Question about 2001 Ford Focus

1 Answer

How to replace ignition coil on ford focus wagon se

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Contributor
  • 46 Answers

P, li { white-space: pre-wrap; }
Things You'll Need:

Adjustable wrench
Philips screwdriver
Paper clip
Ignition switch
Follow this simple steps

Open the hood and disconnect the cable from the negative terminal on the battery by loosening it with an adjustable wrench in a counterclockwise direction. Lift the cable off of the terminal and push it aside. Remove the plastic trim covers on the steering column from inside the passenger compartment by turning out the holding screws on the underside of the column with a Philips screwdriver in a counterclockwise direction. Set the trim covers and screws aside. Insert the key into the ignition switch and turn it to the ON position.
Straighten out a paper clip and insert one end of it into the hole on the side of the ignition cylinder facing the driver. Pull the ignition cylinder out towards the left hand side of the car once the paper clip releases the pin that holds the cylinder in place. Remove the key from the old cylinder and place it into the new ignition switch. Push the switch assembly into the cavity that the old switch was removed from until it locks into place. Turn the key to the OFF position and remove it if desired.

Replace the plastic trim covers and tighten the holding screws in a clockwise direction with a Philips screwdriver.
Place the battery cable back onto the negative battery terminal and tighten it with an adjustable wrench in a clockwise direction. Close the hood.

Posted on Aug 31, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 ford focus wagon se dies after high idle... Change coil pack.plugs. wires...still misfired and dies as soon as I let go of gas....what could this be?


Timing, engine control module, throttle position sensor, air flow meter. Run a diagnostic test to see what codes it shows so you can determine the exact cause.

Aug 07, 2016 | Ford Cars & Trucks

3 Answers

Trouble code P0352


Sorry, this one could be too many things. I would only be guessing. All of the problems like these that have happened to me has to do with fuel pressure from the pump. Trust this one to a mechanic with the right test equipment or you will be spending a lot of money replacing parts that may or may not be the problem.

Jun 12, 2014 | 2001 Ford Focus

1 Answer

02 focus 1.6 zetec se has devolped a missfire/shudder at 2 or 3 positions on accelleration in all gears but is fine once speed is steady


Hi.

You should do a diagnostic with a scan tool first.

Probably an ignition coil problem. Replace it and replace also the spark plugs.

May 17, 2011 | Ford Focus Cars & Trucks

1 Answer

How do I change the coil pack in my 2005 ford taurus


Welcome to Fixya.

Here's the procedure how to replace the ignition coil pack of your car.


•1
Understand basic safety procedures. Any time you work on your Ford Focus, you should set the emergency brake and disconnect the negative, or ground, cable from the battery. Some mechanics recommend you isolate the cable to prevent accidental contact, which could spark a connection.
•2
Release the spark plug wires from the Ford Focus ignition coil pack. You may need to pinch or press a release to unlock the wires.
•3
Use a socket set or a small wrench to unbolt the ignition coil connectors. You also need to undo the capacitor electrical connectors. As you work, make note of which connectors go where--this pays off you when you reassemble the parts.
•4
Locate the bracket that holds the ignition coil pack and the electrical capacitor in place. Undo the fasteners that secure them.
•5
Separate the Ford Focus ignition coil pack from the mounting system. Replace the old Focus ignition coil pack with a new one. Verify the new ignition coil pack works with your engine, even if you use a universal ignition coil pack.
•6
Reassemble the parts. If you have a Torque wrench, use it to tighten the ignition coil bolts with 7 inch pounds of torque (10 Nm).

Thank you for using Fixya!

Nov 19, 2010 | 2005 Ford Taurus

3 Answers

My 2000 Ford Focus SE is throwing a P0302 code for misfire in cylinder 2. We replaced the spark plugs and wires, cleaned the fuel injectors, and checked all fluids. It still misfires and my gas mileage is...


Ignition coil is most likely..clogged injector is uncommon but possible..fuel injector cleaner can only do so much..coil would be the thing to start with..

Sep 03, 2010 | 2000 Ford Focus

1 Answer

I have a 2000 ford focus se. It is vibrating bad enough that my cd player won't even play. even while it is in park. What causes this?


it sounds like your car has a misfire the focus range suffer badly with ignition coil failures and engine control module failures you need to get this checked out as well as all your engine and gearbox mounts checked

Apr 19, 2010 | 2008 Ford Focus SE Sedan

1 Answer

Ford Focus 2000 Wagon SE Rear Whiper


Try the right hand stalk. It should move backwards and forwards to switch on and off the rear wiper.

Nov 15, 2008 | 2000 Ford Focus

Not finding what you are looking for?
2001 Ford Focus Logo

253 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...