Question about 1997 GMC Jimmy

1 Answer

Code reader will not turn on 2000 gmc sanoma 2.2 sfi car misses an stumbles at intermittent speeds lacks power got a fuel filter checked the fuel pump

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 115 Answers

Try to fool your scanner for a s10- 2.2l intead of blazzer

Posted on Aug 28, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is Mazda Miata stumbling and missing after reaching closed loop?


Check compression. After spark and fuel, compression is next on older cars.

Jul 18, 2015 | 2000 Mazda MX-5 Miata

2 Answers

Where is the fuel pump shut off switch located on an 03 GMC SANOMA?


Pretty sure it doesn't have one. Mostly, only Fords had them. No fuel to engine? Check fuel filter and fuel pump operation, have the fuel pressure checked. Do you hear the fuel pump turn on for 2 seconds with key in on, not start? It should, to put pressure in the line to the engine and to the injectors. If pump doesn't turn on, either bad pump or a problem in the fuel pump circuit. There is a fuse and a relay in the circuit.

Jun 29, 2015 | GMC Cars & Trucks

2 Answers

92 dodge 1500 pick up 360 v8 automatic Starts, runs but hesitates, low power code 37 on diagnostic readour


Code 37 is torque converter clutch solenoid failure. Transmission wont shift in and out of overdrive.

Nov 28, 2012 | Dodge Cars & Trucks

1 Answer

02 gmc sanoma turns over but doesn't fire I replaced distributer,rotor,plugs,ignition coil,fuel filter, and the fuel pump turns on and the gas is getting to the fuel rails near the feul pressure sensor.


Check to see if you have compression on all cylinders. If you don't, replace the timing chain/belt. If you do check the ignition relay and fuse panel for blown fuses.

Oct 11, 2010 | 2002 GMC Sonoma Extended Cab

1 Answer

My 2003 Tiburon GT V6 5spd has been intermittantly hestitating and missing while at a contant speed and even stalling out from time to time. Also, the engine revs high at 2000 rpm then back down to 1000...


have you changed your fuel filter in the last year or so, if not. do it. a plugged up fuel filter will cause a lot of issues also. it can cause stalls, hesitation and stumbling.

May 08, 2010 | 2003 Hyundai Tiburon

1 Answer

1994 Sonoma: 1994 GMC Sanoma with 4.3 fuel injection. Idle spee...


that is un adjustable you would have to change the idle postion sensor

May 05, 2010 | 1994 GMC Sonoma

2 Answers

Need to locate fuel filer on 2000 gmc sierra truck 5.3 liter


For 2000 GMC Truck Sierra 2500 4WD 5.3L SFI 8cyl the Fuel Filter is located: Under vehicle, driver side, below seating area, near fuel tank, mounted on frame rail in fuel line.

bb521df.jpg

Fig. Typical in-line fuel filter mounting location

Hope this help (remember comment and rated this post).

Apr 19, 2010 | 2000 GMC Sierra

4 Answers

Missing and stumbling during acceleration


4.2 ltr missing. 2000 truck, f150. Changed plugs, wires. Ran great for 2 weeks. Started again. Changed coils. Got worse. Changed fuel filter, did nothing. Added injector cleaner and fuel cleaner, nothing. Checked EGR, o.k. It is getting worse. Had new gas about the time it all started.

Feb 07, 2009 | 2000 Ford F150 Flareside SuperCab

1 Answer

Engine intermittently stumbles and stalls after taking off from stop. I changed filter, added 1/2 tank of fuel with STP injector cleaner. I had two more occurences after that and 120 miles back home. Is...


Take carborator cleaner. First take off the big hose on the front of your intake then press gas peddal to open up and then spray it inside this fixed my problem. Jerry

Oct 13, 2008 | 2001 GMC Yukon

1 Answer

1997 GMC K1500 4x4 5.7 ex.cab SFI injection system


Hey there boatright33,

A few things things immediately come to mind.

There may be a problem with the engine controller. You could check the ODBII onboard diagnostics. Auto part stores will usually do this for you at no cost.

When you pulled the ones that were/went bad, how did the filters look? Could there be particulate matter still in the tank causing them to fail.

I always put this one off until last. Check the injectors. Are they gummed up?

Let me know what you find out
Mike


Aug 12, 2008 | 1996 GMC Sierra

Not finding what you are looking for?
1997 GMC Jimmy Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...