Question about 2001 Ford Focus

1 Answer

How to fit a alternator belt on a ford focus 16.00 can you send me a pick

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Contributor
  • 46 Answers

P, li { white-space: pre-wrap; }


Simply follow the steps


Disconnect the battery's negative cable and set it aside where it can't accidentally snap back onto the terminal.


Remove the car's accessory drive belt. Disconnect the belt shield by removing its two 10-mm bolts, push up on the tensioner by hand, pull the belt off the air conditioner or water pump pulley and remove the rest of the belt. Take note of how the belt loops around each pulley.

Open the cover containing the alternator's electrical connectors and disconnect them. Remove the bolt on the coolant expansion tank then detach the tank from its clip and secure it away. Detach the power steering reservoir, engine wiring loom bracket, ground cable and evaporative emission canister purge valve.


Unscrew and remove the alternator's first bolt on its right side. Unscrew the second bolt on the left and disengage it fully from the bracket; it cannot be removed from the alternator. Remove the alternator from the engine.


Install the new alternator, placing the built-in bolt within the bracket and tightening it first. Insert and tighten the second bolt.


Replace all other objects set aside in the reverse order they were detached. (evaporative emission canister purge valve, ground cable, engine wiring loom bracket, power steering reservoir and coolant expansion tank). Plug in the electrical connectors and replace the cover over them.


Replace the accessory drive belt. Loop it over all the pulleys except the one on the air conditioner. Retract the tensioner upwards as you did before to fit the belt on the A/C pulley.


Reconnect the battery cable.




Posted on Sep 22, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Trying to find thermostat on a ford focus 1.4 zetec se 2003 but cant find it not where manual says


the thermostat is situated below and to the right of the alternator in the thermostat housing. if you romove the alternator you can then see the thermostat housing..hope this helps.

Apr 03, 2011 | 2000 Ford Focus

1 Answer

My ford focus zetec makes a rattleing noise


spraying WD40 on drive belts is not a good option as it can cause slippage it is better to use silicon spray or ordinary soap,rub the soap on the belt when the engine is stopped,as for the squeak it could well be the tensioner replace it first it may be the cheapest to start with.....hope this helps....cheers

Jul 26, 2010 | 2001 Ford Focus

1 Answer

How do u fiT a fan belt on a 55 plate ford focus


Loosen the adjustment bolt on the alternator, remove old belt, fit new one and stretch it slightly with the adjustment of the alternator until you have 2mm of deflection. Tighten up the bolt and take her for a run to charge the battery properly.

Jun 22, 2010 | 2005 Ford Focus

1 Answer

Is the alternator on a ford focus 1.6 the same as


find what power output each alternater gives the battery.and if the fitting are the same also
if these match between each unit then yes you can use it.
just the plug, size,bolt holes, and power output an belt pulley have to be the same.
if they are yes
Hope i help
bakerboy11@hotmail.com
Automobile

May 17, 2010 | Ford Focus Cars & Trucks

1 Answer

How to fit a belt on alternator on a ford focus 1.6 16v t reg car


go to a car service center isnt so expensive.if something goes wrong even damages to altenator or water pump or worst to the ac compressor or power steering pump can happen!

Apr 12, 2010 | 2000 Ford Focus

2 Answers

Engine warning light , battery light, warning light , rev counter , speedo and temp gauge going on/off intermitantly and speedo not working on digital screen on ford focus can you help. the battery is new...


My 04 Ford Focus the battery light keeps coming on & going off, have fitted a new alternator belt but it didn't solve the problem. The battery connections are good. Also the rev counter, speedo & mileage clock keep going haywire when the battery light is on. Do you think it is the alternator? Or is it some other common problem?

Jan 21, 2010 | 2003 Ford Focus

1 Answer

How to fit a fan belt in a 2000 ford cougar


disconnect the positive terminal lead to the battery and loosen the3 bolts to the alternator remove old one and reinstall new one ...using a grow bar or prybar rest it behind the alternator upper bracket and give some tension to it causing the belt to tighten then secure bolts and reattach the + positive lead terminal ..

Sep 13, 2009 | 2000 Ford Focus

3 Answers

Can't find where to loosen tension on Ford 2006 ZX5 Focus


Buy a Haynes or Chilton's repair manual at your friendly auto parts store.

Jul 14, 2009 | 2006 Ford Focus

1 Answer

What's the best way to replace the alternator on a 2001 Ford Focus (Z Tech)


hi there rowdyrottie best way to do alternator on these is to remove drivers headlamp by removing torx screws once thats out of way make a note on how alt belt goes on,once you have done that remove both 13 or 15mm nuts on top partt of alternator next unbolt 15mm bolt at bottom of alternator once removed disconnect wires from alternator you should be able to remove alternator from bracket if you can't you'll have to remove long bolt going into a bracket with torx socket or a good pair of vice grips once bolt is removed alternator will come out this should be done in just a matter of fitting new alternator & build back up.

Dec 27, 2008 | 2001 Ford Focus

2 Answers

Ford focus 2000 alternator and belt removal and fit


Just took one out last night. It also was stuck. Had to use small pry bar to get off the front mount. Sprayed the mount with PB blast to help. You do have to use some force, becareful not to break any electrical connections. Once the front mount was free, I had to pry up on it using a small hatchet. Only thing that would fit and actually be able to pry. The alternator became twisted from prying only on one side, so I used a block of wood and tapped it back straight. It finally released from the mounts and came loose. Then the fun begins in trying to actually get it out. Had to disconnect everything around it, took two people and alot of twisting and turning. Not looking forward to getting it back in. Removal took over 2 hours.

Jun 29, 2008 | 2000 Ford Focus

Not finding what you are looking for?
2001 Ford Focus Logo

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...