Question about 2004 Jeep Liberty

Open Question

The upper rear brake light bulb on my 2004 Jeep Liberty is out, I have purchsed what I believe is the correct replacement bulb, but see no easy way to get to the bulb to replace it. Any ideas?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

michigan man
  • 3533 Answers

SOURCE: how to replace rear brake pads on 2005 jeep liberty

put the back of car on jack stands and secure the front tires so it does not roll and then remove the bolts off the back of the caliper there is normally two one at top and one at bottom and spray it with some kind of oil for rust and make sure you have the right size socket before you try to loosen them and once caliper is off and the old pads removed take one of the old pads and squeeze the piston on the caliper back in by using a "C" clamp and also remove some of the brake fluid from the master cylinder before you do this put the new ones back on and check the brake fluid and make sure it is full and then pump the brakes to make sure you have a good pedal also put some "No Squeak" brake stop on the back of the pads so they don't squeak they will have that where you buy the pads from

Posted on Mar 01, 2009

  • 1 Answer

SOURCE: How to replace reak brake rotors on Jeep Liberty

Replace rear rotors on 04 liberty.
Remove tire & wheel
Remove brake caliper, tie up out of way.
Back off e-brake shoe adjustment.
Remove factory spring clip from lugs (2places)
This is the crude part....
After attempting to pull off disc/drum with puller....I got pretty sick of it. Understand this is in the Northeast with lots of salt on the roads in winter. Needless to say there is a ridge of rust around the inside edge of the e-brake surface. Any more pressure and I was afraid of damage to the e-brake shoe asembly. I then took a small grinder with a cut off wheel and cut the disc thru (used space where caliper usually sits). Also cut nearly through the face between 2 lugs. You can't quite get thru the back corner at the disc. Since the material is cast iron it will crack when you drive a wedge in the slot cut in the disc. This opens the housing around the shoes and it slides off easily. The cutting operation took less than10 mins, alot less than the puller with hammer assist!
I know this is a bit "unorthodox" to say the least, however the object is to remove the old junk disc safely and as quickly as possible, without harming the e-brake parts inside.
Install new parts in reverse order, new pads go in easy after squeezing the caliper piston back with a c clamp as is the normal procedure.

Posted on Mar 22, 2009

mastatech
  • 478 Answers

SOURCE: how to change front brake pads on a 2004 jeep

Remove the two hex head bolts holding the caliper. Remove caliper, remove pads from it. Use an 8 inch vise and an old pad to press cylinder back into caliper. Reassemble in reverse order.

Posted on Mar 28, 2009

  • 1 Answer

SOURCE: 2004 jeep liberty thermostat change?

ihave to change my thermostat in my 04 jeep liberty is it hard

Posted on May 22, 2009

  • 15 Answers

SOURCE: rear brake light keeps blowing out on 2004 jeep liberty

you need to find the intermittent short.

Posted on Jul 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i change the brake light on jeep liberty 2006?


1) You will need to open the rear swing door.

2) On the inside jam there are two torx headed screws (T-15's if I remember correctly).

3) Unscrew the two torx screws.

4) The light is now held by two mounting tabs (small spherical headed plastic sets that go through a rubber grommet).

5) You will need to pry the light casing off (easy pressure with a good size flat head screw driver will do the trick).

6) The light bulbs are twist mount settings inside the light casing.

7) Twist out the mount setting, change the bulbs, and reset the light mountings.

8) To put the light casing push the light casing back on and put in the screws. Everything else will work in reverse when it comes to assembling the whole unit.

2006 Jeep Liberty Replacement Light Bulb Sizes
Low Beam Headlamp Bulb Size: 9007
High Beam Headlamp Bulb Size: 9007
Parking Light Bulb Size: 2825 or 3157
Front Turn Signal Light Bulb Size: 3157
Rear Turn Signal Light Bulb Size: 3757ALL
Tail Light Bulb Size: 3157
Stop Light Bulb Size: 3157
High Mount Stop Light Bulb Size: 921
Fog/Driving Light Bulb Size: 9145 or H3-55W
License Plate Light Bulb Size: 168
Back Up Light Bulb Size: 3157
Front Side Marker Light Bulb Size: 168
Ash Tray Light Bulb Size: 161
Map Light Bulb Size: 578
Dome Light Bulb Size: 578
Step/Courtesy Light Bulb Size: 906
Trunk/Cargo Area Light Bulb Size: 578

Thank you for using fixya, and good luck

May 08, 2010 | 2006 Jeep Liberty

1 Answer

2002 Jeep Liberty left rear taillight bulb blown. Do I have to take interior panel off to get to the replacement of the bulb?


Yes,It's actually pretty simple, if your somewhat mechanically enclined.
I've only had to replace one or 2 bulbs in my 02' liberty within 95K miles.
The interior trim will either pop out or you have to twist these big plastic
hold downs to get access to the bulb holders. Pretty easy stuff. just
make sure you replace the two filiment bulbs with the correct ones and
vice versa with the single filament bulbs. Good luck.

Mar 22, 2010 | 2002 Jeep Liberty

1 Answer

The two back brake lights went out at the same time but the brake light on top of the rear window still works, would the problem be the bulbs or a fuse? 2005 Jeep Liberty


Both of my brakelights have gone out on my 2005 jeep liberty. The problem is the brakelight socket. I bought replacement socket from the dealership for about $8 each. They are wireless and easy to replace. They sit on a circuit monted to the back of the tailight. The dealership will need your vin # as there are different types of sockets for the liberty.

Dec 30, 2009 | 2005 Jeep Liberty

1 Answer

2005 jeep liberty brake lights will not work. I


brake pedal switch, get a wire, unplug plug, bridge circuit and check lights.
plug and switch is high up on the brake pedal not normally easy to get to.

Aug 15, 2009 | 2005 Jeep Liberty

1 Answer

Why is my 2004 Jeep liberty sport Brake lights not working. I have replaced the bulbs and fuses, what else can i do?


The brake light switch is probably bad. It's usually located up under the dash and is connected to the brake pedal shaft. It could even be unplugged.

Jun 18, 2009 | 2004 Jeep Liberty

1 Answer

Need to replace rear brake light on 02 liberty


open tailgate and you will see two retaining screws remove these and give unit a tug to remove then you will be able to replace bulb

May 19, 2009 | 2002 Jeep Liberty

4 Answers

Fuse for brake light on 2007 Jeep Liberty


I dont have owners manuel and need to know what fuse is my brake lights ? All brakes lights are out . Thank you

May 03, 2009 | 2007 Jeep Liberty Sport

1 Answer

Rear left brake wheel cylinder will not release


you may need to replace the caliper

Apr 12, 2009 | 2004 Jeep Liberty

1 Answer

Jeep Liberty Left Rear Turn Signal Not Working


sounds like the bulb you have is the wrong resistance the new noen bulbs will do this

Nov 16, 2008 | 2004 Jeep Wrangler

Not finding what you are looking for?
2004 Jeep Liberty Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...