Question about 1999 Chevrolet Silverado 1500

1 Answer

Extinguish the change engine oil light - 1999 Chevrolet Silverado 1500

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Chevrolet Master
  • 4,340 Answers

Engine off, Key on, depress the gas pedal three times, to the floor. Light should flash and go out.

Posted on Aug 27, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

How can i find a vacuum leak on my 1999 ford expedition 4.6

> idles up and down when sitting idle and the head lights and interior lights dim in and out

Probably not a vacuum leak; this can be caused by an AC (also on 'defrost') cycling and with changing engine loading, it is normal for some variation in engine speed although a defective 'idle air control' will allow a fair change in RPM.

The visible exhaust is likely purging the system from moisture (condensation) and not a sign of trouble.

Mar 29, 2015 | 1999 Ford Expedition

1 Answer

Bmw e46 problems

May need a new oil pressure switch,it's located next to oil filter,remove electrical connector then part.You may have to remove oil filter to remove part.

Jan 06, 2014 | 2001 BMW 318i

1 Answer

Engine light lights and extinguish

If the engine warning light lights or flashes when the occurrence, the engine of a control signal of the sensor misalignment or engine combustion conditions are bad, the relative range of fault source more, thus can not give accurate judgement of fault. At this time,use GM Tech2 to diagnostic it ,the engine control unit will freeze some data and have trouble codes, makes analysis and repair.

Dec 09, 2013 | Chevrolet Cars & Trucks

1 Answer

Oil light stay on nissan pathfinder 2007

Oil level to low or it could be the oil pressure switch which is located in the engine block, remove the connector and earth or bridge the wire or wires and see if it extinguishes the oil warning light on the dash diplay.

Jun 08, 2012 | Cars & Trucks

1 Answer

How do you reset the wrench on a 2002 Mercury Cougar after an oil change?

From my owners manual:
Illuminates to indicate that routine service should be performed. Check your maintenance schedule to determine the routine service to be completed.
To reset the light, hold the SELECT and UNITS controls on the trip computer for five seconds. The light will be illuminated and then extinguish after approximately four seconds.

Nov 20, 2010 | 2002 Mercury Cougar

2 Answers

CHeck engine AND VSA light came on in my car 2003 Highlander

Hello, and welcome to FixYa. Without knowing the actual 'code' (the reason for the light being on), it is hard to state with any accuracy.

However...we see quite a bit, here in my shop, Highlanders with the Check Engine light on, right after an oil change. Often, whoever changes the oil sometimes checks the air filter, and, when they open the filter box, they knock off a vacuum hose going to the air filter box. This could be your problem.

Go out to the vehicle, pop the hood, and check the black box that holds the air filter, on the passenger side front of the engine compartment; look to see if a black rubber hose is not connected. If it is off, reconnect it and drive the vehicle 10 miles, shut it off, and drive another 10 miles. This may extinguish the light.

I hope that this info helps you out. Thanks for choosing FixYa for assistance.

May 19, 2010 | 2003 Toyota Highlander

1 Answer

How do I reset the oil maintainance warning light after I change the oil on my Lexus GS


Feb 17, 2010 | 2006 Lexus Gs 300

1 Answer

What is the orange cog light on my discovery

If it is top left of the control panel and has a little thermometer in the middle of it, then its the transmission oil temperature light.

"In some markets, this bulb will temporarily illuminate to indicate the bulb is working when the ignition key is moved to position 2".

Generally, if its on for less than a couple of seconds - all is fine. If it stays on whilst driving then your transmission oil is too hot (hot weather, handbrake left on, punishing the engine etc ....).

If it comes on, check the oil temperature guage, and slow down. If it remains on, stop the vehicle and do not continue until it has extinguished.

Always try to get to the root cause of this fault, as it may be something more serious, such as loss of coolant (leading to engine seizure). Never check the coolant level on a hot engine - serious risk of burns injury.

Jan 08, 2010 | 1994 Land Rover Discovery

1 Answer

Engine Management Light stays on

Knock sensor found to be above the oil filter at the back of the engine slightly above and to the right of the oil pressure switch

Mar 19, 2009 | 2004 Kia Rio

2 Answers

Check engine soon

You might Try Installing new Plug Wires Since the Plugs worked this would be the Next Option. Please Rate My Response! Thanks!

Feb 07, 2009 | 2001 Ford Expedition

Not finding what you are looking for?
1999 Chevrolet Silverado 1500 Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides