Question about 2001 Ford Focus

1 Answer

Where to install the Blower Motor Reistor? - 2001 Ford Focus

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Ford Expert
  • 1,868 Answers

Hello! Lower the glove compartment...Disconnect the blower motor resistor block plug...Remove resistor block...


Posted on Aug 28, 2010

Testimonial: "Thanks. That was easy to install."


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2010 DODGE caravan a/c blower fan inop have replaced reistor and control head rear fan works have checked all relays and fuses

Hi Jim, I will try my best to help you. First off, let see what we are losing at the blower motor. Three things I want you to do. #1-With a multi-meter check the power side at the blower motor connector and see if you have a full 12 volts. #2-With a test light hooked to the battery positive terminal, check the ground side at the blower motor connector to see if you have a good ground, the test light should be good and bright. #3-With the multi-meter set on ohm's check across the actual blower motor connector a resistance reading of up too 7 ohms is OK, but if you have a reading above like 14 to 22 ohms then replace the motor. Hope this helps and have an awesome day Jim!

May 23, 2014 | 2010 Dodge Grand Caravan

1 Answer

Replaced resistor pack on citroen xsara blower motor now doesn't come on

old resistor ,,,,,,have a good look at the moving parts as a strip displaced itself from the resister

Feb 08, 2014 | 2001 Citroen Xsara Picasso

1 Answer

1997 Nissan pickup AC switch lights up & sounds like the compressor is coming on, belt is on AC, but no air blowing out--is this a bad blower motor and where is this located?

a defective blower motor usually caused this problem,or a defective reistor block assy located near the blower underneath the globe compartment

Jul 20, 2011 | 1997 Nissan Pickup

1 Answer

Replaced reistor on blow about two months ago that thing that looks like a credit card and than it was fine but now last week it stop working the front blower wont come on but the back will blow

the front blower motor located near the resistor has to be replaced a bad motor can cause the resistor to burn out draws to much amperage you wont need to replace the resistor again

Jan 15, 2011 | 2004 Dodge Durango

3 Answers

Locate blower motor resistor on 2006 Passat 2L Turbo

The resistor is not on the motor. Go into the passenger foot well and look underneath the dashboard right at the back. There you will find a foam cover that just pulls out. Remove the foam and you will see a clip on connector plugged in a white insert. The white insert is the resistor. Firmly pull the white insert out of the dash and the resistor is in your hand

Nov 03, 2010 | 2006 Volkswagen Passat

1 Answer

My 1986 2.3 trooper wil not blow hot or cold. Is it the reistor? Where is it?

Have you checked the fuse to the blower motor? Thats where you should start

Aug 24, 2010 | Isuzu Trooper Cars & Trucks

1 Answer

2002 bmw x5 heater blower not working

It could be the final fan reistor they all give trouble in this model.

Nov 22, 2009 | 2002 BMW 5 Series

1 Answer

Front a/c-heater blower just has off and high speed-for another reason bought another switch (used) and still have the problem with the 1 speed.Could the fan motor be bad?is there an easy way to tell?is...

Check the blower resisotor, I bet it will be burnt up, You'll need to replace the connector if that's the case, along with the reistor. It's the thing bolted into the hvac case right next to the blower motor.

Oct 21, 2009 | Chevrolet Suburban 1500 Cars & Trucks

1 Answer

My ac/heater blower will not turn on.. I do not have any power at the switch.. all my fuses appear to be fine,,Is there a relay that is not in the relay/fuse center that i do not know about, or which relay...

go directly to the blower motor itself on the passengers side of the vehicle. the wiring will be right there it has a green and a black twire connecter use a test light key on the green wire should be hot --if so ground the black wire the blower should run on high if this work you have a reistor fault thr resistor is located in the heater box .good luck

Aug 20, 2009 | 2004 Dodge Ram 1500

Not finding what you are looking for?
2001 Ford Focus Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers


Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides