002 kia rio


reset by code reader but you may have a problem warning lights dont come on for nothing also if you have seatbelt restraints these are connected and it may be one of those, hope its of help.

Apr 25, 2009 | Kia Rio Cars & Trucks

1 Answer

Airbag light on instrument panel flashes then stays illuminated


Some vehicles you can disconnect the battery for 10-20 mins and it usually resets a check engine light. But the airbag light is different. This means there is something wrong with the airbag system and it will not go out until maintenance.

Mar 29, 2009 | 1999 Ford Explorer

1 Answer

Flashing Airbag light


When you disconnected the battery you set a code in the airbag diagnostic module (loss of system voltage), you will have ot manually clear the code out to turn out the light.

Nov 12, 2008 | 1998 Ford Mustang

Not finding what you are looking for?
2005 Hyundai Tucson Logo

495 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...