Question about 2002 Dodge Dakota Club Cab

1 Answer

Need sequence to blrrd brakes 02 dakota - 2002 Dodge Dakota Club Cab

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 17,970 Answers

Dakota, 2001-2005

Bleeding the Brake System
Brake fluid tends to darken over time. This does not necessarily indicate contamination. Examine fluid closely for foreign matter.
The primary and secondary hydraulic brake systems are separate and are bled independently. During the bleeding operation, do not allow the reservoir to run dry. Keep the master cylinder reservoir filled with brake fluid. Never use brake fluid that has been drained from the hydraulic system, no matter how clean it seems.

  1. Clean all dirt from around the master cylinder fill cap, remove the cap and fill the master cylinder with brake fluid until the level is within 1 / 4 in. (6mm) of the top edge of the reservoir.
  2. Clean the bleeder screws at all 4 wheels. The bleeder screws are located on the back of the brake backing plate (drum brakes) and on the top of the brake calipers (disc brakes).
  3. Bleeder screws should be protected with rubber caps. If they are missing, the orifice may easily become clogged with road dirt. If the screw refuses to bleed when loosened, remove it and blow clear. Aftermarket caps are readily available.

Bleeding the ABS System
This is accomplished using the same methods as for the base brake system. Refer to those procedures.
ABS system bleeding requires conventional bleeding methods plus use of the DRB scan tool. The procedure involves performing a base brake bleeding, followed by use of the scan tool to cycle and bleed the HCU pump and solenoids. A second base brake bleeding procedure is then required to remove any air remaining in the system.
  1. Perform base brake bleeding. Refer to the appropriate section.
  2. Connect the scan tool to the data link connector beneath the dashboard.
  3. Select "Antilock Brakes" followed by "Miscellaneous", then "Bleed Brakes". Follow the instructions displayed until the unit displays "Test Complete", then disconnect the scan tool and proceed.
  4. Perform a base brake bleeding a second time.
  5. Top up the master cylinder.

Hope helps (remember rated and comment this).

Posted on Aug 26, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

02 dakota 4x4 shifter sticks in park what is the cure?


Many cars have a shift lock such that you have to depress the brake pedal so a solenoid in the shifter system allows you to get out of park. Either the Brake pedal is not being detected or the solenoid or solenoid wiring is bad.

Feb 19, 2015 | Cars & Trucks

1 Answer

What cause brake pedal to hold low


posible need blrrd system and adjust rear brakes

Sep 26, 2014 | 1995 Nissan Pathfinder

1 Answer

Brake drum


For drum brake related problem,i suggest you to go through this help links.Clickj the link below for troubleshooting procedure:-----How to service Drum brakes? http://repairhelpcenter.blogspot.in/2012/02/how-to-service-drum-brakes.html-------- What type of problems usually noticed on Drum brakes? http://repairhelpcenter.blogspot.in/2012/02/what-type-of-problems-usually-noticed.html--------- How to test Drum Brakes? http://repairhelpcenter.blogspot.in/2012/02/how-to-test-drum-brakes.html
---------How to inspect brake drums? http://repairhelpcenter.blogspot.in/2012/02/how-to-inspect-brake-drums.html
---------This will help.Thanks.

Feb 11, 2012 | 1991 Honda Accord

1 Answer

Need diagram for drum brakes on 1991 dodge dakota 6cl 2wd


Try this video:

http://revver.com/video/186925/dodge-dakota-rear-brake-replacement-video-part-1/

Jul 03, 2010 | 1991 Dodge Dakota

1 Answer

02 dakota 3.9 belt diagram


Below is the diagram for your truck w/o AC.
c806e7c.jpg

Oct 06, 2009 | 2002 Dodge Dakota Club Cab

1 Answer

Need help with the wiring diagram for my 92 Dakota, has not brake lights or blinkers


www.wiring-diagram.com
You can get any wiring diagram for any vehicle. It will cost about $12 and it's well worth it. It will give you the complete diagram bumper to bumper.

Apr 29, 2009 | 1998 Dodge Dakota

1 Answer

Where is the brake light switch on a 95 dakota


The brake light switch is behind the brake pedal

Apr 03, 2009 | 1995 Dodge Dakota

1 Answer

1993 dodge dakota 5.0 torque specs. for heads


105 Foot pounds (Final torque)

Torque sequence ------------ front | 7 3 1 5 9 | of | 8 4 2 6 10 | engine ------------ Final torque must be reached in 3 equal steps Recheck final torque in sequence

Mar 27, 2009 | 1993 Dodge Dakota

1 Answer

My car will not go into gear , could it be the clock spring I have an '02 Dakota SE and it will not go into gear. This happenend once before and the guys at the repair shop had me try to get it into...


This an interlock system to preventing car from being in any gear but park to start, it work off a switch on your brake pedal, it should unlock when the brake is depressed. If not a bad fuse, a bad switch, or a bad solenoid on shiftlock.

Dec 22, 2008 | 2002 Dodge Dakota Club Cab

1 Answer

2002 Dodge Dakota, no brake lights. Where is the fuse or breaker???


Your prob could be the switch at the brake peddle. If not go to the wiring at the trailer hitch. Frankster016

Sep 19, 2008 | 2002 Dodge Dakota Club Cab

Not finding what you are looking for?
2002 Dodge Dakota Club Cab Logo

Related Topics:

334 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...