Question about 2005 Pontiac Grand Prix

Open Question

Changing a water pump in a 2006 Grand Prix - 2005 Pontiac Grand Prix

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

canbruce75
  • 1776 Answers

SOURCE: how do you replace a waterpump on a 2006 Pontiac

Check the autozone.com website and register your car. It's free and will give you access to an online repair manual for the car. The info that you need can be found there. Hope this helped and best wishes.

Posted on Aug 09, 2009

CMV9
  • 594 Answers

SOURCE: replace water pump 93 grand prix

here is a step by step instruction on how to replace your water pump. please do not forget to rate and comment about your experience today with fixya.

  1. Disconnect the negative battery cable.
  2. Remove the air cleaner assembly.
  3. If necessary for access, remove the coolant recovery reservoir.
  4. Partially drain the coolant, into a suitable container, to a level below the water pump.
  5. If equipped, remove the serpentine belt guard/cover.
  6. Remove the serpentine belt.
  7. Remove the retaining bolts, then remove the water pump pulley.
  8. Unfasten the 5 water pump attaching bolts, then remove the water pump and gasket. Discard the gasket.
To install:
  1. Thoroughly clean the water pump mounting surfaces.
  2. Position a new gasket, then install the water pump.
  3. Install the attaching bolts and tighten them to 89 inch lbs. (10 Nm).
  4. Install the water pump pulley.
  5. Install the serpentine belt and belt cover/guard (if equipped).
  6. Refill the cooling system with the specified type and amount amount of engine coolant.
  7. Install the air cleaner assembly.
  8. Connect the negative battery cable, then start the engine and check for coolant leaks.

Posted on Apr 17, 2009

beduncan
  • 73 Answers

SOURCE: 2004 Pontiac Grand Prix OVERHEATING!!!

Have you shop perform a "leakdown test." You probably have a bad head gasket )or a leak in the gasket).

Posted on Aug 06, 2009

  • 40 Answers

SOURCE: how do I change brake pads on a 2006 Pontiac Grand

Yes, You can buy a manual at your lacal parts store.
However, It's not that hard. But , you didn't say if you
need to change the front or rear pads?
I'll assume your refering to the front.
1st You'll need to jack up the car if you only have one
Jack then, pick the side you are too start say left front.
Jack the car up like chainging a tire BUT, Jack the car
up but, leave the tire touching the ground with, some weight
still on the tire with a lug rench turn the lug nuts JUST enought
to loosin the nut DO NOT take the nut off, maybe 1/4 " only.
Do the same on the others. Now, Jack up the car until the tire
is off the ground. NOW, Put a Jack Stand under the car never
NOT use a stand. Remove the nuts and tire.
Turn the wheel to the right it will give you more room to work.
You'll need to remove the caliper that holds the pads on.
There are two screws that hold the caliper on. I believe,
there 13mm remove the screws (Take them all the way OUT)
Remove, The caliper the pads, will stay in the holder.
Remove, the pads you may need a screw driver to get the
pads out.There are two pads that have a scencer on them
one for each side PUT that pad on the inside holder.( sencer down)
NOW rember you need, too make room for te new pads.
You need a c- clamp to push the piston BACK into the
bottom of the caliper. Be sure the piston is at the bottom of the caliper
or the caliper will NOT fit back on. Install the new pads into the holder.
.Then, put the caliper back on to it's mount over the new pads.
Put the two caliper bolts back and, your done.
Reverse, the infromation from the top.

Posted on Jan 02, 2010

Testimonial: "Thank u"

BCAS1298
  • 3092 Answers

SOURCE: 1998 Grand Prix GTP windshield washer (full) not pumping fluid

Yes it's easy to do, remove tank pull pump off of tank, and replace pump, Napa has this pump # 6651533 it runs between $14.00 and $20.00 .

Posted on Jan 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2006 pontiac grand prix and it is leaking coolant and we can not find where it is leaking from. We replaced the water pump gasket and it still leaks. It looks like it is leaking from something...


have a pressure test done so that you can see where it is leaking from.. If it is in the side of the block it may be a rusted welsh plug. Check inside the car for a leaking heater core and hoses . Check the drain hole under the water pump as it may be leaking from that hole while the pump is running ( water pump seal)

Feb 22, 2014 | 2006 Pontiac Grand Prix

1 Answer

03 grand am v-6 3.4 liter lossing coolant &overheating


Just went thru that. I changed the following ...upper and lower intake gaskets and the upper intake . Spent about $400

Dec 13, 2013 | 2006 Pontiac Grand Prix

1 Answer

2006 grand prix is leaking coolant out of the water pump we put a new one on and its still leaking any advice on whats wrong?


Since you replaced a perfectly good water pump most likely do this, have the system pressure tested by a shop and confirm where exactly the leak is.

Aug 28, 2012 | 2006 Pontiac Grand Prix

2 Answers

I have a 2006 pontiac grand prix 3.8l my heat only blow cold aair I checked the thermostat and the heart inlet hose is hot but the outlet hose is luke war what could this be maybe clogged heater core.


Ok fellow 2006 Grand Prix owners!! By trial and error, I went through the process of elimination because my car would over heat and had no heat inside. After changing the thermostat, I had to replace the water pump. However, after you do this, you need to open the inlet hose bleeder and let the air out a few times. This solved my issue of overheating and I now have great heat!!!

Oct 23, 2011 | 2006 Pontiac Grand Prix

1 Answer

Trying to change my water pump for a 2006 pontiac grand prix gxp but can not find where my tension pulley is located


I normally don't pass the buck, but go to e-how.com and depending on whether your

car is supercharged or not they tell you step by step how to remove your belts ,and

where the tensioner is located. there isn't enough space on this page to give you directions.

good luck!

Jul 14, 2011 | 2006 Pontiac Grand Prix

2 Answers

Water pump pulley


The water pump needs replaced.

May 08, 2010 | 2006 Pontiac Grand Prix

1 Answer

Water pump replacement for 2006 grand prix gt supercharged v6


first take the 4 bolts that hold the water pump pulley out, do this while the belt still on, it's easier because the pulley won't turn on you.
remove the pulley then take the 8 bolts around the water pump then pry the pump out.

Feb 26, 2010 | 2006 Pontiac Grand Prix

1 Answer

Changing a 2006 grand prix water pump


the spindle will move rite? there should be holes in that to access that bolt good luck

Jul 18, 2009 | 2004 Pontiac Grand Prix

Not finding what you are looking for?
2005 Pontiac Grand Prix Logo

Related Topics:

242 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...