Question about 1995 Mercedes-Benz SL-Class

1 Answer

I need to know where is the diagnostic computer plog

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mercedes-Benz Master
  • 14,036 Answers

LOOK ON RIGHT REAR CORNER OF ENGINE COMPARTMENT.

Posted on Aug 27, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Were is the relay that control the oxigen sensors


These relays tend to be in a fuse/relay panel under the hood on the firewall or inner fender wall. Auto Zone should have the Chiltons/Haynes repair manual for your auto that covers the make/model and year. It's a good book to have at any rate. It will tell you where the fuse relay panels are and what they contain.

Oct 13, 2014 | Cars & Trucks

1 Answer

The celular plog not working


Replace the fuse for the plug .

May 26, 2014 | 2000 Dodge Durango

1 Answer

Coil is fireing plogs will not fire can you help me


Sound like a cracked distributor cap. Happened to me a couple years ago in my 4.3L Jimmy. Replace the cap and button.

May 23, 2014 | 1993 Chevrolet Astro

1 Answer

I need to reset my diagnostic link connector for my 1995 Oldsmobile Aurora. But whenever I plug my tools into it the tool says that its not connected to the computer so I'm thinking there is a short or...


No clue, either, so to start I would check the validity of the wiring from the computer to the diagnostic connector. Find a wiring diagram and get out the old trusty ohmmeter. You know where the computer and the diagnostic connector are.
Take off the negative battery cable. Pull the PCM connector off. From the wiring diagram you know what pins on the PCM connector go to the diagnostic connector. Now, one ohmmeter lead on the diag. conn. and the other meter lead on the PCM connector-turn the meter to ohms and see if very little resistance is in that wire. Resistance to current flow means very high ohms. A short is a break in the wire, and the ohmmeter will show infinite resistance. A wire still connected by two little strands with the others broken, will show very high resistance, just not infinite.
Check all the wires going to the diagnostic connector in the same way. If all wires are good, check the computer is getting fully powered. Is check engine light on with key on? Is your diagnostic tool working okay on other cars?

Sep 11, 2013 | 1995 Oldsmobile Aurora

1 Answer

Replaced the distributor on my 2002 chevy s10 4.3L and now it will not start.


Timings off, or bad ignition module in new distributor. Disconnect coil wire. Remove number on sparkplug, front left sitting in drivers seat.Have someone bump motor over while holding finger in spark plog hole. Crank slow till you hear/frrl a hard compression push. Check rotor in relation to number one plug on distributor cap. Probably off a couple teeth. Doesn't take much. If not that, replace module in distributor. Go new, not junkyard unless you know the boneyard motor was good that you took it out of.

Jan 16, 2013 | Chevrolet Cars & Trucks

2 Answers

The sevice engine light stay on.


Hello and welcome to FixYa!

I strongly suggest that you have the engine scanned. During the diagnostic, it will list all the trouble codes and by then you'll know what part needs replacement. This is wiser than guessing what's the fix.

Hope this helps and thank you for using FixYa! Have a good one!

Apr 15, 2011 | 1998 Buick Century

1 Answer

Vw golf vr6 1994 firing order it is off pots i need a diagram i dont no what way the plog leads go


1-5-3-6-2-4
See image below.
The angle end of the plug lead goes on the coil pack.
Coil pack is as viewed from the lead connector side.
0b90d44.jpg

Aug 23, 2010 | 1994 Volkswagen Golf

1 Answer

1993 buick lesabra limit 3800 engine got a leak beside the engine anti-freeze coolant


what you neeed to do is replce the freeze plogs on mono block and heads.

Nov 15, 2009 | 1993 Buick LeSabre

1 Answer

I have a Ford Escort 92, and wen the engine is on


look for vacuum leaks , also look inside throttle body for carbon buildup , clean as needed

Feb 19, 2009 | 1993 Toyota Previa

Not finding what you are looking for?
1995 Mercedes-Benz SL-Class Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76109 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...