Question about Chrysler Voyager
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Rear Windshield Wiper Problems
Check the wiper motor connection if its touching anything and loose it will automatically ground out and check at connection make sure you put some gel and then snap it in/ Please rate my response thank you very much
Posted on Jan 31, 2009
http://www.mvreader.com/multiview/dayco/catalogSearch.php?autoCatalogSearch=1&make=CHRYSLER&model=TOWN%20%26% The Town and Country has the Exact same Motor, Here is the Link to the 3.3 Liter Belt Diagram. It is the First at the Top, Just read the Header. Please Rate My Response! Thanks!4ZYEV3
Posted on Feb 06, 2009
smonahan, The rear wiper fuse is actually a circuit breaker. It will reset itself.
Your wiper arm has probably stripped were it attaches to the motor shaft. You can check by trying to move the wiper arm with your hand, if it moves back and forth, its stripped. A new wiper arm will be needed.
Try it and let me know.
Posted on Feb 12, 2009
What has most likely happened is that the Heater-a/c unit needs to be recalibrated and here are the steps to do so.
With the engine running and fully warmed up, A/C has to be turned off for at least 5 minutes [don't turn it on at all] and transmission in Park do the following
1. Set the temp control all the way to cold
2. Set the mode selector to Vent so air blows out of the dash panel outlets.
3. Hold down the rear washer button and the rear wiper buttons simultaineously for about 5 seconds until most all of the heater and ac panel lights blink and then release both buttons
6. At this point the system should go into a self calibration test which can take up to 60 seconds. While it is calibrating various control panel switch lights will blink as it goes through it's tests.
7. When the system is done calibrating then just the rear wiper light should be flashing and you can exit the test by turning off the vehicle. Wait about 10 seconds and restart the engine and it should be fine. If both the rear wiper and intermittent light are both still flashing after the calibration then there is most likely a problem with the system that will need more diagnosing. I see this fairly often with battery replacements so I think you'll be ok. It sometimes takes a couple of tries to calibrate so don't give up if it doesn't work the first time. Good luck, hope this helps!
Posted on Jul 14, 2010
Tips for a great answer:
May 23, 2012 | 2000 Chrysler Grand Voyager
Dec 27, 2010 | 2003 Chrysler Voyager
Feb 10, 2010 | 1999 Plymouth Grand Voyager
Jan 20, 2010 | Chrysler Voyager Cars & Trucks
Nov 19, 2009 | 2000 Chrysler Grand Voyager
Sep 28, 2009 | 1999 Dodge Grand Caravan
Jul 09, 2009 | 2000 Chrysler Grand Voyager
Nov 22, 2017 | Chrysler Cars & Trucks
364 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: