Question about 1994 Chevrolet Corvette

1 Answer

94 corvette sticky starter - 1994 Chevrolet Corvette

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 68 Answers

You havent said if the started sticks and wont enguage or it enguages and sticks enguaged once started. In either case it sounds like your starter is going to need to be replaced but check two things... make sure your battery voltage is good and check the teeth on the flywheel to nake sure they are in good condition. You nay also have to shim the starter in sme cases to achive the correct clearance. Good luck!

Posted on Aug 27, 2010

Testimonial: "that helped out.i'll try your suggested.thank you"

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1985 corvette I changed out the starter for new. Now it's not starting. The starter will run when I bipass the celinoid what am I missing?


Could be the starter relay.Did you put the shims back in with starter?1985 Chevrolet Corvette 5.7L FI OHV 8cyl.The Starter Relay is located: Front seating area, passenger side, under dash, mounted behind kick panel
Application:
Starter (interrupt)Here's what the relay look's like Sonja.
s-l1600-ygacrkiipohhmauesavjx3lv-5-0.jpg

Aug 08, 2017 | Cars & Trucks

1 Answer

What caught 94 corvette engine to lock up, oil was in the engine


Just because oil is in the engine doesn't mean that the oil was getting circulated through the engine. If there was an issue with the oil pump or if the engine was sludged up and had critical oil passages blocked, engine failure would be the end result.

Jan 18, 2015 | Cars & Trucks

1 Answer

Corvette Problems


Unless it is broken or loose I would say not. From your description of the fault I would say that a through inspection of the front suspension is in order followed up by a good wheel alignment.

Nov 17, 2013 | Cars & Trucks

1 Answer

Can't get the starter out pass the cat on my 1987 corvette as shown in repair manual


My manual (Chilton) says to remove the front starter support bracket and heat shield, loosen the starter bolts and lower the front end of the starter first. It comes out the front not the traditional back way. Hope this helps.

Mar 07, 2012 | 1987 Chevrolet Corvette

1 Answer

94 Corvette, why would the air conditioner engage when inside temp is set at 90 (heat should be on)


It's called mixing. It minimizes condensation and helps control humidity. It also keeps a cold windshield from heat shock and vice verse, preventing cracking. when in defrost cycle.

Sep 24, 2009 | 1994 Chevrolet Corvette

2 Answers

Clicking from motor at start up. Goes away after a few minutes


I would bet money on sticky lifters .,why not put an oil flush through the motor ad with new oil and filter see if it goes away that is what i would do -----"yuodoit"

Sep 11, 2009 | 2005 Chevrolet Corvette

1 Answer

87 corvette no start, power is good, all lights work


you can try bypassing it like this turn the key on then take a screwdriver and touch the 2 bolts on the starter try that or try changing the fender mounted starter selonoid

Apr 09, 2009 | 1987 Chevrolet Corvette

2 Answers

1992 Corvette cranks over but will not start.


Your Starter Brushes are worn down to far to Kick her Over. Replace that Starter and you Should be Good. Let me Know!

Jan 16, 2009 | 1992 Chevrolet Corvette

1 Answer

1994 Corvette


sounds like a sticky idle air control valve

Sep 11, 2008 | 1994 Chevrolet Corvette

Not finding what you are looking for?
1994 Chevrolet Corvette Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...