Question about 1999 Plymouth Grand Voyager

1 Answer

How do you change air filter on 99 ply voy. 3.0 engine

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 523 Answers

The filter is located down low under the air box which connects to the throttle body. You'll need to remove the fresh air inlet line from the throttle body (loosen hose clamp) there are two (2) large phillips head screws which hold the air box in place , remove these there may too be a clamp which connects the air bos to the filter box, if there loosen and slide away the air box. On the filter box there are two (2) clamps that hold the filter in, snap back these claps to access the filter and replace. To install reverse the above.

I hope this may have assisted you,
Tom

Posted on Aug 31, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 99 navigator 5.4 engine runs rough when accelerating


Check fuel filter and air,could be tune up,bad wires.

Jan 21, 2015 | 1999 Lincoln Navigator

1 Answer

I have a 97 ply voy 6 cly 3.3 that has a instrament cluster that goes out & does not show. How can i do a self help dissaembly to this part & ?


Guess it's an SE. Find the junction block and check 10A fuse 10 which supplies the body control module. Also check 10A fuse 2, 10A fuse 12 and 20A fuse 3. If replacing fuses solves the problem, disassembly may not be necessary

Oct 02, 2012 | Cars & Trucks

1 Answer

20 amp engine fuse for 2000 plymouth grand yoyager keeps blowing


I don't have a picture, just a diagram. In the power distribution center, I see 20A fuse 3 for the automatic shut down relay and 20A fuse 5 for the fuel pump relay. No 15A fuses in the vicinity

Sep 25, 2012 | Cars & Trucks

2 Answers

Temp got up to 230 on my 99 cadillac deville is that normal


Make sure your engine is breathing properly, by regularly changing air filters. Flush your cooling system once each year and pressure test. There are cooling lines that cross over the rear of the engine that get corroded and may begin to weep antifreeze..you can view these lines by removing the engine cover....if you've had a consistent odor of antifreeze after running,with no drippage evident, this area is probably the culprit.....love my 99...

Mar 14, 2012 | 1999 Cadillac DeVille

1 Answer

I have a 99 jeep cherokee laredo 4.0 and it is stalling before excelerating. The engine is still running and the rpms go up but no faster for 3 or 4 seconds and then it takes off. Happens during the drive...


Change fuel filter, check air filter, clear air intake manifold with spray solution you can get from auto supply store. If that doesn't help have fuel pressure checked

Jul 26, 2010 | 1999 Jeep Grand Cherokee

2 Answers

Where is the fuel filter on a 95 ply voy. located


driver side engine compartment. sometime its under the car driver side frame.

Aug 24, 2009 | 2005 Dodge Caravan

1 Answer

'99 honda accord won't start in heat


ENGINE GETTING VAPOR LOCKED.YOUR AIR FILTER COULD BE CLOGGED.

Aug 09, 2009 | 1992 Honda Accord

1 Answer

1997 ply voy, replaced trans and now engine misses.


Check the gap of the crankshaft position sensor. You can buy a stick-on button for it at a Chrysler dealer or just eyeball it and get close. The sticker attaches to the end of the sensor, when you install it you push it all the way down to touch the tone ring and tighten the bolt. When you hit the key to start, it scrapes the sticker off and you have the correct gap. Or you can loosen it, push it all the way down and then lift it up about one millimeter or so. I hope this helps.

May 23, 2009 | 1997 Plymouth Voyager

1 Answer

How to change an air filter in 99 Intrigue 3.8


  1. Disconnect the IAT sensor electrical connector.
  2. Loosen the air inlet hose clamp.
    444460.gif
    tif.gif
  3. Carefully remove the air inlet hose from the throttle body and air cleaner cover (5).
  4. Remove the 2 housing cover retaining Screws .
  5. Remove the air cleaner cover and carefully remove the air filter element.
  6. Inspect the housing cover (4), seal assembly, and air ducting (2) for damage. If a problem is found, replace as necessary.

Nov 26, 2008 | 2000 Oldsmobile Intrigue

Not finding what you are looking for?
1999 Plymouth Grand Voyager Logo

Related Topics:

289 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...