Question about 2000 Toyota Corolla

1 Answer

2000 toyota corolla...the car was in a crash,damage to driver side front.I have replaced parts(fender,bumper ,etc)but now the park light or signal light will not work.when I turn the turn signal on for the left side it flashes real fast inside and rear...nothing in the front.The right side works just fine.I tested light socket and no power is getting to it

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

You need to check the fuse for it. with no power going to it that is the most likely explanation. other than that, trace the wire from the light and be sure there is no breaks

Posted on Aug 26, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1994 Toyota corolla 1.8, how do I get my passenger front turn signals to work? What wires have to be connected together for my turn signal and side corner marker to work?

does your car have the signal light flasher if so find it and replace it also check the fuses maybe both sides are fused separate

May 05, 2017 | 1994 Toyota Corolla

1 Answer

I just crashed my toyota 1988, it was damage the front driver side. Fender, and bumper maybe the hood. It didn't damage any motor related things. How much could I end up paying to repair this car?

Sorry to hear that. the problem with repairing the car is the avalability of the body panels plus when you do get them they need painting, your best bet would be to try a local parts yard and get the panels used and hopefully not to rusty.

Mar 01, 2011 | 1988 Toyota Corolla 4 Door

1 Answer

I ran my 2006 toyota corolla into the garage door! It was at a very low speed so thankfully it only did a little damage. I need to take the right side of the front bumper off and so a few minor repairs,...

I dont own a toyota so i couldnt tell you for sure..but i do know one thing for sure is that you must be careful that you disable the air bag sensors which are usually near the front bumper on most cars before you work on the bumper so that you dont set them off by accident.

Apr 07, 2010 | 1993 Toyota Corolla

1 Answer

How do i replace the front side light bulbs on a 1991 mr2

Is this the left or right turn signals / markers on the fender? is will see the bumper lights are in 2 parts. Put a flat head screw driver in the slot and pry the smaller piece/ They snap 2gether on one end....and slide in on the other. Once thats out you can see the Phillips screws holding in the whole light assembly as well as the side makers. There is also one screw in the molding portion of the light in the wheel well. Ive had 5 MR2's and they are a real fun problem. hope this helps!

Jan 09, 2010 | 1991 Toyota MR2

1 Answer

1996 corolla wagon driver side front axle is loose at the inner end. can I drive it til replace this weekend? Boots not torn, no clicking. About quarter inch play in wheel. Some buzz/whine sound randomly...

Chances are that if an impact did enough damage to loosen an axle then there is probably some other damage as well. Have you tried pushing the axle back into the transmission? If it comes out it's going to do some real damage to the car. The transmission will run out of oil and burn up your differential inside, then the shaft, which will still be connected to your wheel will beat and bash everything under the car until the cv joints tear apart. I wouldn't recommend it, it's not worth the risk.

Nov 10, 2009 | 1996 Toyota Corolla

2 Answers

My Toyota Corolla rear bumper has at big dent on

you have to take the whole bumper off and the bolt the u see holding it on the re-bar and bumper cover should come off

Jul 01, 2009 | 2000 Toyota Corolla

1 Answer

Where is the fuse box on a 2000 toyota corolla

Check up high on the left front kick panel - you will have to get your head right up there.
Also in the engine compartment on the driver side mounted to left inner fender

May 08, 2009 | 1991 Toyota Corolla

1 Answer

Hazard lights and turn signal dont work

check your mechanics re-wire job lol

Apr 15, 2009 | Toyota Camry Cars & Trucks

1 Answer

Replace door hinges :toyota levin

There is no need to remove the bumper or the fender. Just remove the door to reach the screws for the hinges mounted to the body- fender side.

Nov 15, 2008 | 1998 Toyota Corolla

Not finding what you are looking for?
2000 Toyota Corolla Logo

Related Topics:

165 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides